EPOX EP-MVP4F Bedienungsanleitung

TRADEMARK

All products and company names are trademarks or

registered trademarks of their respective holders.

These specifications are subject to change without notice.

Manual Revision 1.0

August 9, 1999

EP-MVP4FEP-MVP4F

EP-MVP4F

ISAISA

ISA/PCI Mainboard with Onboard AGP/PCI Mainboard with Onboard AGP

/PCI Mainboard with Onboard AGP/PCI Mainboard with Onboard AGP

/PCI Mainboard with Onboard AGP

VGA, PCI Audio, PCI IDE and SuperVGA, PCI Audio, PCI IDE and Super

VGA, PCI Audio, PCI IDE and Super

Multi-I/OMulti-I/O

Multi-I/O

EP-MVP4F

User Notice

No part of this product, including the product and software may be reproduced,

transmitted, transcribed, stored in a retrieval system, or translated into any

language in any form without the express written permission of EPoX Computer

Company (hereinafter referred to as EPoX) except for documentation kept by the

purchaser for backup purposes.

We provide this manual “as is” without warranty of any kind, either expressed or

implied, including but not limited to the implied warranties or conditions of

merchantability or fitness for a particular purpose. In no event shall EPoX be

liable for any loss of profits, loss of business, loss of use or data, interruption of

business or for indirect, special incidental, or consequential damages of any kind,

even if EPoX has been advised of the possibility of such damages arising from any

defect or error in the manual or product. EPoX may revise this manual from time

to time without notice. For updated BIOS, drivers, or product release information

you may visit our websites at http://www.epox.com or http://www.epox.com.tw.

Products mentioned in this manual are mentioned for identification purposes only.

Product names appearing in this manual may or may not be registered trademarks

or copyrights of their respective companies. The product name and revision

number are both printed on the mainboard itself.

Handling Procedures

Static electricity can severely damage your equipment. Handle the EP-MVP4F and

any other device in your system with extreme care and avoid unnecessary contact

with system components on the mainboard. Always work on an antistatic surface

to avoid possible damage to the mainboard from static discharge. Always have the

power supply unplugged and powered off when inserting and removing devices

within the computer chassis. EPoX assumes no responsibility for any damage to

the EP-MVP4F mainboard that results from failure to follow instruction or failure

to observe safety precautions.

CAUTION

The EP-MVP4F mainboard is subject to

damage by static electricity. Always

observe the handling procedures.

EP-MVP4F

Technical Support Services

If you need additional information, help during installation or normal use of this

product, please contact your retailer. Your retailer will have the most current

information about your configuration. If your retailer cannot help, you may visit

our online technical support website and/or contact our support technicians at the

locations listed below.

Record your serial number before installing your EP-MVP4F mainboard. (The

serial number is located near the PCI slots at the edge of the board.)

EP-MVP4F serial number: _________________________________

Contacting Technical Support

EPoX technical support is working hard to answer all of your questions online.

From our website you can find answers to many common questions, drivers, BIOS

updates, tech notes, and important technical bulletins. If you are still unable to

locate the solution you are seeking, you always have the option to contact our

support technicians directly.

North American website (English language)

http://www.epox.com

[email protected]

European website (Multi-language)

http://www.epox.nl

[email protected]

Taiwan website (Chinese language)

http://www.epox.com.tw

[email protected]

Thank you for using EPoX mainboards!

EP-MVP4F

Table of Contents

Section 1 Introduction

Components Checklist ............................................... 1-1

Overview

EP-MVP4F Form-factor ............................................ 1-2

I/O Shield Connector ................................................. 1-3

Power-On/Off (Remote)............................................ 1-3

System Block Diagram...............................................1-4

Section 2 Features

EP-MVP4F Features .................................................. 2-1

Section 3 Installation

EP-MVP4F Detailed Layout ...................................... 3-1

Easy Installation Procedure

Configure DIP Switch ................................................ 3-3

System Memory Configuration ................................. 3-5

Device Connectors ..................................................... 3-7

Section 4 Award BIOS Setup

BIOS Instructions ....................................................... 4-1

Standard CMOS Setup ................................................4-2

BIOS Features Setup .................................................. 4-3

Chipset Features Setup............................................... 4-8

Power Management Setup..........................................4-11

PNP/PCI Configuration ............................................. 4-14

Load Setup Defaults ................................................... 4-16

Integrated Peripherals ................................................ 4-16

Sensor and CPU Speed Setup..................................... 4-21

Change Supervisor or User Password .......................4-23

IDE HDD Auto Detection ..........................................4-24

EP-MVP4F

Save & Exit Setup ....................................................... 4-26

Exit Without Saving ....................................................4-26

Section 5 Appendix

Appendix A

Memory Map .............................................................. A-1

I/O Map ....................................................................... A-1

Timer & DMA Channels Map .................................... A-2

Interrupt Map .............................................................. A-2

RTC & CMOS RAM Map ........................................... A-3

Appendix B

POST Codes................................................................ A-5

Unexpected Errors ..................................................... A-8

Appendix C

Load Setup Defaults ................................................... A-9

Appendix D

GHOST 5.1 Quick User’s Guide................................ A-11

EP-MVP4F

Page Left Blank

IntroductionEP-MVP4F

Page 1-1

Section 1

INTRODUCTION

Components Checklist

üü

üA. (1) One mainboard

üü

üB. (1) One user’s manual

üü

üC. (1) Floppy ribbon cable

üü

üD. (1) ATA-66 IDE ribbon cable

üü

üE. (1) COM Port Connector

üü

üF. (1) Driver and utility

USER’S

MANUAL

EP-MVP4F

Introduction EP-MVP4F

Page 1-2

EP-MVP4F Form Factor

The EP-MVP4F is designed with MicroATX form factor - the new industry

standard of chassis. The MicroATX form factor is essentially a Baby-AT base-

board rotated 90 degrees within the chassis enclosure and a new mounting

configuration for the power supply. With these changes the processor is relocated

away from the expansion slots, allowing them all to hold full length add-in cards.

MicroATX defines a double height aperture to the rear of the chassis which can be

used to host a wide range of onboard I/O. Only the size and position of this

aperture is defined, allowing PC manufacturers to add new I/O features (e.g.; TV

input, TV output, joystick, modem, LAN, etc.) to systems. This will help systems

integrators differentiate their products in the marketplace, and better meet your

needs.

• Smaller size promotes a smaller system size.

• I/O shield does not need to be retooled in an ATX 2.01 or later. Mainboard

could be used in an ATX 2.01-compliant.

• A smaller power supply cam be used. High integration on mainboard reduces

the system costs.

Fulllength

slots

Expandable I/O

5 1/4"

Bay

3 1/2"

Bay

Figure 2: Summary of Micro ATX chassis features

CPU located near

Power Supply

Singlechassis

fan for

system

Micro

ATX

Power

Supply

ATX power

connector

Floppy / IDE

connectors

close to

peripheral

bays

IntroductionEP-MVP4F

Page 1-3

Case (chassis) Power

ON/OFF button

ATX

POWERSUPPLY

Figure 4: Simple ATX Power

ON/OFF Controller

Power-On/Off (Remote)

The EP-MVP4F has a single 20-pin connector for ATX power supplies. For ATX

power supplies that support the Remote On/Off feature, this should be connected

to the systems front panel for system Power On/Off button. The systems power

On/Off button should be a momentary button that is normally open.

The EP-MVP4F has been designed with “Soft Off" functions. You can turn Off

the system from one of two sources: The first is the front panel Power On/Off

button, and the other is the "Soft Off" function (coming from the EP-MVP4F’s

onboard circuit controller) that can be controlled by the operating system.

Windows 95/98 will control this when the user clicks that they are ready to

Shutdown the system.

I/O Shield Connector

The EP-MVP4F is equipped with an I/O back panel.Please use the appropriate I/O

shield (figure 3).

PS/2 Mouse

PS/2

KEYBOARD

COM1 VGA1

parallel port

Speaker

Joystick/Midi

USB port

Line_in

MIC

Figure 3

Introduction EP-MVP4F

Page 1-4

Figure 5: System Block Diagram

System Block Diagram

PAC

PCI Bridge

and memory

controller

VT82C501

socket 7

Processor

100/66 MHz

CRT

VT82C686A

I/O Bridge

USB 0 USB 1

AC97

CODEC

AMR Slot

Inhaltsverzeichnis

Andere EPOX Hauptplatine Handbücher

EPOX

EPOX EP-3C1A Bedienungsanleitung

EPOX

EPOX 3VBA Bedienungsanleitung

EPOX

EPOX F61 Bedienungsanleitung

EPOX

EPOX P55-TX 2 Bedienungsanleitung

EPOX

EPOX EP-BXBS Bedienungsanleitung

EPOX

EPOX EP-3VCA Bedienungsanleitung

EPOX

EPOX GXA486SPM Bedienungsanleitung

EPOX

EPOX nForce2 Ultra 400 Bedienungsanleitung

EPOX

EPOX P55-BT Bedienungsanleitung

EPOX

EPOX EP-6CXA2C Bedienungsanleitung

EPOX

EPOX EP-61BXC-A Bedienungsanleitung

EPOX

EPOX EP-61EXA-A Bedienungsanleitung

EPOX

EPOX P55-VP 2 Bedienungsanleitung

EPOX

EPOX MVP4A Bedienungsanleitung

EPOX

EPOX EP-MVP4G Bedienungsanleitung

EPOX

EPOX 6VBA Bedienungsanleitung

EPOX

EPOX EP-3WXM2 Bedienungsanleitung

EPOX

EPOX EP-LX370Y Bedienungsanleitung

EPOX

EPOX AMD Socket et A Processor based AGP (8X)... Bedienungsanleitung

EPOX

EPOX EP-6ZXM Bedienungsanleitung

EPOX

EPOX 8U1697 GLI Bedienungsanleitung

EPOX

EPOX BXB Bedienungsanleitung

EPOX

EPOX 6VBA-E Bedienungsanleitung

EPOX

EPOX 8KTA Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung

Epson

Epson S5U13700P00C000 Bedienungsanleitung