ElectrIQ EiQTMS60BL Bedienungsanleitung

USER MANUAL

COOKER HOOD

eiQTMS60BL eiQTMS90BL eiQTMS60SS

Thank you for choosing electriQ

Please read this user manual before using this

product and keep it safe for future reference.

Visit our page www.electriQ.co.uk for our entire product range

CONTENTS

SAFETY

VENTILATION

BEFORE USE

PRODUCT OVERVIEW

INSTALLATION

FILTERS

OPERATION

CLEANING AND MAINTENANCE

LIGHT BULB REPLACEMENT

TROUBLESHOOTING

TECHNICAL SPECIFICATION

SUPPORT

SAFETY PRECAUTIONS

Whilst this product is compliant with all safety requirements, incorrect or

inappropriate use can lead to both personal injury and potential damage to

property. Please read the contents of this instruction booklet thoroughly before

fitting or using this appliance.

•The cooker hood must be installed in accordance with the installation

instructions and all measurements followed.

•All installation work must be carried out by a competent person or qualified

electrician.

•The unit must be connected to an earthed power supply.

•If venting externally, make sure the ducting has no bends sharper than 90

degrees as this will reduce the efficiency of the cooker hood.

•The cooker hood is for domestic use only and is not designed for commercial

use. It should only be used for the purpose it was intended –to extract vapours

and cooking odours.

•Do not flambé or use an open flame under the cooker hood.

•Do not try to use the cooker hood without the grease filters or if the filters are

excessively greasy. They should be cleaned regularly (see “Maintenance”) or

replaced as necessary.

•The extraction fan must be level to avoid grease collection at one end, as this

could cause a potential fire risk.

•Do not leave frying pans unattended during use because overheated fat or oils

might catch fire.

•If the cooker hood is damaged, do not attempt to use it.

•If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or a similarly qualified person in order to avoid a hazard.

•This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

•Children shall not play with the appliance. Cleaning and user maintenance

shall not be made by children without supervision.

•Children should be supervised to ensure that they do not play with the

appliance. It is not a toy.

•The plug must be accessible after installation for isolation in case of an

emergency –or an appropriate fused switch if the unit is hard-wired to the

mains via a spur.

•The minimum distance between the surface of the hob and the lowest part of

the hood should be at least 65cm. A distance of between 65cm and 75cm

gives peak efficiency.

•The air must not be discharged into a flue that is used for exhausting fumes

from appliances burning gas or other fuels.

•When the hood is vented externally and used with appliances which burn fuel

(e.g. gas, oil, wood) the area must be sufficiently ventilated to ensure safe

operation. Fresh air must be allowed to freely enter the room to prevent a

partial vacuum.

•A partial vacuum can starve the heating appliance of oxygen, impairing

combustion. It can also prevent toxic fumes from leaving the room, or can

cause fumes to be sucked into the room from outside.

•Safe operation is only possible when the partial vacuum within the working

area does not exceed 4 Pa (0.04 mbar). This can be achieved by ensuring air

is able to enter the room from outside through a suitable sized opening which

cannot be sealed during operation. A number of alternative solutions are

available to ensure this. If in any doubt, professional advice should be sought.

•Regulations concerning the discharge of air have to be fulfilled.

•There is a potential fire risk if cleaning is not carried out in accordance with the

instructions.

•Clean your appliance periodically by following the method given in the chapter

MAINTENANCE

•If used in recirculation mode, the charcoal filters trap odours and must be

replaced at least once a year depending on how frequently the cooker hood

has been used.

•For safety reasons, please use only the same size of fixing or mounting screw,

which are recommended in this instruction manual.

•Warning: Failure to install the screws or fixing device in accordance with these

instructions may result in electrical hazards

CAUTION: Accessible parts of the hood can become very hot during

use with cooking appliances, whether in use or not, due to heat rising

from the hob. Sufficient time should be allowed for the unit to cool before

touching either the housing or the grease filters

OPTIONS FOR VENTILATION

This hood can be set up for either external venting or recirculation of the air. The type of setup

should be decided before commencing installation.

EXTERNAL VENTING

If you have an outlet to the outside, your cooker hood can be

connected as shown in the diagram using any suitable

extraction duct (enamel, aluminium, flexible pipe or

inflammable material with an interior diameter of 150mm) can

be used.

An adaptor is supplied to enable you to connect your hood to

pre-existing 120mm diameter ducting.

If this is the chosen installation method consideration to the

route of the vent pipe should be made prior to installation.

RECIRCULATION

This cooker hood also supports the recirculation of air once it has

passed through the filters. The filtered air is then expelled through

the vent holes in the side of the chimney.

When setting the unit up in this configuration, carbon filters should

also be used to remove odours from the air. Details of sourcing

and fitting the filters can be found in the Carbon filter section.

When setting up for recirculation the installation instructions should

be followed, but a vent pipe should not be attached, and instead

the air can be routed back into the room through the top of the unit.

BEFORE USAGE

Before usage, read all the instructions and make

sure that the voltage (V) and the frequency (Hz)

indicated on the identification plate (found inside

the cooker hood) and all the data inside the

appliance are exactly the same as the voltage and

frequency in your home.

Plug the power lead into the power socket (or if

connecting directly to the mains via a switched

spur, ensure the work is carried out by a

competent, qualified person) and the cooker hood

is then ready for use.

UNPACKING YOUR APPLIANCE

•Please take great care when unpacking; a sharp blade should not be used to open the box,

as it may go deep enough inside to damage components. Components damaged or marked

by careless unpacking are not covered under the guarantee.

•Carefully unpack the contents and check against the section below (Parts) and the next

section (Product overview).

•Packaging materials should be recycled in accordance with local regulations

PRODUCT OVERVIEW - PARTS SUPPLIED

Description

Illustration

Qty.

Cooker hood

Chimney

Adaptor

Cable tie

Wall bracket

Plate I

Plate II

Screw

(4mm x 30mm)

Wall plug

Air Flaps

Screw

(3mm x 10mm)

INSTALLATION

Before installation, ensure you have not connected the appliance to the mains supply.

1. The base of the cooker hood should be placed at a distance of

70~80cm above the cooking plane for best performance.

2. Drill 3 holes to accommodate the wall bracket. Screw and

tighten the wall bracket onto the wall with the screws (4mm x

30 mm) and wall plugs provided.

3. Hang the appliance onto the wall bracket

hook and fix the appliance using the 2 screws

(4mm x 30mm).

5. Plates I and II are used to fix the chimney onto the

wall. Slide the inner chimney on to the outer chimney

and place in position on top of the hood. Mark the

position for plate II. Then slide the inner chimney

upwards to the desired height, and mark the location

for plate I.

6. The holes to accommodate the two plates can then

be drilled, and both the brackets fixed to the wall using

two screws (4mm x 30mm) and wall plugs for each.

NOTE: Fixing the chimney to wall plate is done at the

end of installation.

7. The 2 x air flaps should be installed at this

stage, as access is easier before the unit is

wall mounted. On the top of the Hood Unit

itself, where the air outlet vent is located, the 2

x flaps should be carefully installed, bending

very slightly so the lugs at each end locate into

the holes, enabling flaps to pivot upwards

when the unit is in operation, opening up the

outlet fully for the air to pass through. Please

note –the small spindles/lugs at each end of

each flap locate into the holes on the housing,

not the grooves above them:

9. Put the chimneys back onto the cooker hood. Hook the

outer chimney onto plate II. Lift up the inner chimney to the

desired height and hook in onto plate I. Alternatively Plate I

can be attached to the chimney using 2 x 10mm screws

(Supplied).

10.Plug the power lead into

the power socket (or if

connecting directly to the

mains via a switched spur,

ensure the work is carried

out by a competent,

qualified person) and the

cooker hood is then ready

for use.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ElectrIQ Dunstabzugshaube Handbücher

ElectrIQ

ElectrIQ eiQCURVISL90SS Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60touchslimhe Bedienungsanleitung

ElectrIQ

ElectrIQ eiQATS60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiq90chimbl Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHDD60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCH110CEILING Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCANOPY52S Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ52CANGW Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTMVISORSTEEL Bedienungsanleitung

ElectrIQ

ElectrIQ eiqislandled Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60touchslim Bedienungsanleitung

ElectrIQ

ElectrIQ ISLAND eiQTMISLANDSLIM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURV60EN Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHIM60SC Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ80CURVSCTM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHINTGY60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ52GCANOPY Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTOPVWHITE Bedienungsanleitung

ElectrIQ

ElectrIQ EIQ90CANGW Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60PBSLIMEN Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHB60B Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCANOPY70TM Bedienungsanleitung

ElectrIQ

ElectrIQ eiQSLIM100TOUCH Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHA90B Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch

ElectrIQ eiQTMS60BL Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken