Duke 2505249 Bedienungsanleitung

Inhaltsverzeichnis

Andere Duke Gewerbliche Lebensmittelgeräte Handbücher

Duke

Duke WW-1 Bedienungsanleitung

Duke

Duke DK-FRY-27-S Bedienungsanleitung

Duke

Duke FHUAS-2 Bedienungsanleitung

Duke

Duke FHUAS Referenzhandbuch

Duke

Duke TSCM Bedienungsanleitung

Duke

Duke TSC Bedienungsanleitung

Duke

Duke FWM3-22 Betriebsanleitung

Duke

Duke TSCM Bedienungsanleitung

Duke

Duke FLM200 Bedienungsanleitung

Duke

Duke FORM BWLAM END BREAD FS Bedienungsanleitung

Duke

Duke IRHU Series Bedienungsanleitung

Duke

Duke FCP1-SB Bedienungsanleitung

Duke

Duke FHUAS-2 Bedienungsanleitung

Duke

Duke ReadyFlex RFHU-35M Bedienungsanleitung

Duke

Duke RFHU-22 Bedienungsanleitung

Duke

Duke TSC Bedienungsanleitung

Duke

Duke FWM3-13 Bedienungsanleitung

Duke

Duke FWM3-51 100 Betriebsanleitung

Duke

Duke INTERSECT Bedienungsanleitung

Duke

Duke ReadyFlex RFHU-23R Bedienungsanleitung

Duke

Duke Readyflex Bedienungsanleitung

Duke

Duke HCSS-48-3 Bedienungsanleitung

Duke

Duke DK-FRY-27-S-DQ Bedienungsanleitung

Duke

Duke HCSS-LH Bedienungsanleitung

Beliebte Gewerbliche Lebensmittelgeräte Handbücher anderer Marken

Blue Seal

Blue Seal EF30 Bedienungsanleitung

Tecfrigo

Tecfrigo Snelle 400 GS Bedienungsanleitung

Follett

Follett PFT Series Bedienungsanleitung

MEFE

MEFE CAT 206 PTR Leitfaden

Premier

Premier 900cl Bedienungsanleitung

Diamond

Diamond AL1TB/H2-R2 Bedienungsanleitung

Salva

Salva IVERPAN FC-18 Bedienungsanleitung

Hussmann

Hussmann Rear Roll-in Dairy Bedienungsanleitung

Cornelius

Cornelius IDC PRO 255 Bedienungsanleitung

Moduline

Moduline HSH E Series Bedienungsanleitung

MINERVA OMEGA

MINERVA OMEGA DERBY 270 Bedienungsanleitung

Cambro

Cambro IBSD37 Bedienungsanleitung

Fri-Jado

Fri-Jado LDR 8 s Bedienungsanleitung

Diamond

Diamond OPTIMA 700 Kurzanleitung

Allure

Allure Melanger JR6t Bedienungsanleitung

saro

saro FKT 935 Bedienungsanleitung

MKN

MKN OPGGSGARG Series Bedienungsanleitung

BIRO

BIRO 22 Service-Handbuch

This manual is Copyright © 2021 Duke Manufacturing Co. All rights reserved.

Reproduction without written permission is prohibited. Duke is a registered

trademark of the Duke Manufacturing Co.

CAUTION: Please read these instructions completely before attempting

to install, operate or service this equipment.

WARNING for CA residents: go to www.dukemfg.com/prop65 for prop 65 warning

Instruction Sheet

POS Support Bracket Kit

2505249

P/N 229403

REV A 04/28/2021

PARTS IN KIT TOOLS NEEDED

Stubby Phillips Screw Driver

POS Support Bracket

2505248

2

Installation and Operation of: POS Bracket Installation

POS SUPPORT BRACKET INSTALLATION

1Start by disconnecting all electrical equipment located on top of the POS arm and set it aside in a

safe location.

Failure to disconnect power to equipment could cause equipment damage and or bodily injury.

2Remove the screws that are holding the POS arm in place, which are located underneath the

countertop. Do NOT discard these screws as they will be used in a later step.

Pull the POS arm out of the counter and pull all wires out of the bottom of the arm. Remove

and discard the rectangular cover plate that goes around the POS arm and rests on top of the

countertop.

3

3

Installation and Operation of: POS Bracket Installation

POS SUPPORT BRACKET INSTALLATION

Re-route all wires back through the POS arm that were removed in the earlier steps.

5

6

Remove the two screws at the bottom of the POS arm. Slide the retrot support bracket over the arm

until the two holes on the bracket line up with these two holes on the POS arms. Once the holes are

aligned, re-install the screws.

Do NOT fully tighten the screws as they will be tightened on a later step.

4

Slide the POS arm down into the hole of the countertop until the bracket rests ush against the top

of the countertop.

Note: This bracket is designed to t tight inside the hole of the countertop so the downward facing

anges of the bracket may need to be pressed inwards to allow them to clear the edge of the hole in

the countertop during installation.

Installation and Operation of: POS Bracket Installation

Duke Manufacturing Co.

2305 N. Broadway

St. Louis, MO 63102

Phone: 314-231-1130

Toll Free: 1-800-735-3853

Fax: 314-231-5074 www.dukemfg.com

POS SUPPORT BRACKET INSTALLATION

7

8 9

10

Align the holes of the POS arm and the mounting bracket located underneath the countertop. Once

aligned, re-install and tighten the screws that were removed from step two, making sure not to

cross-thread them.

Tighten the screws that were left loose in step

four.

Place all equipment back on top of POS arm

and re-connect all wires to their designated

equipment.

Installation complete.