Eaton Powerware 9355 Bedienungsanleitung
Powerware Series
Eaton 9355 Parallel UPS
10/15 kVA
User's Guide
®
Class A EMC Statements
FCC Part 15
NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
ICES-003
This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing
Equipment Regulations ICES‐003.
Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du
Canada.
IEC 62040-2
Some configurations are classified under IEC 62040-2 as “C2 UPS for Unrestricted Sales Distribution.”
Eaton, Powerware, ABM, Powerware Hot Sync, and X-Slot are registered trademarks of Eaton or its subsidiaries
and affiliates. Greenlee is a registered trademark of Greenlee Textron. National Electrical Code and NEC are
registered trademarks of National Fire Protection Association, Inc. All other trademarks are property of their
respective companies.
ECopyright 2005–2015 Eaton, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced
in any way without the express written approval of Eaton.
Special Symbols
The following are examples of symbols used on the UPS or accessories to alert you to important
information:
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk of electric
shock symbol.
CAUTION: REFER TO OPERATOR'S MANUAL - Refer to your operator's manual for
additional information, such as important operating and maintenance
instructions.
This symbol indicates that you should not discard the UPS or the UPS batteries
in the trash. This product contains sealed, lead‐acid batteries and must be
disposed of properly. For more information, contact your local recycling/reuse or
hazardous waste center.
This symbol indicates that you should not discard waste electrical or electronic
equipment (WEEE) in the trash. For proper disposal, contact your local
recycling/reuse or hazardous waste center.
ON - Indicates that the switch is in the ON position.
OFF - Indicates that the switch is in the OFF position.
PHASE - The word “phase.”
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality i
Table of Contents
1 Introduction 1.........................................................
2 Safety Warnings 3.....................................................
3 UPS Setup 7..........................................................
Inspecting the Equipment 7...............................................................
Floor Loading 8.......................................................................
Clearances 8.........................................................................
Unloading the Cabinet(s) 9...............................................................
Three-High Cabinets or Two-High EBMs 9..................................................
Two-High UPS Cabinets 13.............................................................
4 Version 1 Tie Cabinet Parallel Installation 17.................................
5 Version 2 Tie Cabinet Parallel Installation 27.................................
6 Installing Options 41....................................................
Powerware Hot Sync CAN Bridge Card 42.....................................................
7 Stabilizing the Cabinet 47................................................
8 Extended Battery Module Installation 51....................................
9 Operation 55...........................................................
Control Panel Functions 55................................................................
Changing the Language 56.............................................................
Display Functions 56..................................................................
User Settings 58.....................................................................
Initial Startup 60.......................................................................
Configuring the UPS for EBMs 61...........................................................
Parallel System Shutdown 62..............................................................
Individual UPS Shutdown 63...............................................................
Restarting the Parallel System 64...........................................................
10 Parallel Bypass 65......................................................
TABLE OF CONTENTS
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality
ii
11 Troubleshooting 67......................................................
Typical Alarms and Conditions 67...........................................................
Silencing the Alarm 69...................................................................
Service and Support 70...................................................................
12 Warranty 71...........................................................
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality 1
Chapter 1 Introduction
A parallel system with up to four uninterruptible power supplies (UPSs)
can be installed to provide a parallel capacity and/or redundant system.
This load sharing system provides more capacity than a single UPS and
can provide backup, depending on the load and configuration. In
addition, when one UPS is taken out of service for maintenance or is not
operating properly, a redundant UPS continues to supply uninterrupted
power to the critical load. A parallel Powerware Hot Sync®CAN Bridge
Card provides connectivity for system metering and operational mode
control. The parallel system consists of two to four UPSs, each with a
parallel CAN Bridge Card and a parallel cabinet.
Figure 1 shows the Eaton 9355 UPS UPS and an optional Extended
Battery Module (EBM).
Figure 1. The Eaton 9355 UPS UPS and EBM (3-High Cabinets Shown)
INTRODUCTION
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality
2
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality 3
Chapter 2 Safety Warnings
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions that you should follow during installation and
maintenance of the UPS and batteries. Please read all instructions before operating the
equipment and save this manual for future reference.
DANGER
This UPS contains LETHAL VOLTAGES. All repairs and service should be performed by
AUTHORIZED SERVICE PERSONNEL ONLY. There are NO USER SERVICEABLE PARTS
inside the UPS.
WARNING
SThis UPS contains its own energy source (batteries). The UPS output may carry live
voltage even when the UPS is not connected to an AC supply.
STo reduce the risk of fire or electric shock, install this UPS in a temperature and humidity
controlled, indoor environment, free of conductive contaminants. Ambient temperature
must not exceed 40°C (104°F). Do not operate near water or excessive humidity (95%
maximum).
STo reduce the risk of fire, connect only to a circuit provided with 100 amperes maximum
branch circuit overcurrent protection in accordance with the National Electrical Code®
(NEC®), ANSI/NFPA 70.
SOutput overcurrent protection and disconnect switch must be provided by others.
CAUTION
SBatteries can present a risk of electrical shock or burn from high short circuit current.
Observe proper precautions. Servicing should be performed by qualified service
personnel knowledgeable of batteries and required precautions. Keep unauthorized
personnel away from batteries.
SProper disposal of batteries is required. Refer to your local codes for disposal
requirements.
SNever dispose of batteries in a fire. Batteries may explode when exposed to flame.
SAFETY WARNINGS
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S164201601 Rev D www.eaton.com/powerquality
4
Consignes de Sécurité
CONSIGNES DE SÉCURITÉ IMPORTANTES
CONSERVER CES INSTRUCTIONS
CE MANUEL CONTIENT DES CONSIGNES DE SÉCURITÉ
IMPORTANTES
DANGER!
Cet onduleur contient des TENSIONS MORTELLES. Toute opération d'entretien et de
réparation doit être EXCLUSIVEMENT CONFIÉE A UN PERSONNEL QUALIFIÉ AGRÉÉ.
AUCUNE PIÈCE RÉPARABLE PAR L'UTILISATEUR ne se trouve dans l'onduleur.
WARNING
SCet onduleur renferme sa propre source d'énergie (batteries). Les prises de sortie
peuvent être sous tension même lorsque l'onduleur n'est pas branché sur le secteur.
SPour réduire les risques d'incendie et de décharge électrique, installer l'onduleur
uniquement à l'intérieur, dans un lieu dépourvu de matériaux conducteurs, où la
température et l'humidité ambiantes sont contrôlées. La température ambiante ne doit
pas dépasser 40 °C. Ne pas utiliser à proximité d'eau ou dans une atmosphère
excessivement humide (95 % maximum).
SLa protection contre une surintensité pour le(s) circuit(s) de sortie de courant alternatif
doit être fournie par un autre fournisseur.
SLes interrupteurs de déconnexion convenables pour le(s) circuit(s) de sortie de courant
alternatif doivent être fournie par un autre fournisseur.
ATTENTION!
SLes batteries peuvent présenter un risque de décharge électrique ou de brûlure par des
courts-circuits de haute intensité. Prendre les précautions nécessaires.
SUne mise au rebut réglementaire des batteries est obligatoire. Consulter les règlements
en vigueur dans votre localité.
SNe jamais jeter les batteries au feu. L'exposition aux flammes risque de les faire
exploser.
Andere Handbücher für Powerware 9355
8
Inhaltsverzeichnis
Andere Eaton UPS Handbücher
Eaton
Eaton Powerware 9390-160/100 Bedienungsanleitung
Eaton
Eaton Power Xpert 9395 Plus Bedienungsanleitung
Eaton
Eaton Eaton 5PX Montageanleitung
Eaton
Eaton Powerware 9395 Handbuch
Eaton
Eaton 9395XC Bedienungsanleitung
Eaton
Eaton 5S 550 Bedienungsanleitung
Eaton
Eaton Power Xpert Gateway Minislot Programmierhandbuch
Eaton
Eaton SPM Series Bedienungsanleitung
Eaton
Eaton 9315 Bedienungsanleitung
Eaton
Eaton 5S 550 Bedienungsanleitung
Eaton
Eaton Powerware 5125 Bedienungsanleitung
Eaton
Eaton Ellipse ECO 500 Bedienungsanleitung
Eaton
Eaton Ellipse PRO 1600 DIN Bedienungsanleitung
Eaton
Eaton Power Xpert Plus 1 Bedienungsanleitung
Eaton
Eaton Pulsar EX RT 5000 Bedienungsanleitung
Eaton
Eaton FERRUPS Bedienungsanleitung
Eaton
Eaton Powerware 9395 Handbuch
Eaton
Eaton 9 55 Series Bedienungsanleitung
Eaton
Eaton Powerware 5110 Bedienungsanleitung
Eaton
Eaton EX 700 Bedienungsanleitung
Beliebte UPS Handbücher anderer Marken
Pylontech
Pylontech Victron & Pylontech US5000 Bedienungsanleitung
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung
Mecer
Mecer ME-1000-WTU Bedienungsanleitung
Mustek
Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch
Emerson
Emerson Liebert NXL series Bedienungsanleitung
MAKELSAN
MAKELSAN BOXER SERIES Bedienungsanleitung
Block
Block PC-0524-400-0 Bedienungsanleitung
CyberPower
CyberPower CP585LCD Bedienungsanleitung
CyberPower
CyberPower Office Tower Series UPS 1000 Bedienungsanleitung
CyberPower
CyberPower BM100 Bedienungsanleitung
Best Power
Best Power 610 Bedienungsanleitung
Best Power
Best Power Unity/I UT3K Bedienungsanleitung
