Epson II Bedienungsanleitung

EPSON

ACTION SCANNER

™

Color Scanner

Getting Started

for Windows

Printed on recycled paper

with at

least

20% post-Consumer content

A Note Concerning Responsible Use of

Copyrighted Materials

Like photocopiers, scanners can be misused by improper copying of copyrighted material.

Although Section 107 of the U.S. Copyright Act of 1976 (Title 17, United States Code), the

“fair use” doctrine, permits limited copying in certain circumstances, those circumstances

may not be as broad as some people assume. Unless you have the advice of a

knowledgeable attorney, be responsible and respectful by not scanning published material

without the permission of the copyright holder.

system, or transmitted in any form or by any means, electronic, mechanical, photocopying,

recording, or otherwise, without the prior written permission of Seiko Epson Corporation.

No patent liability is

assumed with respect to the use of the information contained herein.

Neither is any liability assumed for damages resulting from the use of the information

contained herein.

Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this

product or third parties for damages, losses, costs, or expenses incurred by purchaser or

third parties as a result of: accident, misuse, or abuse of this product or unauthorized

modifications, repairs, or alterations to this product.

Seiko Epson Corporation and its affiliates shall not be liable against any damages or

problems arising

from

the use of any options or any consumable products other than those

designated as Original EPSON Products or EPSON Approved Products by Seiko Epson

Corporation.

EPSON and EPSON Stylus are registered trademarks of Seiko Epson Corporation.

ActionScanner is a trademark of Epson America, Inc.

General notice: Other product names used herein are for identification purposes only and may be

trademarks of their respective companies. EPSON disclaims any and all rights in those marks.

1995 by Epson America, Inc.

Torrance, California, USA

9/95

Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

System and Memory Requirements . . . . . . . . . . . . . 2

Installing the Parallel Interface Card

.............

Configuring the Card

...................

Installing the Card

.....................

Setting Up the Scanner . . . . . . . . . . . . . . . . . . . . . 7

Connecting the Scanner to the Computer . . . . . . . . . .

Configuring Parallel Port LPT2 for Windows 95 . . . .

Installing the EPSON Scanning Utilities . . . . . . . . . . .

Installing Image-In . . . . . . . . . . . . . . . . . . . . . . . 13

Scanning Images . . . . . . . . . . . . . . . . . . . . . . . . 15

Putting It Together

.......................

Calibrating Your System

..................

Selecting the Correct Resolution

.............

iii

This package contains everything you need for professional

quality color scanning:

EPSON

ActionScanner

II color scanner, which scans in

full color (24 bit) or grayscale monochrome (8 bit) at

300 dpi (dots per inch)

Bidirectional parallel interface card, which provides an

additional parallel interface for your computer

Bidirectional parallel interface cable

EPSON Scanning Utilities (EPSON Scan! II and EPSON

TWAIN), which let you capture scanned images, export the

images in a variety of formats, calibrate your scanner, and

use the scanner’s advanced features with software

programs that support the industry standard TWAIN

interface

Image-In

Easy Pack, a combination image-editing, optical

character recognition (OCR), and file conversion program

that lets you edit and retouch color images, convert hard

copies into formatted text, and convert the files into a

variety of formats.

This booklet tells you how to set up your scanner, install the

software, and scan an image. If you need more detailed

information after you begin scanning, consult the individual

manuals for the ActionScanner II, EPSON Scanning Utilities,

and Image-In.

System and Memory Requirements

For the scanner hardware and software to work properly, your

system must include the following minimum configuration

listed below for either Windows 3.1 or Windows 95:

Microsoft

Windows

™

3.1 Requirements:

A 386-based (or higher) IBM

compatible computer or an

IBM PS/2

MS-DOS

version 5.0 or higher

Microsoft Windows 3.1

3.5-inch, high-density diskette drive

At least 100MB of free hard disk space for scanner

applications and images

8MB of system RAM plus a permanent Windows swap file

providing 8MB to 16MB of virtual memory (a swap file of

contiguous space on your hard disk drive which Windows

can use; see your Microsoft Windows manual)

Note:

8MB is the minimum amount of RAM; graphics applications run

faster and more efficiently with more RAM.

A mouse or other compatible pointing device

A Video Graphics Array (VGA) or other Windows

compatible display adapter card or built-in interface

supporting at least 256 colors; highquality, realistic color

scans require a card or interface supporting 16 million

colors

A color monitor compatible with the card or interface you

are using.

Windows 95 Requirements:

A 386-based (or higher) IBM compatible computer or an

IBM PS/2

MS-DOS version 5.0 or higher

Microsoft Windows 95

3.5-inch, high-density diskette drive

At least 100MB of free hard disk space for scanner

applications and images

8MB of system RAM

Note:

8MB is the minimum amount of RAM; graphics applications run

faster and more efficiently with more RAM.

A mouse or other compatible pointing device

A Video Graphics Array (VGA) or other Windows

compatible display adapter card or built-in interface

supporting at least 256 colors; highquality, realistic color

scans require a card or interface supporting 16 million

colors

A color monitor compatible with the card or interface you

are using.

Installing the Parallel lnterface Card

Follow the steps in this section if you need to install the

bidirectional parallel interface card in your computer. You may

also need to configure the card before you install it.

Some computers come with a built-in bidirectional parallel

interface. You do not need to install the parallel interface card if

your computer has a built-in interface that you are not

currently using. If you will connect the scanner to an existing

interface, skip to “Setting Up the Scanner” on page 7.

Note:

Standard (unidirectional) and bidirectional parallel interfaces look the

same but operate differently. Your scanner does not work with a

standard parallel interface, so check your computer manual to make

sure you have an unused bidirectional parallel interface before you

connect the scanner to it.

Configuring the Card

The parallel interface card contains jumpers that select the port

address (LPT1 or LPT2) and interrupt (IRQ5 or IRQ7) it uses.

You may need to change the jumper settings if there is a

conflict with your computer’s parallel port settings. See your

computer manual for information about the port address and

interrupt used by its parallel port.

The bidirectional parallel interface card default settings are:

Port address LPT2

Interrupt IRQ5.

Your computer’s parallel port probably uses LPT1 and a

different IRQ setting. However, if it uses LPT2 or IRQ5, follow

the steps in this section to change the interface card’s jumper

settings.

Carefully remove the interface card from its packaging,

holding it only by its top edges. Then place it on a flat,

clean surface.

Caution:

Avoid touching the components or the gold contacts on

the interface

card;

they can be damaged by static

electricity.

Locate jumpers Jl and J2 on the interface card, as shown

below.

Q”-oo;;’

o=“-

0000

The settings are printed on the circuit board next to the

jumpers. To change a setting, lift off the jumper cap and

reinstall it over the appropriate pair of pins.

Caution:

Be careful not to bend the jumper pins.

Follow these steps to install the card in your computer:

Turn off the computer and any peripheral devices.

Disconnect the computer’s power cable from the electrical

outlet and from the back panel. Also disconnect any other

cables, including the keyboard cable.

Remove the cover from your computer. If you need detailed

instructions, see your computer manual.

Before you touch any of the computer’s internal components,

touch an unpainted metal surface inside the computer case

to discharge any static electricity.

Choose an option slot for the interface card. You can install

the card in any available slot.

Remove the retaining screw from the option slot cover and

remove the slot cover. Keep the screw to secure the

interface card to the computer. Store the slot cover in a safe

place in case you remove the interface card later.

Insert the interface card into the slot, guiding it straight

down. Push the card down firmly (but carefully); you

should feel it fit into place.

Secure the card to the computer with the retaining screw.

Replace the computer’s cover, reconnect all the cables, and

plug the power cord into an electrical outlet.

Setting Up the Scanner

Follow these steps to set up the scanner:

Take the scanner out of its box and place it on a flat, stable

surface with the rear panel facing you.

Remove the tape securing the scanner cover and pull out

the paper underneath the cover.

Locate the round screw in the middle of the rear panel and

turn it counterclockwise. If necessary, use a coin to loosen it.

Remove the screw and push it into the storage hole marked

STOCK;

do not screw it in.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Epson Scanner Handbücher

Epson

Epson DS-70000 WorkForce DS-70000 Montageanleitung

Epson

Epson RR-60 Bedienungsanleitung

Epson

Epson 2480 - Perfection Photo Bedienungsanleitung

Epson

Epson Perfection 636 Bedienungsanleitung

Epson

Epson DS-C480W Bedienungsanleitung

Epson

Epson ES-300GS Bedienungsanleitung

Epson

Epson 4870 - Perfection Pro Abmessungen

Epson

Epson WorkForcePro GT-S50 Bedienungsanleitung

Epson

Epson ActionScanner ActionScanner II Bedienungsanleitung

Epson

Epson Grayscale Scanner Bedienungsanleitung

Epson

Epson Expression 10000XL Series Bedienungsanleitung

Epson

Epson Perfection 600 Bedienungsanleitung

Epson

Epson Perfection V33 Photo Bedienungsanleitung

Epson

Epson Perfection V330 Photo Bedienungsanleitung

Epson

Epson 1640SU - Perfection Photo Scanner Abmessungen

Epson

Epson PowerLite 1260 Bedienungsanleitung

Epson

Epson Perfection V350 Series Bedienungsanleitung

Epson

Epson Perfection 4870 Photo Bedienungsanleitung

Epson

Epson B11B248401 Bedienungsanleitung

Epson

Epson GT-10000 Bedienungsanleitung

Epson

Epson ES-300GS Bedienungsanleitung

Epson

Epson Perfection V200 Photo Bedienungsanleitung

Epson

Epson ES-600C Abmessungen

Epson

Epson DS-6500 WorkForce DS-6500 Bedienungsanleitung

Beliebte Scanner Handbücher anderer Marken

Plustek

Plustek Scanner Bedienungsanleitung

Z/I Imaging

Z/I Imaging PhotoScan 2001 Bedienungsanleitung

Renkforce

Renkforce DS100-5M Bedienungsanleitung

Image Access

Image Access WideTEK A2 Bedienungsanleitung

Canon

Canon imageFORMULA CR-120N Bedienungsanleitung

Fujitsu

Fujitsu FI-4860C2 Bedienungsanleitung

GeoSlam

GeoSlam ZEB Horizon Montageanleitung

Kodak

Kodak i5800 Scanner Bedienungsanleitung

Kodak

Kodak i7300 Bedienungsanleitung

Revopoint

Revopoint POP Bedienungsanleitung

Fujitsu

Fujitsu fi-4860C Bedienungsanleitung

Eddyfi Technologies

Eddyfi Technologies Floormap X Bedienungsanleitung

Faselase

Faselase F6 Bedienungsanleitung

Fujitsu

Fujitsu CardMinder Bedienungsanleitung

Uniden

Uniden BC340CRS Bedienungsanleitung

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Bedienungsanleitung

Mustek

Mustek PageExpress 4800 Pro Bedienungsanleitung

Optex

Optex 750830 Bedienungsanleitung