ElectrIQ EiQCHA90B Bedienungsanleitung

USER MANUAL

ANGLED BLACK GLASS TOUCH

CONTROL COOKER HOOD

eiQCHA90B/ eiQCHA90SS

Thank you for choosing electriQ

Please read this user manual before using this

product and keep it safe for future reference.

Visit our page www.electriQ.co.uk for our entire product

range

CONTENTS

SAFETY

PRODUCT OVERVIEW

VENTING OPTIONS

INSTALLATION

FILTER INFORMATION

OPERATION

CLEANING AND MAINTENANCE

TROUBLESHOOTING

TECHNICAL SPECIFICATION

SUPPORT

SAFETY PRECAUTIONS

Whilst this product is compliant with all safety requirements,

incorrect or inappropriate use can lead to both personal injury and

potential damage to property. Please read the contents of this

instruction booklet thoroughly before fitting or using this appliance.

•The cooker hood must be installed in accordance with the

installation instructions and all measurements followed.

•All installation work must be carried out by a competent person

or qualified electrician.

•The unit must be connected to an earthed power supply.

•If venting externally, make sure the ducting has no bends

sharper than 90 degrees as this will reduce the efficiency of the

cooker hood.

•The cooker hood is for domestic use only and is not designed for

commercial use. It should only be used for the purpose it was

intended –to extract vapours and cooking odours.

•Do not flambé or use an open flame under the cooker hood.

•Do not try to use the cooker hood without the grease filters or if

the filters are excessively greasy. They should be cleaned

regularly (see “Maintenance”) or replaced as necessary.

•The extraction fan must be level to avoid grease collection at

one end, as this could cause a potential fire risk.

•Do not leave frying pans unattended during use because

overheated fat or oils might catch fire.

•If the cooker hood is damaged, do not attempt to use it.

•If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or a similarly qualified person in

order to avoid a hazard.

•This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

•Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

•Children should be supervised to ensure that they do not play

with the appliance. It is not a toy.

•The plug must be accessible after installation for isolation in

case of an emergency –or an appropriate fused switch if the

unit is hard-wired to the mains via a spur.

•The minimum distance between the surface of the hob and the

lowest part of the hood should be at least 65cm. A distance of

between 65cm and 75cm gives peak efficiency.

•The air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other fuels.

•When the hood is vented externally and used with appliances

which burn fuel (e.g. gas, oil, wood) the area must be sufficiently

ventilated to ensure safe operation. Fresh air must be allowed to

freely enter the room to prevent a partial vacuum.

•A partial vacuum can starve the heating appliance of oxygen,

impairing combustion. It can also prevent toxic fumes from

leaving the room, or can cause fumes to be sucked into the

room from outside.

•Safe operation is only possible when the partial vacuum within

the working area does not exceed 4 Pa (0.04 mbar). This can

be achieved by ensuring air is able to enter the room from

outside through a suitable sized opening which cannot be sealed

during operation. A number of alternative solutions are available

to ensure this. If in any doubt, professional advice should be

sought.

•Regulations concerning the discharge of air have to be fulfilled.

•There is a potential fire risk if cleaning is not carried out in

accordance with the instructions.

•Clean your appliance periodically by following the method given

in the chapter MAINTENANCE

•If used in recirculation mode, the charcoal filters trap odours and

must be replaced at least once a year depending on how

frequently the cooker hood has been used.

•For safety reasons, please use only the same size of fixing or

mounting screw, which are recommended in this instruction

manual.

•Warning: Failure to install the screws or fixing device in

accordance with these instructions may result in electrical

hazards

CAUTION: Accessible parts of the hood can become

very hot during use with cooking appliances, whether in use

or not, due to heat rising from the hob. Sufficient time

should be allowed for the unit to cool before touching either

the housing or the grease filters.

PRODUCT OVERVIEW - PARTS SUPPLIED

Description

Illustration

Qty.

Cooker hood

Chimney

Exhaust Pipe

Adaptor

cable tie

Plate I

Plate II

Screw

(4mm x 40mm)

Wall plug

Screw

(4mm x 8mm)

Screw

(4mm x 30mm)

Air Flaps

EXTERNAL VENTING

If you have an outlet to the outside, your cooker hood can be

connected as shown in the diagram using any suitable

extraction duct (enamel, aluminium, flexible pipe or

inflammable material with an interior diameter of 150mm) can

be used.

An adaptor is supplied to enable you to connect your hood to

pre-existing 120mm diameter ducting.

If this is the chosen installation method consideration to the

route of the vent pipe should be made prior to installation.

RECIRCULATION

This cooker hood also supports the recirculation of air once it has passed

through the filters. The filtered air is then expelled through the

vent holes in the side of the chimney.

When setting the unit up in this configuration, carbon filters

should also be used to remove odours from the air. Details of

sourcing and fitting the filters can be found in the Carbon filter

section.

When setting up for recirculation the installation instructions

should be followed, but a vent pipe should not be attached, and instead the air

can be routed back into the room through the top of the unit.

INSTALLATION

1. Before installation, ensure you have not connected the appliance to the

mains supply.

2. The cooker hood should be placed at a distance of 65~75cm above the

cooking plane for best effect.

3. Install the hanging screw on a suitable place once

the installation height is fixed, and keep it in line. The

fixed position of the inside chimney bracket is the

place of chimney. Also install the safety hole in the

wall. Total drill 8 holes and insert the Wall plug.

4. Put 2 x Screws (4mm x30mm) into hanging

hood position and keep it away from wall distance 3-

4mm, screw and tighten the bracket onto the wall

with the screws (4mm x 40mm) and wall plugs

provided.

5. The 2 x airflaps should be installed at this stage, as access is easier before

the unit is wall mounted. On the top of the Hood Unit itself, where the air outlet

vent is located, the 2 x flaps should be carefully installed, bending very slightly

so the lugs at each end locate into the holes, enabling flaps to pivot upwards

when the unit is in operation, opening up the outlet fully for the air to pass

through. Please note: the small spindles/lugs at each end of each flap locate

into the holes on the housing, not the grooves above them.

6. Hang the cooker hood on wall.

7. Install the v-flap and converter onto the cooker hood. Fix the expansion

pipe on the converter using a cable tie. Hang the cooker hood onto the hook.

8. Adjust the height of the chimney to approximately the required height.

Then install plate I on the chimney. Two screws (4mm x 8mm) are used.

9. Put the inner chimney into the outer chimney. Then pull the inner chimney

upwards. Adjust to reach the approximate height required. Fine height

adjustment is done later.

NOTE: Remember not to fix the

screw too tightly, so that later height

adjustment can be done more easily.

9. Fix the chimney set into the

chimney bracket and fix with 2 x

screws (4mmx8mm), then fix the

outer chimney bracket into wall with

2 x screws (4mm x 40mm), pull out

the exhaust pipe to outside.

10. Pull up the inner chimney and

fix it into inner chimney bracket

with 2 x screws (4mm x 8mm).

11. Take out the Aluminum filter and fix the safety hole with 2 x screws (4mm

x30mm).

12. Before usage, read all the instructions and make sure that the voltage (V)

and the frequency (Hz) indicated on the identification plate (found inside

the cooker hood) and all the data inside the appliance are exactly the

same as the voltage and frequency in your home. Then plug the power

lead into the power socket (or if connecting directly to the main via a

switched spur, ensure the work is carried out by a competent, qualified

person) and the cooker hood is then ready for use.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ElectrIQ Dunstabzugshaube Handbücher

ElectrIQ

ElectrIQ eiQ52GCANOPY Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURV60EN Bedienungsanleitung

ElectrIQ

ElectrIQ eiQSRG60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHIM60SC Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCANOPY52S Bedienungsanleitung

ElectrIQ

ElectrIQ eiqislandled Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURV60SC Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHFGBSS60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTOPVWHITE Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60touchslimhe Bedienungsanleitung

ElectrIQ

ElectrIQ ISLAND eiQTMISLANDSLIM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHDD60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ80CURVSCTM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTMVISORSTEEL Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCANOPY70TM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURVISL90SS Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ70CURVBL Bedienungsanleitung

ElectrIQ

ElectrIQ eiQATS60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60touchslim Bedienungsanleitung

ElectrIQ

ElectrIQ eiQSLIM100TOUCH Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHC60W Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCH110CEILING Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ52CANGW Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTMS60BL Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

Küppersbusch

Küppersbusch DX ISLA Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

ElectrIQ eiQCHA90B Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken