GFA ELEKTROMAT KE 20.24-40,00 Bedienungsanleitung

Installation Instructions

ELEKTROMAT

KE 20.24-40,00

Model: 10002232 10813

-en-

Status: 19.01.2022

GfA ELEKTROMATEN GmbH & Co. KG

Wiesenstraße 81

D-40549 Düsseldorf

www.gfa-elektromaten.de

[email protected]

Table of contents

1General safety information .............................................................................................. 4

2Technical data ................................................................................................................ 6

3Mechanical installation .................................................................................................... 7

4Electrical installation ..................................................................................................... 12

5Limit switch setting ........................................................................................................ 13

6Motor connection .......................................................................................................... 14

7Alternative motor connection ......................................................................................... 14

8Limit switch connection ................................................................................................. 15

9Emergency manual operation (hand chain operator) ..................................................... 16

10Completing commissioning / inspection ......................................................................... 18

11Disposal ........................................................................................................................ 20

12Declaration of incorporation / Declaration of conformity ................................................. 21



Symbols

Warning - Potential injury or danger to life!

Warning - Danger to life from electric current!

Note - Important information!

▶ Requirement - Required action!

Schematic representations are based on product examples. Deviations from delivered

products are possible.

1General safety information

Specified use

The drive unit is intended for vertically moving doors. The force is transmitted using a

chain. Doors that must be secured against dropping require a separate safety brake.

The drive unit must be protected against moisture and aggressive environmental

conditions (such as corrosive substances). The drive units are only suitable for indoor use.

Appropriate protective measures must be taken for outdoor installation. The drive unit is

not intended for hazardous areas. The values specified in the technical data of the drive

unit must not be exceeded. The safe operation can only be ensured if used as specified.

Target audience of these installation instructions

These installation instructions are geared towards qualified persons trained in the handling

of door systems. Expert knowledge, relevant skills and practical experience are what set

apart qualified persons. They are capable of safely carrying out the tasks involving

installation, maintenance and modernisation according to the instructions.

Safe operation

The safe operation of the product can only be ensured if it is used as specified. Follow the

installation instructions. Observe all specifications, especially warnings, when installing the

product in the overall system. GfA is not liable for damage resulting from non-observance

of the installation instructions. The resulting overall system must be reassessed for its

safety in accordance with applicable standards and directives (e.g. CE marking). These

installation instructions refer only to a part of the overall system and are not sufficient as

the sole instructions for the overall system. The installer of the system must prepare the

instructions for the overall system. We recommend entering the danger area of the system

only when the drive unit is at a standstill.

Warning - Failure to follow these installation instructions may result in severe injury or death.

Please read these instructions before using the product.

Keep these instructions handy.

Include these instructions when passing on the product to third parties.

Warning - Danger from improper use of the product!

Do not let children operate the product unsupervised or use as a toy.

Warning - Danger to life from incorrect installation!

Work carried out improperly may result in death or severe injury from electrical

current or falling parts.

Allow only competent people to carry out the work.

Disconnect all cables from the power supply.

Observe valid regulations and standards.

Use suitable tools.

Warning! Danger to life from falling objects if the drive unit is subjected to

impermissible forces.

Inadmissible forces (examples: collision with a forklift, dropping the drive unit, tearing

or pulling on the motor) lead to damage to the drive unit. There is a risk of severe

injury or death from falling objects.

Prevent impermissible forces from acting on the drive unit,

Check the drive unit for damage if impermissible forces have acted on it. Look

even for minor damage. Lock the door during the inspection.

Contact the service department if you have difficulty assessing the damage.

2Technical data

Designation Unit

Output speed 24 rpm

Output torque 200 (200) 1) Nm

Output / hollow shaft 40,00 mm

Series SG 85 -

Limit switch range

(maximum revolutions of the output / hollow shaft)

40 -

Supply voltage 3~ 400 V

Operating current 1,80 A

Operating frequency 50 Hz

Power factor cos φ 0,51 -

Safety circuit 24 V

Degree of protection IP 65 -

Temperature range -10 / +40 (+60) 2) °C

Operating sound pressure level < 70 dB(A)

Maximum output speed OPEN / CLOSE

for frequency inverter operation

42 / 42 min-1

Cycles per hour 9 (2,7)1) h-1

Max. holding torque 200 Nm

Braking torque 9 Nm

Braking voltage 103-130 V DC

Rectifier type EGR 230/103 -

Manual force emergency manual operation 187 N

1) Specification in ( ) according to EN 60335-2-103.

2) When using a temperature range of +40°...+60°C use half of maximum cycles per hour.

3Mechanical installation

Prerequisites

The permissible loads on walls, fastenings, mountings and transmission elements must not

be exceeded, even for maximum holding torques or locking torques (▶ refer to technical

data).

Connection elements

▶ Self-locking connection

elements with a minimum

strength of 800 N/mm2

(8.8) must be used.

▶ Utilize the hole diameter

to the full.

▶ Use adequately

dimensioned washers for

elongated holes.

BAGAB00002_Z002 BAGAB00003_ Z002

3 : 1

Permissible mounting positions

BAGAC03202_Z001

Transmission elements

▶ Install the chain wheel

properly.

▶ Position the chain wheels

properly.

▶ Tighten the chain wheel

properly.

BAGAB00021_Z001

BAGAB00022_Z001

Mounting

Four elongated holes are provided for mounting.

BAGAD03202_Z001

13.5

Installation

The descriptions below apply to general door specifications. The specifications of the door

manufacturer must also be observed during installation.

Warning - Potential injury or danger to life!

During installation, be sure to use a lifting device that has a sufficient load-

carrying capacity.

▶ Thoroughly grease the output-shaft.

BAGAE01201_Z001

▶ Install (①) and secure (②) the chain

wheel. Do not tighten yet. Install (③) and

secure (④) the output-shaft on the right or

left.

BAGAE03206_Z001

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere GFA Toröffner Handbücher

GFA

GFA 10003997 10013 Bedienungsanleitung

GFA

GFA ELEKTROMAT KE 40.40 FU-40,00 Bedienungsanleitung

GFA

GFA SG 50 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 10.100 FU-25,40 Bedienungsanleitung

GFA

GFA 10002479 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 9.20 WS-25,40 Bedienungsanleitung

GFA

GFA 10002367 10012 Bedienungsanleitung

GFA

GFA 10003871 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 7.32 WS-25,40 Bedienungsanleitung

GFA

GFA 10003690 10001 Bedienungsanleitung

GFA

GFA ELEKTROMAT KE 9.60 FU-25,00 Bedienungsanleitung

GFA

GFA ELEKTROMAT SI 75.10-55,00 Bedienungsanleitung

GFA

GFA 10003805 00012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 5.24 WS-25,40 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 22.24-30,00 Bedienungsanleitung

GFA

GFA 10003424 10012 Bedienungsanleitung

GFA

GFA 10003917 10012 Bedienungsanleitung

GFA

GFA 10003826 10012 Bedienungsanleitung

GFA

GFA 10003831 10012 Bedienungsanleitung

GFA

GFA 10003697 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT KE 60.45 FU-55,00 Bedienungsanleitung

GFA

GFA 10004010 10013 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 14.21-25,40 ER Bedienungsanleitung

GFA

GFA ELEKTROMAT FT 80.5 FU-45,00 Bedienungsanleitung

Beliebte Toröffner Handbücher anderer Marken

CAME

CAME FROG-PM4 Bedienungsanleitung

SOMFY

SOMFY FX230 Bedienungsanleitung

Aprimatic

Aprimatic ONDA 500 Bedienungsanleitung

Turnstiles

Turnstiles FSW 900 Bedienungsanleitung

Erreka

Erreka BUL BL33 Betriebsanleitung

Erreka

Erreka VULCAN S Bedienungsanleitung

Beninca

Beninca R1-2 WBV Bedienungsanleitung

Erreka

Erreka VULCAN D Bedienungsanleitung

Motorline professional

Motorline professional FORT Bedienungsanleitung

Beninca

Beninca BOB5024 Bedienungsanleitung

AGA

AGA GATEMASTER 900 HD Bedienungsanleitung

Cardin

Cardin BL Series Bedienungsanleitung

Westfalia

Westfalia 85 27 06 Bedienungsanleitung

CAME

CAME F500 Bedienungsanleitung

Extel

Extel VERA Bedienungsanleitung

Comunello Automation

Comunello Automation ABACUS 220 Bedienungsanleitung

CAME

CAME FA40230CB Bedienungsanleitung

Mighty Mule

Mighty Mule 200 E-Z GATE OPENER UL325 SERIES Bedienungsanleitung