Edge-Core ECS3510-28T Programmierhandbuch

Management Guide

www.edge-core.com

ECS3510-28T/52T

28/52-Port Fast Ethernet

Layer 2 Switch

ANAGEMENT

UIDE

ECS3510-28T FAST ETHERNET SWITCH

Layer 2 Switch

with 24 10/100BASE-TX (RJ-45) Ports,

and 4 Gigabit Combination Ports (RJ-45/SFP)

ECS3510-52T FAST ETHERNET SWITCH

Layer 2 Switch

with 48 10/100BASE-TX (RJ-45) Ports,

and 4 Gigabit Combination Ports (RJ-45/SFP)

ECS3510-28T

ECS3510-52T

E122013/ST-R04

M0NEC3510201Z

149100000204A

– 5 –

ABOUT THIS GUIDE

PURPOSE This guide gives specific information on how to operate and use the

management functions of the switch.

AUDIENCE The guide is intended for use by network administrators who are

responsible for operating and maintaining network equipment;

consequently, it assumes a basic working knowledge of general switch

functions, the Internet Protocol (IP), and Simple Network Management

Protocol (SNMP).

CONVENTIONS The following conventions are used throughout this guide to show

information:

OTE

Emphasizes important information or calls your attention to related

features or instructions.

AUTION

Alerts you to a potential hazard that could cause loss of data, or

damage the system or equipment.

ARNING

Alerts you to a potential hazard that could cause personal injury.

RELATED PUBLICATIONS The following publication details the hardware features of the switch,

including the physical and performance-related characteristics, and how to

install the switch:

The Installation Guide

Also, as part of the switch’s software, there is an online web-based help

that describes all management related features.

BOUT

HIS

UIDE

– 6 –

REVISION HISTORY This section summarizes the changes in each revision of this guide.

DECEMBER 2013 REVISION

This is the fourth version of this guide. This guide is valid for software

release v1.4.0.0. It includes information on the following changes:

◆Updated information on the length of cable which can be accurately

tested with cable diagnostics under "Performing Cable Diagnostics" on

page 170 and "test cable-diagnostics" on page 990.

DECEMBER 2013 REVISION

This is the third version of this guide. This guide is valid for software

release v1.4.0.0. It includes information on the following changes:

◆Updated range for parameters under "Resetting the System" on

page 146.

◆Removed symmetric parameter under "Configuring by Port List" on

page 152.

◆Added "Displaying Transceiver Data" on page 166 and "Configuring

Transceiver Thresholds" on page 167.

◆Added "Configuring Load Balancing" on page 185.

◆Added "Configuring MAC Address Learning" on page 227.

◆Updated Table 31, "Supported Notification Messages," on page 453.

◆Added information for Command Usage under Table , "Switch

Clustering," on page 482.

◆Added new parameters under "Using the Trace Route Function" on

page 561.

◆Updated range of Forwarding Priority under "Configuring IGMP

Snooping and Query Parameters" on page 608.

◆Updated parameter list under "Specifying Static Interfaces for a

Multicast Router" on page 612.

◆Added Multicast Data Drop parameter under "Filtering IGMP Query

Packets and Multicast Data" on page 621.

◆Updated range of Forwarding Priority under "Configuring MVR Domain

Settings" on page 644.

◆Added "mac-learning" on page 866.

◆Added "port security mac-address-as-permanent" on page 869.

◆Added "ip dhcp snooping limit rate" on page 896.

◆Added "clear ip dhcp snooping database flash" on page 900.

BOUT

HIS

UIDE

– 7 –

◆Added mode option to "ip source-guard binding" on page 912 and "ip

source-guard max-binding" on page 915.

◆Added "ip source-guard mode" on page 916.

◆Added "clear ip source-guard binding blocked" on page 917.

◆Updated parameters for "show ip source-guard binding" on page 918.

◆Added allow-zeros option for "ip arp inspection validate" on page 928.

◆Added Layer 3 and Layer 4 options to "permit, deny (MAC ACL)" on

page 957.

◆Updated parameters for "clear access-list hardware counters" on

page 965.

◆Removed symmetric parameter from "capabilities" on page 969.

◆Added "discard" on page 971 and "show discard" on page 977.

◆Added "Transceiver Threshold Configuration" on page 982.

◆Added "storm-sample-type" on page 1021.

◆Updated description of rate parameter under "switchport packet-rate"

on page 1022.

◆Added "loopback-detection action" on page 1046.

◆Removed “loopback-detection mode.”

◆Added "loopback detection trap" on page 1048.

◆Changed range of priority parameter under "ip igmp snooping priority"

on page 1194.

◆Updated syntax for "ip igmp snooping vlan immediate-leave" on

page 1202.

◆Added "ip igmp authentication" on page 1218 and "show ip igmp

authentication" on page 1223.

◆Updated syntax for "ip igmp query-drop" on page 1222.

◆Added "ip multicast-data-drop" on page 1222 and "show ip

multicast-data-drop" on page 1226.

◆Added "MLD Filtering and Throttling" on page 1237.

◆Updated range of priority parameter for "mvr priority" on page 1249.

◆Added "clear mrv groups dynamic" on page 1258.

BOUT

HIS

UIDE

– 8 –

◆Added "clear mrv statistics" on page 1258.

◆Updated parameter options for "show mvr statistics" on page 1263.

◆Added "clear mvr6 statistics" on page 1279.

◆Updated range of interval-level parameter for "ethernet cfm cc ma

interval" on page 1331.

◆Added "clear efm oam event-log" on page 1358.

◆Updated definition of netmask parameter for "ip address" on

page 1388.

◆Added parameter option for "traceroute6" on page 1416

DECEMBER 2012 REVISION

This is the second version of this guide. This guide is valid for software

release v1.2.4.2. It includes information on the following changes:

◆Removed support for VLAN translation.

◆Removed egress port option from Security > ACL (Configure Interface -

Configure) page under "Binding a Port to an Access Control List" on

page 367, the ip access-group command page 948, the ipv6 access-

group command page 954, and the mac access-group command

page 960.

◆Added "IPv6 Source Guard" on page 403.

◆Added UDP Port parameter to "Remote Log Configuration" on page 420

and logging host command on page 741.

◆Added "Ethernet Ring Protection Switching" on page 487, and "ERPS

Commands" on page 1085.

◆Added "Connectivity Fault Management" on page 512.

◆Added "OAM Configuration" on page 549.

◆Added "MLD Snooping (Snooping and Query for IPv6)" on page 632,

and commands for "MLD Snooping" on page 1227.

◆Added "Multicast VLAN Registration for IPv6" on page 657, and

commands for "MVR for IPv6" on page 1268.

◆Added "TFTP Configuration Commands" on page 726.

◆Added terminal command on page 737.

◆Added daylight savings time commands "clock summer-time (date)" on

page 756, "clock summer-time (predefined)" on page 758, and "clock

summer-time (recurring)" on page 759.

BOUT

HIS

UIDE

– 9 –

◆Added ipv6 dhcp snooping option remote-id command on page 905.

◆Added ipv6 dhcp snooping option remote-id policy command on

page 906.

◆Added commands for "IPv6 Source Guard" on page 919.

◆Added commands for "ND Snooping" on page 1423.

◆Added "UniDirectional Link Detection Commands" on page 1039.

JULY 2012 RELEASE

This is the first version of this guide. This guide is valid for software release

v1.0.0.0.

BOUT

HIS

UIDE

– 10 –

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edge-Core Netzwerk-Router Handbücher

Edge-Core

Edge-Core ECS3510-26P Programmierhandbuch

Edge-Core

Edge-Core ES3510 Bedienungsanleitung

Edge-Core

Edge-Core ES3510 Programmierhandbuch

Edge-Core

Edge-Core AS7926-40XKFB Bedienungsanleitung

Edge-Core

Edge-Core ECS4620-28F Bedienungsanleitung

Edge-Core

Edge-Core DCS209 Bedienungsanleitung

Edge-Core

Edge-Core ES4626 Bedienungsanleitung

Edge-Core

Edge-Core Wedge100BF-32QS Bedienungsanleitung

Edge-Core

Edge-Core EWS100 Bedienungsanleitung

Edge-Core

Edge-Core AS7946-30XB Bedienungsanleitung

Edge-Core

Edge-Core ES3628C Programmierhandbuch

Edge-Core

Edge-Core ES3526XA Bedienungsanleitung

Edge-Core

Edge-Core ECS3610-28T Bedienungsanleitung

Edge-Core

Edge-Core AS7512-32X Bedienungsanleitung

Edge-Core

Edge-Core ECS3810-26T Bedienungsanleitung

Edge-Core

Edge-Core AS5710-54X Bedienungsanleitung

Edge-Core

Edge-Core ES4624-SFP Programmierhandbuch

Edge-Core

Edge-Core ECS4100-26TX Bedienungsanleitung

Edge-Core

Edge-Core AS5835-54T Bedienungsanleitung

Edge-Core

Edge-Core ES3528MV2 Programmierhandbuch

Edge-Core

Edge-Core VR-100 Bedienungsanleitung

Edge-Core

Edge-Core AS7712-32X Bedienungsanleitung

Edge-Core

Edge-Core ECS4210-12P Bedienungsanleitung

Edge-Core

Edge-Core ECS4210-12P Programmierhandbuch

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise