Electro-Harmonix Octavix Bedienungsanleitung

Octavix

OCTAVE FUZZ

Congratulations on your purchase of the Electro-Harmonix Octavix, a fuzz pedal with

a frequency doubling circuit. The Octavix produces a range of distortion from light

drive to over the top torn speaker fuzz tone. The frequency doubling circuit yields

classic chime and ring modulated overtones. The Octavix has control over Boost,

Octave, Volume and internal rail voltage. The rail voltage switch enables even more

tonal possibilities not found in other octave fuzz pedals.

WARNING: Your OCTAVIX comes equipped with an Electro-Harmonix 9.6DC-200BI power

supply (same as used by Boss®& Ibanez®: 9.6 Volts DC 200mA). The OCTAVIX draws up to

62mA at 9VDC with a center negative plug or runs off a 9Volt battery. Using the wrong adaptor

or a plug with the wrong polarity may damage your OCTAVIX and void the warranty.

GETTING STARTED

Connect the output plug of the supplied power adaptor to the 9V power jack. Plug

your instrument into the INPUT jack; connect your amp to the OUTPUT jack.

Sample settings:

*Tip: Playing lightly will make the octave above effect more pronounced.

BOOST KNOB

The BOOST knob controls the amount of fuzz.

*Tip: Rolling down the guitar volume with high BOOST settings gives a slightly

broken up fuzz sound.

OCTAVE KNOB

The OCTAVE knob controls the volume of the octave above signal. At fully counter

clockwise the octave above signal is removed from the signal path.

VOLUME KNOB

The VOLUME knob controls the output signal level of the effect.

9/24 TOGGLE SWITCH

The Octavix contains a rail voltage selector switch just below the OCTAVE knob. The

setting of this switch determines the power supply voltage for the entire circuit. When

set to 9, the circuit is powered by 9V, when set to 24 the circuit runs off of 24V. At

9V the pedal behaves like the classic saggy fuzz boxes of the mid 70’s. At 24V the

pedal commands a tighter sound and produces a richer octave tone.

*Note: When switching from 9 to 24 there may be volume drop before the boost in

volume. This is normal as it takes a second or two for the capacitors to charge up to

24V.

*Note: When in 24V mode, if all of the controls are at maximum it will produce

feedback which will translate into a chirping sound. This is normal.

BYPASS FOOTSWITCH & STATUS LED

The Footswitch selects whether the Octavix is engaged or in True Bypass mode.

When the effect is engaged, the LED is lit.

INPUT JACK

The ¼” jack is the audio input for the Octavix. The input impedance is 1MΩ.

AMP JACK

The ¼” jack is the audio out for the Octavix.

CHANGING THE BATTERY

To change the 9-volt battery, you must remove the 4 screws on the bottom of the

Octavix. Once the screws are removed, you can take off the bottom plate and change

the battery. Please do not touch the circuit board while the bottom plate is off or you

risk damaging a component. To extend battery life, disconnect the INPUT jack when

the Octavix is not in use. When in 24V mode the battery drain is significantly greater

than in 9V mode.

Current draw

Current draw of the OCTAVIX is 9mA when the toggle switch is set to 9 and 62mA

when the switch is set to 24.

- WARRANTY INFORMATION -

Please register online at http://www.ehx.com/product-registration or complete and

return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will

repair or replace, at its discretion, a product that fails to operate due to defects in

materials or workmanship for a period of one year from date of purchase. This

applies only to original purchasers who have bought their product from an authorized

Electro-Harmonix retailer. Repaired or replaced units will then be warranted for the

unexpired portion of the original warranty term. If you should need to return your

unit for service within the warranty period, please contact EHX Customer Service at

718-937-8300 or [email protected] for a Return Authorization Number. Along with your

pedal, please include a brief description of the problem as well as your name,

address, telephone number, copy of your receipt, and a check or money order.

United States - $12 Ship to:

Canada - $15 Electro-Harmonix

Europe and outside countries - $25 C/O New Sensor Corporation

55-01 2nd Street

Long Island City, NY, 11101

Attn: Service Department

Please make checks/money orders payable to New Sensor Corporation.

To hear demos on all EHX pedals visit us on the web at www.ehx.com

Email us at [email protected]m

- FCC COMPLIANCE -

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation. If the

device is not installed and used in accordance with the instructions, it may cause harmful

interference to radio communications and void the user's authority to guarantee the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.



Consult the dealer or an experienced radio/TV technician for help.

Modifications not expressly approved by the manufacturer could void the user's authority to

operate the equipment under FCC rules.

Andere Electro-Harmonix Musikpedal Handbücher

Electro-Harmonix

Electro-Harmonix PLATFORM Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Epitome Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix MAINFRAME bit crusher Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Intelligent Harmony Machine Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix STEREO MEMORY MAN WITH HAZARAI Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix XO BASS BIG MUFF PI Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix V256 Vocoder Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix LUMBERJACK Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Deluxe Electric Mistress Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix LESTER G Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix GREEN RUSSIAN BIG MUFF Pi Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Attack Decay Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Holier Grail Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix SLAMMI Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix XO WHITE FINGER Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix SLAMMI PLUS Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix nano MUFF OVERDRIVE Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix OPERATION OVERLORD Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Iron Lung Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Triangle Big Muff Pi Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix nano STEEL LEATHER Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix EDDY Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix 1 ECHO Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix NANO BIG MUFF PI Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung