ElectrIQ EiQCURV60EN Bedienungsanleitung

USER MANUAL

COOKER HOOD

eiQCURV60/90EN

eiQCURV60/90ENBL

Please read this manual before using or installing the cooker hood and

keep it safe for future reference.

Visit our page www.electriQ.co.uk for our entire range of electricals

CONTENTS

IMPORTANT SAFETY INFORMATION

PARTS

INSTALLATION OF FLAPS

EXTERNAL VENTILLATION

INSTALLATION

EXHAUST INSTALLATION

OPERATION

GREASE MESH FILTERS

CARBON FILTER

REPLACING THE BULB

CLEANING AND MAINTENANCE

TROUBLESHOOTING

SPECIFICATION AND SUPPORT

PRODUCT FICHE

IMPORTANT SAFETY INFORMATION

Please read this instruction manual carefully and retain

for future reference. It contains important information

concerning the safe operation, installation and

maintenance of the appliance.

• There must be adequate ventilation of the room when

the hood is used at the same time as appliances

burning gas or other fuels.

• This cooker hood is only designed for domestic use,

and should not be used in a commercial environment.

• Never use the hood for any purpose other than its

intended use.

• Do not check the status of the filters during operation of

the cooker hood.

• Do not touch the light bulb within 30 minutes of use.

• Do not flambé or excessively flame under the hood.

• Never leave frying food unattended as it can be a

serious fire hazard.

• If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or a similarly

qualified person in order to avoid a hazard.

• The socket outlet for the hood must be located so it is

easily accessible for the user after installation.

• Ensure the mains supply voltage corresponds with that

of the appliance.

• There is a fire risk if cleaning is not carried out in

accordance with the instructions.

• Ensure that the socket used provides adequate earthing

of the appliance, if unsure professional advice must be

sought.

• This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or

instruction concerning use of the appliance in a safe

way and understand the hazards involved.

• Children must not play with the appliance.

• Cleaning and user maintenance must not be carried out

by children without supervision.

• When the hood is being maintained, cleaned or filters

changed, make sure it is switched off at the mains

supply.

• The exterior of the hood should be cleaned with mild

detergent on a warm damp sponge or cloth.

• The air must not be discharged into a flue that is used

for exhausting fumes from appliances burning gas or

other fuels.

• Regulations concerning the discharge of air have to be

fulfilled.

• The minimum distance between the supporting surface

for the cooking vessels on the hob and the lowest part

of the hood must be at least 65 cm.

• When the cooker hood is used in conjunction with

appliances supplied with energy other than electric, the

negative pressure in the room must not exceed 0,04

mbar to prevent fumes being drawn back into the room

by the cooker hood.

• Failure to install the hood in accordance with these

instructions may result in electrical hazards.

CAUTION:

Accessible parts may become hot when used with

cooking appliances.

Deep fat fryers must be continuously monitored during

use: overheated oil can burst into flames.

PARTS

DESCRIPTIONILLUSTRATIONQTY

Cooker Hood 1

Glass Canopy

Chimney Sections (Pair) 1

Outlet 1

Air Flap 2

Chimney bracket 1

Canopy Anti vibration ring 4

Canopy Mounting washer 4

Bolt (M4*20) 4

Screw (ST4*40) 2

Screw (ST4*30) 4

Wall plug 6

Screw (ST4*8) 4

Exhaust Adaptor 1

INSTALLATION OF THE FLAPS

The 2 air flaps should now be installed on the top of the unit, as access

is easier before the unit is wall mounted. The flaps should be carefully

installed, bending them slightly so the lugs at each end locate into the

holes in the outlet vent. When the unit is in operation the flaps pivot

upwards to allow airflow.

Please note: Ensure the small lugs at each end of each flap locate into

the holes on the housing and not the grooves above them.

After installing the flaps, ensure that they are able to pivot freely within

the outlet, before fixing the air outlet to the top of the unit using 2 x ST4*8

Screws.

OPTIONS FOR VENTILATION

This hood can be set up for either external venting or recirculation of the

air. The type of setup should be decided before commencing

installation.

EXTERNAL VENTING

If you have an outlet leading outside, your

cooker hood can be connected as shown in the

diagram using a flexible exhaust pipe.

Alternatively, any suitable extraction duct

(enamel, aluminium, flexible pipe or

inflammable material with an interior diameter

of 120/150mm) can be used.

An adaptor is also supplied to enable you to

connect your hood to pre-existing 120mm

diameter ducting.

If this is the chosen installation method, consideration to the route of the

vent pipe should be made prior to installation.

NOTE: the performance of the hood may be affected if the diameter of

the pipe is reduced, or if the airflow is restricted.

RECIRCULATION

This cooker hood also supports the

recirculation of air once it has passed through

the filters. The filtered air is then expelled

through the vent holes in the side of the

chimney.

When setting the unit up in this configuration,

carbon filters should also be used to remove

odors from the air. Details of fitting the filters

can be found in the Carbon filter section.

When setting up for recirculation the installation instructions should be

followed, but the vent pipe should not be attached, allowing the air to be

expelled through the vents on the side of the chimney.

INSTALLATION

• Unpack the hood and check that all functions are working. Ensure that

the voltage (V) and the frequency (Hz) indicated on the serial plate

match the voltage and frequency at the installation site.

• Check that the area behind the installation surface is clear of any

electrical cables or pipes, etc to avoid damage when drilling.

• The surfaces of the hood can be very easily damaged during installation.

Take care with tools to protect the surfaces during installation.

• Protect the hob surface with cardboard, or similar, to prevent damage

occurring whilst the hood is being installed above.

• The manufacturer shall not be liable for any failure to observe all

safety regulations in force for the correct and normal operation of

electrical products.

• Ensure the wall is level and the installation plates are horizontal to

prevent grease from accumulating within the hood.

• Ensure the power has been turned off at the mains before starting

installation.

• Connection to the mains supply must be in an accessible location.

• You may need the following tools to complete this installation:

• Drill appropriate for your wall

• Phillips Screwdriver

• Tape Measure

• Electrical wiring must be done by a qualified professional in accordance

with all applicable codes and standards, including fire rated construction.

IMPORTANT

• Sufficient air is needed for proper combustion and exhaustion of gases

through the flue (chimney) for fuel burning equipment to prevent back

drafting. Ductless fans must always be vented to the outdoors.

• When assessing the air pressure, the entire ventilation system in the

house/apartment must be taken into account.

• All legal regulations must be observed for the conveyance of exhaust air.

If the extractor hood is used in recirculating mode with the optional

carbon filter, there are no operating restrictions.

1. Before installation, ensure

you have not connected

the appliance to the

mains supply.

2. The cooker hood should

be placed at a distance of

65~75cm above the

cooking plane for best

effect.

3. After confirming the

height of the cooker

hood measure the

position of the

holes inside and

outside of the

chimney bracket for

hanging the hood.

4. Drill 4 holes, 2 for

the inner chimney

bracket and 2 for

hanging the hood, and keep the hood level.

The inner chimney bracket should be

secured at the highest point.

5. Screw two 4 x 30mm screws on the wall with wall plugs to fix the

hood, then use two 4mm x 40mm screws to fix the inner chimney

bracket.

6. Place the glass canopy on to the

hood, aligning the screw holes.

Place the anti-vibration rings into

the 4 holes before securing the

glass canopy into place by

tightening the 4 bolts (M4*20)

through the mounting rings into

the hood.

7. Then fix the outlet on the hood

and attach the adaptor.

8. Hang the hood on the wall in the desired

final position.

9. Once the hood is positioned

correctly, fix the unit to the wall

using 2 x ST4*30 screws and wall

plugs through the fixing holes.

The fixing holes are located inside

the unit behind the grease filters.

10. Place the two chimneys together

onto the cooker hood body. Adjust

the height of the inner chimney

until a suitable height. Fix the inner

chimney to the chimney bracket

using the supplied screws

(ST4*8).

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ElectrIQ Dunstabzugshaube Handbücher

ElectrIQ

ElectrIQ eiQ60touchslim Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHDD60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTOPVWHITE Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHC60W Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHINTGY60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ52CANGW Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHB60B Bedienungsanleitung

ElectrIQ

ElectrIQ eiqislandled Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTMVISORSTEEL Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURVISL90SS Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURV60SCTOUCH Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ60PBSLIMEN Bedienungsanleitung

ElectrIQ

ElectrIQ eiQSLIM100TOUCH Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHIM60SC Bedienungsanleitung

ElectrIQ

ElectrIQ eiQATS60 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ80CURVSCTM Bedienungsanleitung

ElectrIQ

ElectrIQ EIQ90CANGW Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCURV60SC Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCH110CEILING Bedienungsanleitung

ElectrIQ

ElectrIQ eiQCHA90B Bedienungsanleitung

ElectrIQ

ElectrIQ eiq90chimbl Bedienungsanleitung

ElectrIQ

ElectrIQ eiQTMS60BL Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ70CURVBL Bedienungsanleitung

ElectrIQ

ElectrIQ ISLAND eiQTMISLANDSLIM Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch

ElectrIQ eiQCURV60EN Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken