Geemarc AMPLICALL 150 Bedienungsanleitung
0
Portable Alert Receiver
Récepteur d’alerte portatif
Tragbarer Warnempfänger
English P2
Français P8
Deutsch P15
1
2
Please refer to our website: www.geemarc.com for an up to date
user guide, as there may be important updates and changes you
need to be aware of.
PACKAGE CONTENTS
The AMPLICALLTM150 box contains the following items:
1 Base station AC150 (AMPLICALLTM150)
1 charging cradle
1 rechargeable battery (pre-installed)
1 AC/DC power adaptor
1 UK and 1 VDE plug adaptors
1 user’s manual
1 set (8 pcs) alarm icon stickers
DESCRIPTION
Reset Button
Function Switch
Speaker
Zone Indicator
Battery status Indicator
Charging Docking
3
UK plug
VDE plug
AC/DC adaptor (with Type C plug)
Belt-Clip
Battery Cover
Battery Compartment
Power Switch
Type C socket
4
SWITCH ON/OFF
The receiver built-in a replace lithium polymer battery. When
using for the first time, you need to turn on the power switch
inside the battery cover ON ( I).
When not used for a long period, it is recommended to turn
the switch to the OFF ( O) position.
Loosen the screw
with a small phillips
screwdriver.
Connect the
battery and slide
the switch to on
position.
Close the battery
cover and tight the
screw with the
screwdriver.
BATTERY CHARGING
5
Charging with Docking – Connect the type C USB plug to
the docking, put the AC150 receiver to the docking.
Charging without Docking – Drect connect the type C USB
plug to the AC150 receiver unit.
Battery low indicator – If a zone LED light is blinking every
10 S, it indicates the battery is low for this transmitter. You
must recharge the battery as soon as possible.
PAIRING & ALARM MELODY
To pair a new device, please follow these steps:
1.Enter pairing mode for the AC150.
Press & hold the LEARNING button (●) for
3 seconds. The LED in zone #1 will flash.
2.Press the LEARNING button (●) again to
move to the zone you wish to pair with.
Press the melody selection () button to
scroll through the melodies. Once you hear a melody you
like, do not press any button during the melody.
3.Once the zone and melody are selected, press one time on
device (AC101,AC110,AC140) button to pair. If successful,
the AMPLICALL150 will generate two short tones.
4.Press the LEARNING button (●) to exit the pairing mode;
the system is now ready to use.
Battery status indicato
r
Charging
Mode Standby
Mode
LED Light Charging
LED OFF Full Normal
LED Blink
each 10S Local
Battery Low
6
Remove and transmitter of the AC150 memory
First, press and hold the (●) button for 3 seconds to enter
the pairing mode.
Press the (●) button to move to the zone which is to be
deleted.
Press and hold the(●) and ( ) buttons together for 3 seconds
The receiver will generate a tone to indicate the transmitter of
this zone has been deleted.
CHANGE THE MELODY IN DESIERD ZONE
First, press and hold the (●) button for 3 seconds to enter
the pairing mode.
Press the (●) button to move to the zone then press the ( )
button to select the melody required.
Press the (●) button until the pairing mode is exited.
USING
When the AC150 receives a trigger signal, it will play a melody
and vibrating (depend on the Alarm setting position). The zone
LED will light to show which sensor is triggered. The Zone LED
will keep lighting until the reset button is pressed..
GUARANTEE
From the moment your Geemarc AMPLICALLTM150 is purchased,
Geemarc guarantee is for the period of two years. During this
time, all repairs or replacements (at our discretion) are free of
charge. Should you experience a problem then contact our help
line or visit our website at www.geemarc.com. The guarantee
does not cover accidents, negligence or breakages to any parts.
The product must not be tampered with or taken apart by anyone
who is not an authorized Geemarc representative. The Geemarc
guarantee in no way limits your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE
AND MUST BE RETAINED AND PRODUCED IN THE EVENT
OF A WARRANTY CLAIM.
7
Please note: The guarantee applies to the United Kingdom
only.
DECLARATIONS:
UKCA Directives
Geemarc Telecom SA hereby declares that this AMPLICALLTM150
is in compliance with the essential requirements and other relevant
provisions of the Radio Equipment Directive 2014/53/UE.
The UKCA declaration of conformity may be consulted at
www.geemarc.com
RF power : < 250mW
Recycling Directives
The WEEE (Waste Electrical and Electronic Equipment) has been
put in place for the products at the end of their useful life are
recycled in the best way.
When this product is finished with, please do not put it in your
domestic waste bin. Please use one of the following disposal
options:
- Remove the batteries and deposit them in an appropriate WEEE
skip. Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a new
one, they should accept it. Thus if you respect these instructions
you ensure human health and environmental protection.
For product support and help visit our website at www.geemarc.com
telephone 01707 387602
lines are open 09h00 to 16h00 Mon to Fri
2 Rue Galilée, Parc de l’Etoile, 59791 GRANDE-SYNTHE Cedex,
FRANCE
This product is made in China To Geemarc Telecom
8
Veuillez consulter notre site Web: www.geemarc.com car il peut y
avoir des mises à jour importantes et changement dont vous devez
être conscient.
CONTENU DU PAQUET
La boite de l’AC140 contient les éléments suivants:
1 station de base AC150 (AMPLICALLTM150)
1 support de chargement
1 batterie de recharge (pré-installée)
1 adaptateur CA/CC
1 adaptateur de prise britannique et 1 adaptateur de prise
VDE (européen)
1 guide d’utilisation
1 jeu (4 pièces) d'autocollants pour les icônes d'alarme
DESCRIPTION
Bouton de réinitialisation
Interrupteur type d'alarme
Haut-Parleur
Indicateur de zone
d’alarme
Indicateur d’état de la
batterie
Support de chargement et
de connexion
9
Fiche Anglaise
Fiche Française
Adaptateur CA/CC (avec prise
de type C)
Clip de ceinture
Couvercle du
compartiment batterie
Compartiment batterie
Interrupteur
Marche/Arrêt
Prise de type C
Inhaltsverzeichnis
Sprachen:
Andere Geemarc Empfänger Handbücher
