•
When using the machine in wet rooms (e.g. in the
bathroom) only connect it to sockets which are
connected in series with a ground fault circuit in-
terrupter. In case of doubt, consult an electrician.
•
Periodically examine the power cord and machi-
ne for damage. If any damage is found, do not use
the appliance but contact your service centre for
repair.
•
Should extension cables be used, ensure that these
lay on dry surfaces and protected against water jets.
•
Before vacuuming liquids, check the oat functions
correctly. When vacuuming liquids, and when the
tank is full, a oat closes the suction opening, and the
vacuum operation is interrupted. Then switch o the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (oat)
and examine it for signs of damage.
•
If the equipment should overturn it is recommended
that the machine should be stood up before switching
o.
•
If foam or liquid escape from the appliance, switch o
immediately.
•
The equipment should not be used to pick up wa-
ter from containers lavatories, tubs, etc.
•
Aggressive solvents or detergents should not be
used.
•
Service and repairs must be carried out by qualied
personnel only. Only use manufacturer original spare
parts for service repair.
•
The manufacturer cannot be held responsible for
any damage/injury caused to persons, animals or
property caused by misuse of the appliance, not in
compliance with manual instructions.
USAGE
(see g.
③④⑤⑥
)
IMPORTANT: Clean the lter from time to time in order
to ensure that the vacuum cleaner continues to per-
form optimally (and environment).
• Be sure that switch is in o position (0) OFF and con-
nect the machine to a suitable socket.
• The machine must be always kept on horizontal ba-
ses, in a safe and stable way.
• Insert the suitable lters for the proper use.
• Select the lter O according to g.
③
for dry suction.
• Select the lter Paccording to g.
④
for liquid suc-
tion.
BLOWER FUNCTION :
Select the lter Oaccording to g.
⑤
for blower fun-
ction.
•
Never use the appliance without lters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (-) ON position in order to start the ma-
chine.
• (see g.
⑥
)
Pneumatic lter shaker C
:
If there should
be a reduction in the suction power, operate the
lter reset buton
C
several times to reset the lter .
• When job is over, switch o (0) OFF and keep away
the plug from the socket.
• If the appliance is used with especially ne dust
(size below 0.3 µm) the lter supplied will require
cleaning more frequently. For especially deman-
ding applications, the use of specic lters sup-
plied as an optional (Hepa) may be necessary.
CARE AND MAINTENANCE
The unit is maintenance-free.
•
The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
•
Warning
Do not use abrasives, glass or universal cleaners! Never
immerse the appliance in water.
• Clean the appliance and accessory parts made of pla-
stic with a commercial plastic cleaner.
• If required, rinse the container and accessories with
water properly and dry them before reuse.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry
safe place, out of the reach of children.
FILTER CLEANING
•
The machine shall be disconnected from its power
source, by removing the plug from the socket-outlet,
during cleaning or maintenanc.
1- Remove the lter P ,O.
2- Shake the lter P ,O.
•
Once the lter has been cleaned, check whether it is
suitable for further use. If it has been damaged or bro-
ken, replace it with an original lter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and are cov-
ered against manufacturing defects in accordance with
applicable regulations. The warranty is eective from
the date of purchase.
9
