Edelbrock 5737 Bedienungsanleitung

Brochure #63-0369

Rev. 11/06 - DA/mc

Page 1 of 2

Catalog #5737

Edelbrock Cat-Back Exhaust System

For 2003-2006 Hummer H2 6.0L V8 4WD

Catalog #5737

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Cat-back Exhaust System. If you have any questions,

contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at

[email protected].

Suggested Tools for Installation:

❑3/8" ratchet set with SAE and metric sockets

❑9/16” & 15mm wrench

❑Jackstands and jack

❑Liquid penetrant and rubber lubricant

DISASSEMBLY

1. Raise vehicle and support with proper jackstands for

the weight, leaving the suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts and bolts.

4. Remove the bolts and clamps from the system and

lubricate the rubber isolators.

5. Use a long pry bar to pull the rubber isolators off of the

pipe hangers.

6. Remove the old system. In some cases, you will find it

easier to cut the overaxle pipe to remove it.

Note: Carefully check all rubber isolators that the exhaust

system attaches to for wear, cracks, and fatigue.

Replace as necessary.

ASSEMBLY

1. Install I-Pipe to factory outlet flange (behind catalytic

converters). Use supplied 2-1/2” clamp for slip fit end.

Note: Do not tighten flange bolts or clamp at this time,

(snug only).

2. Slip the muffler onto the intermediate pipe with a

3" clamp on the front. Note: Inlet end of muffler is

marked. Snug the clamp so you can adjust the system

later.

3. Install a 3" band clamp on the front of the overaxle pipe

and engage it into the stock rubber isolators as you slip

it into the muffler. Snug the clamp.

4. Install hanger clamp assembly onto I-pipe and engage

into stock rubber hanger. Snug clamp to pipe. Hanger

bar should be level.

5. Working from the front of the system, align and tighten

each pipe from the cat-back.

6. Check for clearance to body, frame, and driveline as

you tighten the system from front to rear.

7. Check for leaks and correct, if necessary.

WARNING!!!

Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

INSTALLATION INSTRUCTION

Brochure #63-0369

Rev. 11/06 - DA/mc

Page 2 of 2

Catalog #5737

KIT CONTENTS

Catalog #5737

Qty.Part # Description

1 23-4040 Hanger Clamp Assembly

1 25-3191 I-Pipe

1 25-3192 Overaxle Pipe

1 25-5572 Muffler

1 46-6610 2 1/2” Clamp

3 46-6612 3” Band Clamps

WARNING: Support your vehicle with proper

jackstands or ramps rated for the total vehicle weight.

Place stands so that the rear axle is allowed to hang

free for easy system removal.

WARNING: These cat-back systems are engineered

to fit stock catalytic converters or equivalent replace-

ments. If you original system has been modified,

Edelbrock will not warranty fit or performance.

I-Pipe Assembly

Overaxle Pipe Assembly

Hanger

Edelbrock Corporation

2700 California St.

Torrance, CA 90503

Tech Line: (800) 416-8628

E-Mail: [email protected]

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 6564 Bedienungsanleitung

Edelbrock

Edelbrock 66592 Bedienungsanleitung

Edelbrock

Edelbrock 63-0081 Bedienungsanleitung

Edelbrock

Edelbrock 67082 Bedienungsanleitung

Edelbrock

Edelbrock 5250 Bedienungsanleitung

Edelbrock

Edelbrock 5713 Bedienungsanleitung

Edelbrock

Edelbrock Torker II 5081 Bedienungsanleitung

Edelbrock

Edelbrock 68272 Bedienungsanleitung

Edelbrock

Edelbrock Russell R08367 Bedienungsanleitung

Edelbrock

Edelbrock Acura Integra 6737 Bedienungsanleitung

Edelbrock

Edelbrock 33505 Bedienungsanleitung

Edelbrock

Edelbrock 7577 Bedienungsanleitung

Edelbrock

Edelbrock 5728 Bedienungsanleitung

Edelbrock

Edelbrock Victor Glidden 18 2858 Bedienungs- und Wartungshandbuch

Edelbrock

Edelbrock 5420 Bedienungsanleitung

Edelbrock

Edelbrock Performer Series 8059 Bedienungsanleitung

Edelbrock

Edelbrock 25-9213 Bedienungsanleitung

Edelbrock

Edelbrock 2475 Bedienungsanleitung

Edelbrock

Edelbrock 61949 Bedienungsanleitung

Edelbrock

Edelbrock Chevrolet 5783 Bedienungsanleitung

Edelbrock

Edelbrock 6661 Bedienungsanleitung

Edelbrock

Edelbrock 3811 Bedienungsanleitung

Edelbrock

Edelbrock 15015 Bedienungsanleitung

Edelbrock

Edelbrock PRO-FLO XT 3527 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung