Electrolux Z5305 Bedienungsanleitung

OPERATING INSTRUCTIONS

Z5305

Contents

Safety information........................................................................................................................4

Exploded view and assembly......................................................................................................5

Vacuum cleaning ...........................................................................................................................6

Nozzles ..............................................................................................................................................7

Emptying dust collector/cleaning filters................................................................................8

Transport and storage ..................................................................................................................9

Maintenance and cleaning...................................................................................................... 10

What to do if... ............................................................................................................................ 10

For the sake of the environment........................................................................................... 10

Spares ............................................................................................................................................. 10

Service.............................................................................................................................................11

Guarantee ......................................................................................................................................11

Dear Customer

Please read these operating instructions carefully. Pay particular attention to the

safety information! Please keep the operating instructions for future reference.

Pass them on to any future owner of the appliance.

Before you start

Check the voltage

First check the voltage shown on the data plate (see rear view) to make sure that

the cleaner is of the correct voltage for your electricity supply. If it is not, do not

use the cleaner but refer back to your dealer.

Connecting to your electricity supply

Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a

non-rewirable plug incorporating a 13A fuse.

In the event of the fuse requiting replacement the fuse cover should be removed

using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved

BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is

used again. In the event of loss of the fuse cover, replacements can be obtained

from your Electrolux Retailers and must be of the same colour as indicated by the

coloured insert on the base of the plug.

If difficulty is experienced in obtaining a replacement, contact Electrolux on 08706

055055.

In no circumstances must the plug be used without a correct fuse cover fitted.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it

must be cut off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to prevent the hazard of shocks in case

it should be plugged into a 13 amp socket in another part of your home.

The wires in the mains cable of this appliance are coloured in accordance with the

following code: Blue: Neutral. Brown: Live.

As the colours of the wires in the mains cable of this appliance may not correspond

with the coloured markings identifying the terminals in your plug, proceed as fol-

lows:

The wire which is coloured blue must be connected to the terminal which is mar-

ked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is mar-

ked with the letter L or coloured red.

If using a three-pin plug, do not make any connection to the terminal marked with

the letter E or by the earth symbol or coloured green or green-and-yellow. This cle-

aner is double insulated and no earth connection is necessary.

It is in your interest to ensure that the plug is correctly attached to the mains

cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot

regard the repair of faults on the plug connection as a service that can be given

free of charge under the terms of the guarantee.

Fuse cover

Fuse blue brown

Cord clamp

13 Amp Fuse

Safety information

• Power supply: AC only 220/230 V, fuse 13A (see also „Before you start“, page 2).

• Do not put the unit into service if:

– the connecting lead is damaged,

– the unit is visibly damaged.

• Use only in the home for cleaning dry material.

People and animals must not be treated with the unit.

Keep children away from electrical appliances.

• Do not vacuum:

–Liquids. Allow damp cleaned fitted carpet to dry out completely.

– Matchsticks, glowing ash or cigarette ends.

– Hard, pointed objects.

– Toner dust (from laser printers, photocopiers).

• Never pull the mains plug from the socket with the cord. Do not run over the

mains cable with the unit and suction brush.

• Do not clean unit with water (except filters and dust collector as per the

instructions).

• Do not expose the unit to the effects of weather, moisture or sources of heat.

• Dust collector or a paper dust bag and all filters must always be fitted. If no

dust collector or paper dust bag is fitted, the dust-collector compartment

cover cannot be closed. Please do not use force!

• Repairs to electrical appliances must be carried out by qualified service engi-

neers. Improperly performed repairs can result in considerable danger for the

user.

• If the power cable is defective the entire cable roller must be exchanged by the

AEG customer service or an authorised workshop.

• The manufacturer accepts no liability for any damage caused by improper use

or incorrect operation.

In the event of a fault please contact your specialist dealer or the Electrolux custo-

mer service directly.

This vacuum cleaner complies with the following EU Directives

• 73/23/EEC of 19.02.1973 – Low Voltage Directive.

• 89/336/EEC of 03.05.1989 (including revised Directive 92/31/EEC)

– EMC Directive.

Exploded view and assembly

ACable rewind foot switch FAccessories holder *

BFoot switch ON/OFF GSuction control *

C"Empty dust collector" indicator HMetal tubes (2) *

DOpener for dust-collector JFloor nozzle *

compartment KPower cable

ESuction hose

* depending on model

F *

H *

J *

G *

Vacuum cleaning

• Withdraw cable, insert mains plug.

(To roll the cable up press foot switch A. Please hold the plug.)

• Switch on/off with foot switch B(on the lowest power setting, there may be a

start delay up to 4 seconds due to the electronic starting current limiter *).

• Suction capacity can be reduced by opening the suction control G*.

If you open the suction control Gon the bent end, you can reduce the force requi-

red to push the nozzle across the carpet, and enable you to clean lightweight rugs,

curtains and upholstery.

* depending on model

G *

Nozzles

LFloor nozzle *, dual purpose for carpets and hard floors

MFurniture brush *

NCrevice nozzle *

OUpholstery nozzle * (threads and fluff are effectively removed)

* depending on model

L *

M * N * O *

Emptying dust collector/cleaning filters

• We recommend emptying the dust collector after each use, but no later than

when indicator Cshows red all over (with the unit switched to maximum suc-

tion capacity and the nozzle raised from the floor). If necessary, also brush dust

from the collector filter. Figs. 1-3.

Caution: open dust-collector compartment cover fully until it locks in place!

If the collector is cleaned wet (see also p. 10): allow to dry well before refitting.

•If the suction power falls off noticeably even after the dust collector has

been emptied (or if indicator C is red), rinse out all filters under hot running

water. Allow to fully dry before refitting. Figs. 4-6. Replace filters if necessary.

* depending on model

123

456

Transport and storage

Maintenance and cleaning

Before starting maintenance or cleaning, switch off the unit and withdraw the

mains plug.

Wipe over unit and dust-collector compartment if necessary with a damp cloth

and allow to dry. Do not use abrasive materials or solvents. Clean floor nozzle and

brush webs occasionally with the crevice nozzle.

Do not wash the dust collector in a dishwasher or clean with aggressive detergents.

(This could damage or dull the dust collector).

What to do if...

...it is difficult to move the nozzle: reduce the suction capacity. This does not

reduce the cleaning effect.

...the motor overheating protection has switched off the unit: e.g. owing to

overload of the motor, by full dust collector or blocked tools.

Switch off the unit, withdraw the mains plug, allow motor to cool. Check dust col-

lector, suction tube and suction hose; removed any blockage. The unit can be swit-

ched on again after approx. 30 minutes.

...the fuse has blown: the fuse can blow if other electrical units with high con-

sumption are used at the same time as the vacuum cleaner from the same circuit.

In this case before switching on set the suction capacity control to the lowest level

and only select a higher level after switching on.

For the sake of the environment

Do not simply discard packing material and used units!

Unit packing: we recommend preserving the packing material for the term of the

warranty to permit reliable transport.

Take the polyethylene (PE) bag to a PE recycling bank.

Recycling the vacuum cleaner at the end of its service life: the plastic parts are

identified by a material code, so that they can be recycled at the end of the service

life of the vacuum cleaner in the same way as other materials.

Your local authority environment office will provide information on the location of

the nearest recycling facility.

Spares

New filters, dust bags, brush rollers and drive belts can be obtained from Authori-

sed Electrolux Dealers and electrical retailers. If difficulty is experienced in obtai-

ning spares please call us on 08706 055055.

Inhaltsverzeichnis

Andere Electrolux Staubsauger Handbücher

Electrolux

Electrolux ERGORAPIDO Bedienungsanleitung

Electrolux

Electrolux Ultrasilencer deepclean Bedienungsanleitung

Electrolux

Electrolux 5551 Bedienungsanleitung

Electrolux

Electrolux CYCLONE ULTRA Bedienungsanleitung

Electrolux

Electrolux EL1014 Bedienungsanleitung

Electrolux

Electrolux Ergorapido Classic EERC72IW Bedienungsanleitung

Electrolux

Electrolux EL5010 - Aptitude Quiet Upright Vacuum... Bedienungsanleitung

Electrolux

Electrolux airmax ZAM 6210 Bedienungsanleitung

Electrolux

Electrolux Ergorapido EHVS2510AW Bedienungsanleitung

Electrolux

Electrolux AEG 60 Series Bedienungsanleitung

Electrolux

Electrolux TWINCLEAN Z 8234 Bedienungsanleitung

Electrolux

Electrolux Ultrasilencer Series Bedienungsanleitung

Electrolux

Electrolux Elara Bedienungsanleitung

Electrolux

Electrolux EL7020A - Home Care Oxygen3 Canister Vacuum Bedienungsanleitung

Electrolux

Electrolux Ergospace Green Bedienungsanleitung

Electrolux

Electrolux ultrapower EL3020 Series Bedienungsanleitung

Electrolux

Electrolux RAPIDO CAR VAC ZB412C Bedienungsanleitung

Electrolux

Electrolux Ergorapido 12V Bedienungsanleitung

Electrolux

Electrolux ERGORAPIDO Bedienungsanleitung

Electrolux

Electrolux Z 990 Bedienungsanleitung

Electrolux

Electrolux Z3270 series Bedienungsanleitung

Electrolux

Electrolux PURED9 Bedienungsanleitung

Electrolux

Electrolux Ergorapido Li-21 Bedienungsanleitung

Electrolux

Electrolux PUREi9 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung