• Never use this device on animals or people
• Never point the UVC bulb toward any part of the body or eyes
• Do not handle this device with wet hands
• Do not leave device unattended while on
• Do not place device on wet surfaces
• Do not get device wet or submerge in water
• Use UV resistant eye protection when using this device (not included)
• It is a violation of federal law to use this device in a manner inconsistent with its labeling or
instructions
• If this device is no longer working properly, has been dropped or damaged in any way, or
left outdoors, do not use
• Do not directly expose this device to an open flame or other heat source
• Handle device with care to prevent breakage
• This device uses AA batteries only (not included). DO NOT use rechargeable batteries with
this device
• Remove batteries before cleaning. Wipe clean with soft cloth
• Always remove batteries when not using device for an extended period of time
• Always replace weak or dead batteries
• Battery acid and leakage can cause personal injury and damage to the device and
surroundings. If leakage occurs, thoroughly wash infected areas. Keep battery acid away from
eyes, ears, nose and mouth. Immediately wash all clothing, objects and surfaces that have
contact with leaked battery acid. Leaking batteries may make popping sounds
• Batteries must be disposed of properly. Consult your local waste authority regarding disposal
options and recycling
• This device is for use to sanitize surfaces only. It is not meant to be used to disinfect air
• When not in use, store in a cool, dry place
• THIS DEVICE IS NOT A TOY. KEEP OUT OF THE REACH OF CHILDREN
This Portable UVC Surface Sanitizer is not a medical device. It is for sanitizing only.
This device cannot keep users from getting sick and cannot be used to treat any
illness
Sanitize Everything, Everywhere!
Remove the battery compartment cover by sliding toward bottom of wand. (Fig1)1.
2. Insert 4 AA batteries. Do NOT use rechargeable batteries. (Fig2)
3. Replace cover.
4. To turn on, press power button. You will hear a beep sound and the light above the button
will turn blue. The UVC bulb will turn on. (Fig3)
5. Hold wand bulb side down ½ inch or as close as possible to surface to be disinfected.
7. Press the power button to turn the wand off. You will hear a beep and the blue light will
turn off. (Fig4)
8. Whenever possible, to conserve battery life, power the wand by using the
USB power cable. See below for instructions
a. Plug cable into the
bottom of the wand.
b. Plug into USB power source or into an electrical
outlet using an adapter (not included).
c. Go to steps 4 – 7
above.
6. Very slowly, move wand back and forth across the surface for 10 – 15 seconds or longer
when possible. Never rotate the wand so the bulb faces up.
Instructions for Use
Warnings
Where to Use
CAUTION
WARNING
WARNING
Never look at the UVC light or shine on skin. Direct, prolonged exposure of eyes or skin to the UVC
bulb can cause serious skin burns and eye inflammation.
The UVC bulb in this device contains trace amount of mercury, a chemical known to the state of
California to cause birth defects or other reproductive harm. For more information go to
www.p65warnings.ca.gov
•Countertops
•Tables and chairs
•Desks and accessories
•Computer keyboard
•Car interior
•Toilet and handle
•School desks
•Airplane seats, armrests and
seatback tables
•Door knobs-handles
•Stair railings
•Light switches
•Restaurant tables
•TV remote
•Keys
•Credit cards
•Phones
•Toys
•Baby bottles
and pacifiers
•Grocery bags
•Delivery boxes
•Mail
•Jewelry
•Makeup brushes,
sponges
Fig1
Fig2
Fig3
Fig4
