Ericsson EDACS DPE-100 Bedienungsanleitung

User’s Manual

EDACS®

Duplex Portable

DPE-100

ericssonz

NOTICE!

This manual covers Ericsson and General Electric

products manufactured and sold by Ericsson Inc.

NOTE!

Repairs to this equipment should be made only by an

authorizedservicetechnicianorfacilitydesignatedbythe

supplier. Any repairs, alterations or substitution of rec-

ommended parts made by the user to this equipment not

approved by the manufacturer could void the user’s

authority to operate the equipment in addition to the

manufacturer’s warranty.

This manual is published by Ericsson Inc., without any warranty.

Improvements and changes to this manual necessitated by typo-

graphical errors, inaccuracies of current information, or improvements

to programs and/or equipment, may be made by Ericsson Inc., at any

time and without notice. Such changes will be incorporated into new

editions of this manual. No part of this manual may be reproduced or

transmitted in any form or by any means, electronic or mechanical,

including photocopying and recording, for any purpose, without the

express written permission of Ericsson Inc.

The software contained in this device is copy-

righted by Ericsson Inc. Unpublished rights are

reserved under the copyright laws of the United

States.

NOTE

TABLE OF CONTENTS

INTRODUCTION . . . . . . . . . . . . . . . . . . 5

BASIC OPERATION . . . . . . . . . . . . . . . . 7

TURNING THE RADIO ON . . . . . . . . . . . . 7

PLACING AN INTERCONNECT CALL . . . . . . 8

Nobody Answers or You Hear a Busy or

Fast Busy Tone . . . . . . . . . . . . . . . . 10

Last Number Re-Dial . . . . . . . . . . . . . 10

A Call is Unsuccessful or a Call in Progress

is Interrupted . . . . . . . . . . . . . . . . . 10

ANSWERING A CALL . . . . . . . . . . . . . . 10

Unanswered call Counter . . . . . . . . . . 11

VOLUME CONTROL . . . . . . . . . . . . . . . 12

MUTE KEY . . . . . . . . . . . . . . . . . . . . 12

AIR TIME METER . . . . . . . . . . . . . . . . . 13

TURNING THE TELEPHONE OFF . . . . . . . . 13

DISPLAY, KEYPAD, AND AUDIBLE SIGNALS . . . 14

DISPLAY . . . . . . . . . . . . . . . . . . . . . 14

Alphanumeric Field . . . . . . . . . . . . . 14

Numeric Field . . . . . . . . . . . . . . . . 14

Status Indicators . . . . . . . . . . . . . . . 14

KEYPAD . . . . . . . . . . . . . . . . . . . . . . 15

MENU . . . . . . . . . . . . . . . . . . . . . . . . 16

Illumination . . . . . . . . . . . . . . . . . . 19

ALERTTONES . . . . . . . . . . . . . . . . . . . 20

EDACS APPLICATIONS . . . . . . . . . . . . . 20

AUDIBLE SIGNALS . . . . . . . . . . . . . . . . 22

Ringing Signal . . . . . . . . . . . . . . . . 22

Error Signal . . . . . . . . . . . . . . . . . 22

Malfunction Alarm Signal . . . . . . . . . . 22

ELECTRONIC LOCK AND CALL

RESTRICTIONS . . . . . . . . . . . . . . . . . . 22

SETUP LOCK CODE . . . . . . . . . . . . . . . 24

STORING NUMBERS . . . . . . . . . . . . . . . 24

STORING A NUMBER (AND NAME) . . . . . . . 25

MEMORY PROTECTION . . . . . . . . . . . . . 27

MEMORY FULL . . . . . . . . . . . . . . . . . . 28

TABLE OF CONTENTS (Continued)

RECALLING NUMBERS . . . . . . . . . . . . . . 29

Displaying Extended Digits . . . . . . . . . 29

Alpha Recall . . . . . . . . . . . . . . . . . 29

Recalling a Number by Entering the

Memory Location . . . . . . . . . . . . . . 30

Appending Digits to a Recalled Number . . 31

Changing a Recalled Number . . . . . . . . 31

SPEED CALLING . . . . . . . . . . . . . . . . 32

ERASING A STORED NUMBER . . . . . . . . 32

RECALLING A NUMBER DURING A CALL . . . 33

DTMF SIGNALING . . . . . . . . . . . . . . . . . 33

DTMF SIGNALING USING THE KEYPAD . . . . 33

Pause Before Sending DTMF Signals . . . 34

Pre-Programmed DTMF Signaling . . . . . 35

SYSTEM SELECTION . . . . . . . . . . . . . . . 36

ACCESSING USER MENU FUNCTIONS . . . . . 37

MENU FUNCTION DEFINITIONS . . . . . . . . 38

BATTERIES AND RECHARGING . . . . . . . . . 44

BATTERIES . . . . . . . . . . . . . . . . . . . 44

Battery Level Indicator . . . . . . . . . . . 44

Low Battery Alert . . . . . . . . . . . . . . 45

Care and Maintenance . . . . . . . . . . . 45

Rechargeable Battery Pack Disposal . . . . 46

Inserting and Removing a Battery . . . . . 47

RECHARGING . . . . . . . . . . . . . . . . . . 48

Using a Desk-Top Charger . . . . . . . . . 49

Restoring Battery Capacity . . . . . . . . . 50

APPENDIX 1 . . . . . . . . . . . . . . . . . . . . 51

FAULT TRACING . . . . . . . . . . . . . . . . . 51

No Power to the Radio . . . . . . . . . . . 51

SERV Indicator Does Not Come On . . . . 51

Received Signal is Weak . . . . . . . . . . 51

A Call Cannot be Placed . . . . . . . . . . 52

"KEYLOCK" Is Displayed . . . . . . . . . . 52

"LOCKED" Is Displayed . . . . . . . . . . . 53

INTRODUCTION

This manual describes how to use the DPE-100

Portable Radio. The DPE-100 is a synthesized, micro-

processor-based, high performance duplex portable FM

radio providing reliable two-way communications in En-

hanced Digital Access Communications System

(EDACS) trunking environments.

Duplex is provided in EDACS systems while operat-

ing in the Telephone Interconnect Mode. In an EDACS

trunked environment the user selects a communications

system.In this mode, channel selection is transparent to

the user and is controlled via digital communication with

the system controller. This provides advanced program-

mable features and fast access to communication chan-

nels.

Theexactoperationoftheradiodependsontheradio

mode,theoperatingmode,theradio’sprogramming,and

the particular radio system. Most features described in

this manual may be enabled or disabled through pro-

gramming. Consult the system administrator for the re-

quired features to be programmed into the radio.

BASIC OPERATION

TURNING THE RADIO ON

ETurntheradioonbyholdingdownthe

keyuntilyouhear abeep.

The display illumination comes on. All the status

indicators and all the segments in the alphanumeric and

numeric fields in the display will flash 3 times.

The radio’s LID number is displayed briefly.

A battery level indicator is shown in the upper right

corner of the display. This can be a value from B0 to B5

in proportion to the battery’s voltage level. You can read

more about this in the chapter

Batteries and Recharg-

ing

OnceserviceisavailablefromanEDACSsystem,the

SERV (Service) indicator comes on, together with a

signal strength meter and the CC SCAN goes off in the

display. This meter indicates the relative signal strength

by displaying from 0 to 5 "bars" ,with the number of bars

being proportional to the signal strength.

Own Logical ID Battery Level IndicatorSystem Indicator

Note the following points:

•If the SERV indicator does not come on, you have

lost contact with the EDACS system and cannot,

therefore, place or receive any calls. Refer to

Appendix 1 for further information.

•If no signalstrength is shown, try movingthe radio

to obtain a stronger signal. Refer to Appendix 1

for further information.

PLACING AN INTERCONNECT CALL

1. Enter the desired number on the numeric keys.

The digits are shown in the display.

If you enter a wrong digit or a wrong number:

Erase a wrong digit by pressing the

key

momentarily. You may delete all wrong digits

individually like this, or eliminate all entered dig-

its by holding the

key for approximately 1

second.Ifyouarenotinacall,pressingthe

key will also delete all entered digits.

Signal strength meter

2. Whenyouhaveenteredthenumber,press

The text "

DIALING

" shows in the display and

the symbol comes on.

When you have made contact with the EDACS

system, "

DIALING

" will disappear.

The number dialedwill remain inthedisplay until

any key is pressed, or the call is ended, at which

time the minutes and seconds of the call will be

displayed.

The left two digits show minutes, and the right

two digits show the seconds (separated by two

dashes).

3. When the conversation is finished, press

Nobody Answers or You Hear a Busy or Fast Busy

Tone

Press

. The telephone number will be re-

tained in the memory and you can easily repeat

the call.

Last Number Re-Dial

MPress

, then

to scroll to the

RE-

CALL

function. Then press

, the word

LAST DIAL

will appearandthelastdialed

number will be displayed. Press

placethecall.

The last number called will remain in the

memory even though the radio is turned

off.

A Call is Unsuccessful or a Call in Progress is

Interrupted

An error signal (a short beep) is heard. Observe the

signal strength indication in the display. The signal

strength should be at least 1. Refer to Appendix 1 for

further information.

Andere Handbücher für EDACS DPE-100

Inhaltsverzeichnis

Andere Ericsson Tragbares Radio Handbücher

Ericsson

Ericsson M-PA SELECT Bedienungsanleitung

Ericsson

Ericsson LBI-38823D Bedienungsanleitung

Ericsson

Ericsson Monogram Series MGP 450 Bedienungsanleitung

Ericsson

Ericsson EDACS DPE-100 Bedienungsanleitung

Ericsson

Ericsson AEGIS EDACS M-PA Narrowband 9600 Bedienungsanleitung

Ericsson

Ericsson EDACS M-RK-II SCAN Bedienungsanleitung

Ericsson

Ericsson KPC-300 Bedienungsanleitung

Ericsson

Ericsson M-PATM SERIES LBI-38377E Bedienungsanleitung

Ericsson

Ericsson Monogram Series Bedienungsanleitung

Ericsson

Ericsson MDX SERIES Bedienungsanleitung

Ericsson

Ericsson KPC-300 Betriebsanleitung

Ericsson

Ericsson Voice Guard M-Pa SCAN Bedienungsanleitung

Ericsson

Ericsson EDACS IPE SERIES Bedienungsanleitung

Ericsson

Ericsson PORTABLE FM RADIO Bedienungsanleitung

Ericsson

Ericsson EDACS M-RK I Bedienungsanleitung

Ericsson

Ericsson GE-MARC VE MDR Bedienungsanleitung

Ericsson

Ericsson KPC-300 Bedienungsanleitung

Ericsson

Ericsson AEGIS EDACS M-PA LBI-33056 Bedienungsanleitung

Ericsson

Ericsson RRUS 13 Bedienungsanleitung

Ericsson

Ericsson LZT-1872R1A Bedienungsanleitung

Ericsson

Ericsson AEGIS FDMRTS M-PA NARROWBAND 9600 Bedienungsanleitung

Ericsson

Ericsson LBI-38732E Bedienungsanleitung

Ericsson

Ericsson M-PA EDACS Bedienungsanleitung

Ericsson

Ericsson AEGIS M-PA Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung