Extron electronics EWB 212 Bedienungsanleitung

IMPORTANT:

Go to www.extron.com for the

complete user guide

, installation

instructions, and specifications.

EWB 212 • Installation Guide

Overview

The Extron EWB 212 is an EU two-gang external wall box that

provides complete compatibility in t and nish with Extron EU

devices and assists with cable management. The diagram to the

right shows a typical application.

This guide provides basic instructions for installation by an

experienced installer.

Equipment Needed but not Provided

• Stud detector • Cable raceway (optional)

• Electric drill • Fasteners for wall mounting

(see Recommended Fasteners

table on the following page)

• Screw driver

• Small wire cutters

Mounting the EWB 212

The EWB 212 can be mounted directly to the wall or to an EU junction box. Use the

mounting holes shown in the diagram below.

Insert for #6

Hex Screw

Insert for M3

Grounding Scr

Mounting Holes

for EU Junction Box (2)

(60 mm center to center)

EWB 212 Rear View

Wall Mounting

Holes (4)

Device

Mounting Holes (4)

use M3 screws

Knockout Covers

The EWB 212 is often used with a surface raceway (not provided). The wall box has gaps in

the top, bottom, and both sides to accommodate a raceway from any direction. The back

of the EWB 212 has four covers that can be used to ll gaps that are not used (see the

diagrams to the right).

1. Use small wire cutters to cut the plastic attaching the knockout cover to the wall box.

2. Ensure the knockout cover is in the correct orientation and slide it into place.

NOTE: The larger knockout covers (for the top and bottom) have smaller

knockouts nested inside for running a small raceway to the top or bottom of

the wall box.

Grounding

Holes are available for M3 and #6 grounding hex screws and nuts (see the diagram above).

The screws and nuts are not provided.

Use small wire

cutters to re

move

knockout cover.

se sm

utters t

Slide knockout

cover onto slots.

lide kn

over o

OFF

VIDEO

VOL

OFF

VIDEO

VOL

MLC 55 RS EU

EWB 212

68-2875-01 A

02 16

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

Extron Europe

+800.3987.6673

(Inside Europe Only)

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.299.1800

+971.4.299.1880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

Inside India Only

+91.80.3055.3777

+91.80.3055.3737 FAX

EWB 212 • Installation Guide (Continued)

Installation

Preparing the EWB 212

1. Based on where the wall box and cables will run, remove the knockout covers and insert them into the unused gaps on the

top, bottom, or sides of the wall box (see Knockout Covers on the previous page).

Mount the EWB 212 directly to the wall or to an existing in-wall EU junction box.

Wall Mounting

Recommended fasteners

The EWB 212 can be mounted to any convenient place on a wall, using the appropriate fasteners (not provided).

Wall Type Fastener Minimum Size

Fastener

Quantity Drill Bit Size Notes

Dry wall Toggle bolts 3/16 inch at least 2 1/2 inch Wall thickness 3/8 inch minimum

Solid wood Wood screws #6 at least 2 1/8 inch Wall thickness 3/8 inch minimum

Masonry Masonry screws 3/16 inch at least 2 5/32 inch masonry bit Do not mount to masonry joints.

1. If required, locate the center of a wall stud and hold the wall box

where it will be mounted.

2. Mark the position of the four wall mounting holes (for the

dimensions, see the gure to the right).

3. Select a suitable fastener (see the Recommended Fasteners

table above) and drill the holes, as recommended in the table.

4. If required, insert a grounding screw (not provided. See

Grounding on the previous page).

5. Secure the wall box to the wall.

6. If required, install a cable raceway to manage the cables.

Mounting to an Existing In-wall EU Junction Box

1. Align the mounting holes of the wall box with the two holes in the EU junction

box (60 mm center to center).

2. Secure the wall box to the junction box, using M3 screws (not provided).

Completing the Installation

1. Run and connect cables to the device (see the device user guide).

2. Mount the device using M3 screws.

1.97" (5.0cm)

0.69" (1.75cm)

1.1"

(2.79cm)

3.94" (10.0cm)

)

79cm)

Wall mounting holes (4)

(diameter 0.19" [0.48 cm])

MLC 55 RS EU

EWB 212

WB 212

RESET

OFF

EWB 212

EU Box

212 M3 mounting holes (4)

Inhaltsverzeichnis

Andere Extron electronics Gehäuse Handbücher

Extron electronics

Extron electronics HSA 822M Bedienungsanleitung

Extron electronics

Extron electronics PVM 220 Bedienungsanleitung

Extron electronics

Extron electronics Cable Cubby 500 Bedienungsanleitung

Extron electronics

Extron electronics NBP 1200C Bedienungsanleitung

Extron electronics

Extron electronics EBP 1200C Bedienungsanleitung

Extron electronics

Extron electronics SMB 110 Series Bedienungsanleitung

Extron electronics

Extron electronics Cable Cubby 300C Bedienungsanleitung

Extron electronics

Extron electronics CCD 220 Bedienungsanleitung

Extron electronics

Extron electronics HSA 400 Series Bedienungsanleitung

Extron electronics

Extron electronics HSA 200SE Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 401 Bedienungsanleitung

Extron electronics

Extron electronics Cable Cubby 300S Bedienungsanleitung

Extron electronics

Extron electronics MediaLink MLM-WB+ Bedienungsanleitung

Extron electronics

Extron electronics Hideaway HSA 200C Series Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 401 Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 1600 Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 1600 Bedienungsanleitung

Extron electronics

Extron electronics HSA 822 Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 401 Bedienungsanleitung

Extron electronics

Extron electronics Cable Cubby F55 Edge Bedienungsanleitung

Extron electronics

Extron electronics PowerCage 411 Series Bedienungsanleitung

Extron electronics

Extron electronics TLM 100 T Bedienungsanleitung

Extron electronics

Extron electronics HSA 822MS Handbuch

Extron electronics

Extron electronics CS 120P Bedienungsanleitung

Beliebte Gehäuse Handbücher anderer Marken

SilentiumPC

SilentiumPC Armis AR5 Handbuch

Pulsar

Pulsar 17/TRP80/DSPR Bedienungsanleitung

Thermaltake

Thermaltake V150 TG Bedienungsanleitung

MSI

MSI MPG SEKIRA 500X Bedienungsanleitung

Antec

Antec Dark fleet DF-10 Bedienungsanleitung

Nexans

Nexans WTC05 Bedienungsanleitung

Peavey

Peavey DS 1502 Bedienungsanleitung

D-Link

D-Link ShareCenter Pro DNS-1550-04 Bedienungsanleitung

Rosewill

Rosewill RX82-U(JBOD) Bedienungsanleitung

QNAP

QNAP SAS JBOD CLI 1.0 Bedienungsanleitung

GAMDIAS

GAMDIAS Talos P1 Bedienungsanleitung

Auvs

Auvs KR615 Bedienungsanleitung

Digitus

Digitus DA-71114 Bedienungsanleitung

CommScope

CommScope FDH 3000 Bedienungsanleitung

FS FHD-FWME4 Bedienungsanleitung

JBL

JBL CS1215T Bedienungsanleitung

Pulsar

Pulsar ARAD-S4 Bedienungsanleitung

Pulsar

Pulsar AWO454 Bedienungsanleitung