Elite Screens OMS103HR Bedienungsanleitung

042117DR www.elitescreens.com 1

Yard Master Series

Rear Projection Outdoor Movie Screen

User’s Guide (v. 2)

Note:

1. The Ring-Stakes, Curved-Stakes & Guy Rope should always be installed for Stability.

2. Use of this product is not recommended in gusty winds over 20mph.

Maintenance:

1. Soft cloth with mild soap &water may be used to clean the screen’s surface.

2. To prolong the lifespan of this product, store it in its carry case when not in use.

Parts checklist (Model: OMS103HR/OMS123HR)

A. Screen material x1 B. Steel tube x12-14

C. Fiber glass pole x4

D. Carrying bag x1

E. Guy-ropes x4

F. M6hex nuts x2

G. Curved stake x4

H. Ring stake x4

I. M6x43mm hex screw x2

J. Velcro band x24

K. Lock Pins (Spare parts) x 5

A. Main Support Metal Frame Assembly

1. Assemble the steel tube frame by connecting the letters on the ends of the tubes together as shown in the

picture. For example, A to A, B to B etc.

14 Top/Bottom sections - 15cm bands

10 Left/Right sections - 13cm bands

042117DR www.elitescreens.com 2

2. A and Jare attached and secured with the provided Hexagonal Screws (G). This will be the last step.

Step 2:Screen Material Frame Assembly (Fiber glass poles)

1. Join the Fiber Glass Pole to form a straight support rod as shown in the diagram below.

2. Repeat to complete the two horizontal rods. Keep the two vertical rods disconnected for the next steps.

Step 3: Attaching the screen material to the frame

1. Lay out the material on a clean, scratch-free area.

2. Insert the horizontal support rods into the top and bottom sleeves of the screen material.

Horizontal support rod

3. After the frame has been built, lay it on a clean

scratch-free area.

Horizontal support rod

Horizontal Support Rod x2

042117DR www.elitescreens.com 3

3. To insert the vertical support rods, fold the material in half (long ways)

at the middle opening. Insert both ends of the rod into each half of the

material as shown in Fig.1.

4. Keeping the frame laid flat, place and center the screen material (Elite Screens logo facing up) inside the metal

frame.

5. Attach the screen material by the exposed areas of the vertical and horizontal support rods onto the metal frame

wrapping the velcro bands around the rod and frame. Two people are recommended for the following steps.

Front of Screen material

While folded in half, match the connecting ends of the rod and slowly

lower and flatten the material to have the rod connect.

(Shown below in Fig. 2)

Repeat for other side.

Fig. 1

Fig. 2

042117DR www.elitescreens.com 4

1. With one person at the top of the

frame and the other at the bottom, begin

by attaching the material with the velcro

bands, starting at the 3 middle sections

keeping the material centered and evenly

tensioned.

2. Next, with one person at each side,

attach the left and right sides of the

material with the velcro bands, starting

with the 3 middle sections.

3. Leaving the corner sections for

last, attach the remainder of the top and

bottom material with the velcro bands,

using one person on each side to

maintain even tensioning and a

centered screen. .

Note:

Attach the bands on the left and right sides

as tightly as possible. This will provide the

tension required to make the screen material

flat.

042117DR www.elitescreens.com 5

Step 4: Final Assembly and Main Frame Support set up

1. Stand the frame upright, and rotate the legs (A) and (J) 90 degrees and insert the hexagonal screws. Secure

using the M6 hex nut (I) place.

2. Ensure the ring-stakes and guy rope are properly used to safely secure the screen to the ground during use.

3. Drive the Curved Stakes (G) through each hole on the ends of the legs.

4. Drive the Ring-Stakes (H) to the ground and attach a Guy-Rope on each side for additional support and

stability.

M6hexagonal screw

M6 hex nut

Legs A and J are to be

rotated 90 degrees.

4. Lastly, tightly attach the corner

sections of the material with the velcro

bands.Your screen should look like the

figure shown (to the left).

Note:

After all velcro bands are attached, check

each individual band for equal tension. If

needed, tighten the bands until desired

tensioning is achieved.

042117DR www.elitescreens.com 6

Warning Instructions

1. The Ring-Stake and Curved Stake should be properly driven into the ground to avoid the frame from

falling which could result in injury or permanent damage to the screen.

2. Always be cautious of strong windy conditions. We don’t recommend using over 20mph.

3. A soft terry cloth with mild soap and water may be used to clean the screen surface.

For a local Elite Screens contact or Technical Support, please visit

www.elitescreens.com

Ring stake

Curved Stake

Guy rope

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Elite Screens Projektionsfläche Handbücher

Elite Screens

Elite Screens Elite Home 2 Series Bedienungsanleitung

Elite Screens

Elite Screens F100XWH1 Bedienungsanleitung

Elite Screens

Elite Screens QuickStand Series Bedienungsanleitung

Elite Screens

Elite Screens EB100HW2-E12 Kurzanleitung

Elite Screens

Elite Screens Tab-Tension Series Bedienungsanleitung

Elite Screens

Elite Screens Manual Series Bedienungsanleitung

Elite Screens

Elite Screens ezFrame R180WH1 Bedienungsanleitung

Elite Screens

Elite Screens ezFrame Series Bedienungsanleitung

Elite Screens

Elite Screens M100VSR-PRO Bedienungsanleitung

Elite Screens

Elite Screens YardMaster Manual Series Bedienungsanleitung

Elite Screens

Elite Screens Evanesce AcousticPro UHD Series Bedienungsanleitung

Elite Screens

Elite Screens 2 CLR Series Bedienungsanleitung

Elite Screens

Elite Screens C Bedienungsanleitung

Elite Screens

Elite Screens Osprey Tension Dual Series Leitfaden

Elite Screens

Elite Screens EDGE FREE Aeon AcousticPro UHD Series Bedienungsanleitung

Elite Screens

Elite Screens TE100HC2 Bedienungsanleitung

Elite Screens

Elite Screens Yard Master Pro B Series Bedienungsanleitung

Elite Screens

Elite Screens GolfSim Bay Series Bedienungsanleitung

Elite Screens

Elite Screens Elite Vmax Series Bedienungsanleitung

Elite Screens

Elite Screens Elite Ez-Frame Series Bedienungsanleitung

Elite Screens

Elite Screens EVANESCE TAB-TENSION Series Kurzanleitung

Elite Screens

Elite Screens Insta-DEM Series Bedienungsanleitung

Elite Screens

Elite Screens CineTension2 Series Bedienungsanleitung

Elite Screens

Elite Screens Kestrel Series Kurzanleitung

Beliebte Projektionsfläche Handbücher anderer Marken

FART PRODUKT

FART PRODUKT Standard SCREEN Bedienungsanleitung

Draper

Draper E Series Handbuch

Laarhoven

Laarhoven Companion II Bedienungsanleitung

Renogy

Renogy RMS-LFPS-US Bedienungsanleitung

Da-Lite

Da-Lite ExecutiveElectrol Bedienungsanleitung

Samsung

Samsung S*H65* Bedienungsanleitung

FONESTAR

FONESTAR PPTR-43100-FA Bedienungsanleitung

Slide Clear

Slide Clear Varro XL Bedienungsanleitung

OS РХ-090Н Bedienungsanleitung

Niko

Niko 10-845 Bedienungsanleitung

Speaka Professional

Speaka Professional 2357532 Betriebsanleitung

Sima

Sima XL-72 Bedienungsanleitung

Jasic

Jasic EVO 2.0 ET-200P Bedienungsanleitung

InFocus

InFocus SC-WALL GRY-92H Handbuch

Barco

Barco OverView MVL-615 Bedienungsanleitung

Draper

Draper Envoy Handbuch

SI Dynamic 2 XL Bedienungsanleitung

Draper

Draper Nocturne+ E Montageanleitung