Grandway OFI-3 Bedienungsanleitung

User's Guide to the OFI-3

Optical Fiber Identifier

English Version

OFI-3

User's Guide to the OFI-3

Optical Fiber Identifier

CONTENTS PAGE

1 Introduction

2 Warranty

2.1 One Year Limited Warranty

2.2 Exclusions

2.3 Returning Product

2.4 Contact us

3 Safety Information

4 Preparing for Operation

4.1 Unpacking the instrument

4.2 Battery

5 Operation

5.1 Controls and connectors

5.2 Powering on the instrument

5.3 Traffic detecting

5.4 Frequency detecting

5.5 Signal intensity

5.6 Self-calibrating

6 Specifications

7 Maintenance

OFI-3 / Introduction

1 Introduction

The OFI-3 optical fiber identifier is an inexpensive, portable

instrument designed to identify optical test tones and live

traffic without disconnecting live system. By simply

clamping the OFI-3 onto a fiber, the instrument will indicate

if there is a signal, or traffic and show the signal direction. It

can detect a variety of optical tones, 270Hz, 1KHz and

2KHz.

The OFI-3 is recommended for both 0.25 mm bare fiber,

0.9mm tightly buffered fiber and 2/3mm jacket fiber. When

testing jacket fibers, the slim design of the OFI-3 allows

easier access to a splice tray where the amount of

workspace is limited. The clamping trigger is designed to fit

the natural motion of the operator’s hand. The instrument is

ruggedly constructed and reliable to use.

OFI-3 / Warranty

2 Warranty

One Year Limited Warranty

Grandway products are warranted against the defective components and workmanship for a period

of one year from the date of delivery to the original customer. Any product found to be defective

within the warranty period would be returned to Grandway authorized service center for repair,

replacement and calibration.

Exclusions

The warranty on your equipment shall not apply to defects resulting from the following:

Unauthorized repair or modification

Misuse, negligence, or accident

Returning Product

To return product, you may contact Grandway to obtain additional information if necessary.

To serve you better, please specify the reasons for the return.

All delivery and mails should be sent to the following address:

Grandway Customer Service

6F, Xin'an building No. 99 Tianzhou Road

Shanghai, 200233 P.R. China

Tel: 0086-21-54451260/61/62/63

Fax: 0086-21-54451266

E-mail: overseas@grandway.com.cn

Website: www.grandway.com.cn

OFI-3 / Warranty

OFI-3 / Safety Information

3 Safety Information

Never look directly into optical outputs or a fiber while the equipment is on.Invisible laser beam

may damage your eyes.

Do not short-circuit the terminal of AC adapter / charger and the batteries.Excessive electrical

current may cause personal injury due to fumes,electric shock or equipment damage.

Connect AC power cord with the equipment and wall socket properly. While inserting the AC plug,

make sure there is no dust or dirt on the terminals and both plugs are fully seated. Incomplete

engagement may cause fuming, electric shock or equipment damage and may result in personal

injury.

Do not operate the equipment near hot objects, in hot environments, in dusty/ humid atmosphere

or when condensation is present on the equipment. This may result in electric shock , product

malfunction or poor performance.

Warnings!

OFI-3 / Preparing for Operation

4 Preparing for Operation

4.1 Unpacking the instrument

Packing material

We suggest that you keep the original packing material. Using the original packing material is your

guarantee of protecting the instrument during transit.

Checking the package contents

The standard accessories of OFI-3 are as follows:

Main unit User's Guide

Plungers 2*1.5V Alkaline Batteries

Carrying Case Quality Check Report

Checking for damage in transit

After unpacking the instrument, check to see whether it was damaged in transit. This is particularly likely

if the outer casing is clearly damaged. If there is damage, do not attempt to operate the instrument or to

repair it without authorization. Doing so can cause further damage and you may lose your warranty

qualification.

4.2 Battery

The OFI-3 instrument is powered by two 1.5V AA batteries. There is a “Low” battery indicator on the

panel board. It turns on if there is not enough power to supply the instrument. That is when you should

replace the battery with a new one. To replace the battery, please remove the battery plate on the back

side of the instrument with a screwdriver.

Note: 1 It is advisable to use 1.5V alkaline batteries. The Low Battery Indicator may light up if you use

rechargeable batteries.

2 To eliminate the possibility of acid leakage, please take out the batteries if the unit is not used for a

long time.

OFI-3 / Preparing for Operation

OFI-3 / Operation

5 Operation

5.1 Controls and connectors

5.1.1 Front (Panel Board)

Key / Indicator

Plunger

Fiber Groove

PD Headstock

No Signal Indicator

Left Traffic Indicator

Right Traffic Indicator

Signal Intensity Indicator

2kHz Indicator

1kHz Indicator

270Hz Indicator

Low Battery Indicator

Adjusting Key

Note

Three available types: H0.25mm, H0.9mm, H3.0mm.

A slot to place tested fiber.

Lights up if there is not a signal in tested fiber.

Lights up if the signal in tested fiber is from right to left.

Lights up if the signal in tested fiber is from left to right.

To show the signal intensity level. The higher, the stronger.

Lights up if the wave frequency is 2kHz.

Lights up if the wave frequency is 1kHz.

Lights up if the wave frequency is 270Hz.

Lights up when there is not enough power.

Self-calibrates.

H2.0mm,

No.

AD JUS T

Inhaltsverzeichnis

Andere Grandway Messgerät Handbücher

Grandway

Grandway FHS2T01F Bedienungsanleitung

Grandway

Grandway FHO1000 Bedienungsanleitung

Grandway

Grandway FIM-7 WiFi Bedienungsanleitung

Grandway

Grandway FHS2D02 Bedienungsanleitung

Grandway

Grandway FHP1A Bedienungsanleitung

Grandway

Grandway 6200 Bedienungsanleitung

Grandway

Grandway FHO1000 Bedienungsanleitung

Grandway

Grandway FHS1D02 Bedienungsanleitung

Grandway

Grandway F2H FHO5000 Bedienungsanleitung

Grandway

Grandway VLS-8-10 Bedienungsanleitung

Grandway

Grandway FHO2000-D26 Bedienungsanleitung

Grandway

Grandway FHP2A04 Bedienungsanleitung

Grandway

Grandway FHO2000 OTDR Bedienungsanleitung

Grandway

Grandway Optical Instruments Series Bedienungsanleitung

Grandway

Grandway FHO1500 Bedienungsanleitung

Grandway

Grandway FHP3P01 Bedienungsanleitung

Grandway

Grandway FHP2P01 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

ELMETRON

ELMETRON CP-511 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

EXFO

EXFO FTB-2 Bedienungs- und Wartungshandbuch

Keysight

Keysight M8290A Bedienungsanleitung

ADTEK

ADTEK MW-5 Bedienungsanleitung