Ekwb EK-FB ASUS ROG R6E Monoblock Bedienungsanleitung

All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Revision 4.0. Published on February 1st 2018

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no

liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates.

Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

1. Please carefully read the manual thoroughly before beginning with the installation process!

2. Please remove your motherboard from the computer to assure safest mounting process in order to prevent any possible damages to your CPU and/or motherboard’s circuit board (PCB).

3. The EK-HFB and EK-ACF type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.

4. The use of quality, market proved corrosion inhibiting coolants is always strongly recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION Sample photo of ASUS ROG Rampage VI Extreme motherboard

BAG CONTENT: Bag content is universal for all water blocks, you may not need all screws.

STEP 1: PREPARING YOUR MOTHERBOARD

STEP 2: PREPARING YOUR MOTHERBOARD

REMOVING STOCK COOLER. Remove all encircled screws. There are 2 screws on

the right back side of the motherboard that need to be removed in order to remove

I/O plastic cover and 4 screws for the factory installed MOSFET heat pipe cooling

solution. Please store away the factory backplate as it will be reused.

1. APPLYING THERMAL COMPOUND. Apply thermal compound on CPU heat

spreader (IHS) - see sample photo on right with enclosed EK-TIM Ectotherm thermal

grease.

The quantity of about two rice grains is just about right. There is no need to cover

the whole IHS. Applying too much thermal grease will have negative impact on the

cooling performance!

2. CUTTING THERMAL PADS. Your block comes with thermal pads which needs to be trimmed in order to fit the voltage regulation area (MOSFET) on the motherboard’s

circuit board. WARNING: DIMENSIONS ON PICTURES BELOW ARE SCALED.

Replacement thermal pads @ EKWB web shop:

Thermal PAD G 1mm - (120x24mm) [EAN: 3830046996770]

Thermal PAD F 2mm - (120x16mm) [EAN: 3830046996756]

Installation manual for EK-FB ASUS ROG R6E Monoblock water block

Mosfets

CPU socket

X299 PCH

(SB)

1. Thermal pad G–1.0mm

(for mosfets and inductor coils):

2. Thermal pad F–2.0mm

(for AQUANTIA Ethernet controller):

All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Revision 4.0. Published on February 1st 2018

STEP 3.1: PLACING THE HEATSINK ON TO MOTHERBOARD

(only for RAMPAGE)

PLACING THE HEATSING ON THE MOTHERBOARD AQUANTIA Ethernet controller.

Place the heatsink on to the motherboard and secure it using two M2,5x5 AX1

screws with M2.5 PVC washers. Then you can reinstall plastic factory I/O cover.

STEP 3.2: PLACING THE BLOCK ON TO MOTHERBOARD

STEP 4: ATTACHING BLOCK ON TO THE MOTHERBOARD

PLACING THE BLOCK ON THE MOTHERBOARD. Place the EK-FB ASUS ROG R6E

Monoblock series water block gently to the motherboard or vice versa (as shown on

photo below). Make sure that mounting holes are aligned. Place it on factory installed

washers on the motherboard (MOSFET area).

Prior to fastening the screws please make sure the mounting holes on the

motherboard’s circuit board are aligned with the water block.

A) Mosfet part: Use two M2,5x7 AX1 screws with original backplate. Tighten the

screws evenly. Do not use excessive force when tightening the screws!

B) CPU part: Use four thumb nuts with screws and washers. Tighten

the thumb nuts.

Use the enclosed screws and washers as shown in picture below:

STEP 5: CONNECTING THE LED STRIP (optional)

CONNECTING THE RGB

Plug the 4-pin connector from Monoblock

RGB LED strip to the motherboard.

Please ensure that the arrow indicated on

the connector is plugged into the 12V line

as indicated on your motherboard. failure

to do so will damage your motherboard

or LED strip.

CONNECTING THE D-RGB

Plug the 4-pin connector from Monoblock

D-RGB LED strip to the ADD HEADER on

the motherboard. Please ensure that the

arrow indicated on the connector is

plugged into the +5V line as indicated on

your motherboard. Failure to do so will

damage your motherboard or LED strip.

*D-RGB header is available only on

ASUS Rampage VI Extreme

motherboard

For the EK-FB ASUS ROG R6E Monoblock series water block to operate properly the

G1/4 port nearest to the right edge of the water block MUST BE USED AS THE

INLET PORT. EK recommends the use of EK-ACF fittings. When using fittings other

than EK-ACF series please use hose clamps or appropriate substitute to secure the

tubing to the barb. The use of biocide containing and corrosion inhibiting coolant is

always recommended for any liquid cooling system.

REQUIRED TOOLS AND MOUNTING SCREWS:

scissors philips screwdriver Allen key

M3 PVC Washer

Factory backplate

M2.5x7 screws

M3 thumb nut

3. PLACING THERMAL PADS ON MOTHERBOARD. Place thermal pads on

PCB as shown on the picture. PLEASE REMOVE THE PROTECTIVE FOIL

FROM BOTH SIDES OF THE THERMAL PADS PRIOR TO INSTALLATION!

Place 1mm thermal pads

in larger strips over both

marked area and make

sure all mosfet chips and

inductor coils are covered.

Place 2mm thermal pad

on AQUANTIA Ethernet

controller.

M2.5x5 screws

M2.5 PVC

Washer

Tubing

IMPORTANT: USE

THIS OPENING AS

AN INLET PORT!

Dieses Handbuch passt für folgende Modelle

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FB ASUS M6I Leitfaden

ekwb

ekwb EK-FC1080 GTX Ti Aorus Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX Ti Strix Bedienungsanleitung

ekwb

ekwb EK-FB GA X470 Gaming 7 RGB Bedienungsanleitung

ekwb

ekwb EK-FB ASRock X399 RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-UNI RAD Handbuch

ekwb

ekwb EK-Classic Pump Reservoir 160 SPC PWM D-RGB Handbuch

ekwb

ekwb EK-FC980 GTX Ti WF3 Handbuch

ekwb

ekwb EK-Momentum ROG Strix Z390I RGB Bedienungsanleitung

ekwb

ekwb EK-FC980 GTX Strix Handbuch

ekwb

ekwb EK-FC1080 GTX TF6 Backplate Handbuch

ekwb

ekwb EK-FC980 GTX TF5 Handbuch

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Bedienungsanleitung

ekwb

ekwb EK X Series Bedienungsanleitung

ekwb

ekwb EK-Momentum MSI Z390 MEG GODLIKE Bedienungsanleitung

ekwb

ekwb EK-FC750 GTX Series Bedienungsanleitung

ekwb

ekwb EK-Loop PCI Bracket Pass-Through Bedienungsanleitung

ekwb

ekwb EK-FB KIT EVGA SR-X Installationsanleitung

ekwb

ekwb EK-PRO GPU WB AMP-Trinity RTX 4090 Ni+Inox Bedienungsanleitung

ekwb

ekwb EK-7970 Leitfaden

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Bedienungsanleitung

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Leitfaden

ekwb

ekwb EK-Pro AM5 Series Bedienungsanleitung

ekwb

ekwb EK-Quantum Kinetic TBE 120 VTX PWM Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

ekwb EK-FB ASUS ROG R6E Monoblock Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken