Hasbro Star Wars Clone Wars Ultimate Lightsaber... Bedienungsanleitung

Product and colors may vary.

TM & ® denote U.S. Trademarks. P/N 6769590000

Not suitable for children

under 3 years because of

small parts - choking hazard.

AGES 6+

87625/87623 Asst.

FCC Statement:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy, and, if not installed and used

in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

BATTERIES REQUIRED

1.5V AA/R6 size

Alkaline batteries recommended.

Phillips/cross head screwdriver (not

included) needed to insert batteries.

NOT INCLUDED

BATTERIES REQUIRED

1.5V AA/R6 size

Alkaline batteries recommended.

Phillips/cross head screwdriver (not

included) needed to insert batteries.

NOT INCLUDED

Blade

Hilt

Tonfa handleEnd caps

Kyber crystals (3)

Hilt sleeves (4) Sleeve rings (3)

Blade-emitter guard

PARTS STEP 1

The first step in building a lightsaber is to

install the power-generating component.

Using a Phillips/crosshead

screwdriver (not included),

loosen screw in door and

remove door. Insert 3 x 1.5v

“AA” or R6 size batteries

(not included) into hilt.

INSTALLING BATTERIES

Alkaline batteries

recommended.

Replace battery door

and tighten screw.

STEP 2

Install one or more crystals

into the chamber in the hilt.

Each crystal causes the lightsaber

to emit a different sound. After you

complete your lightsaber, you can

always switch, add or remove crystals.

CRYSTAL

Store the extra crystals

in the storage chamber.

Note: If the crystals become

misplaced or lost, turn the power

on and off (see “Power Up” section

below) to cycle through the

different blade colors and sounds.

Color Chart:

Red: red crystal

Blue: blue crystal

Green: green crystal

Aqua: blue and green crystals

Orange: red and green crystals

Purple: red and blue crystals

CAUTION:

TO AVOID BATTERY LEAKAGE

1. Be sure to insert the batteries correctly and always follow the

toy and battery manufacturers’ instructions;

2. Do not mix old and new batteries or alkaline, standard

(carbon-zinc) or rechargeable (nickel-cadmium) batteries;

3. Always remove weak or dead batteries from the product.

IMPORTANT:BATTERY INFORMATION

Please retain this information for future reference.

Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified

and be sure to insert them correctly by matching the + and – polarity

markings.

2. Do not mix old batteries and new batteries, or standard (carbon-zinc)

with alkaline batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical interference,

move it away from other electrical equipment. Reset (switching off and

back on again or removing and re-inserting batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of

battery. Always remove from the product before recharging. Recharge

batteries under adult supervision. DO NOT RECHARGE OTHER TYPES

OF BATTERIES.

CUSTOMIZE

The above steps are the basic steps for building

a lightsaber. Switch and combine the parts to

customize your lightsaber!

NOTE: Some configurations will cover the power

button. Please be sure that the power button is

exposed when completing your configuration.

POWER UP

Practice your dueling skills! Press the

button to “power up” your lightsaber.

When customizing your lightsaber, always make sure

the button is exposed so that you can “power up”!

STEP 3

Place blade on hilt and hold it in place.

STEP 4

Choose a sleeve ring and slide it over the blade.

STEP 5

Choose a hilt sleeve and slide it on the hilt.

NOTE: When customizing your lightsaber, always make

sure the button is exposed so that you can “power up”!

STEP 6

Choose an end cap and attach it to the hilt.

NOTE: Line up rib inside sleeve with slot on hilt.

BLADEHILT

SLEEVE RING

SLEEVE

END CAP

Congratulations! You have assembled your lightsaber!

FINISHED

ASSEMBLING CHARACTER-SPECIFIC LIGHTSABERS

Count Dooku Lightsaber

Yoda Lightsaber

Mace Windu Lightsaber

Maris Brood Lightsaber

Red

Green

Red

Blue

Green

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hasbro Spielzeug Handbücher

Hasbro

Hasbro Transformers: Rise of the Beasts Movie Beast Alliance Beast Weaponizers 2-Pack Optimus... Bedienungsanleitung

Hasbro

Hasbro GI Joe Voice FX Duke Bedienungsanleitung

Hasbro

Hasbro Toad Double Bubble Bedienungsanleitung

Hasbro

Hasbro Trans Formers 83808 Bedienungsanleitung

Hasbro

Hasbro Power Rangers Dino Fury Zord Link Bedienungsanleitung

Hasbro

Hasbro Disney Princess Comfy Squad Bedienungsanleitung

Hasbro

Hasbro Ghostbusters Ecto-Plasm Lab Playset Bedienungsanleitung

Hasbro

Hasbro 60153/60151 Bedienungsanleitung

Hasbro

Hasbro My Little Pony Bedienungsanleitung

Hasbro

Hasbro PlayDoh Animal Bucket 22454 Bedienungsanleitung

Hasbro

Hasbro Cinderella Musical Castle 10119 Bedienungsanleitung

Hasbro

Hasbro Air Surfer Bedienungsanleitung

Hasbro

Hasbro Transformers 83758 Bedienungsanleitung

Hasbro

Hasbro My Little Pony F3883 Bedienungsanleitung

Hasbro

Hasbro Disney FROZEN Bedienungsanleitung

Hasbro

Hasbro Play-Doh Buzz 'n Cut Barber Shop Bedienungsanleitung

Hasbro

Hasbro FurReal friends Cuddles My Giggly Monkey... Bedienungsanleitung

Hasbro

Hasbro Electronic Splat 'n Sound 21877 Bedienungsanleitung

Hasbro

Hasbro Disney/Pixar TOY STORY AND BOYOND Squad Leader... Bedienungsanleitung

Hasbro

Hasbro Trivial Pursuit 41039 Bedienungsanleitung

Hasbro

Hasbro NERF POWER MOVES MARVEL SPIDER-MAN Bedienungsanleitung

Hasbro

Hasbro Mustafar Final Duel Playset 85243 Bedienungsanleitung

Hasbro

Hasbro Play-Doh Kitchen Creations Magical Oven Bedienungsanleitung

Hasbro

Hasbro Playskool 31943 Bedienungsanleitung

Beliebte Spielzeug Handbücher anderer Marken

marklin

marklin 37321 Bedienungsanleitung

Canon

Canon PAPER CRAFT Bedienungsanleitung

GREAT PLANES

GREAT PLANES Pitts M-12S Bedienungsanleitung

NOCH

NOCH 14261 Bedienungsanleitung

Hausler

Hausler 450 SE V2 Bedienungsanleitung

Dynaflite

Dynaflite Daydream Bedienungsanleitung

Kenner

Kenner Batman 63651 Bedienungsanleitung

LEGO

LEGO 8527 Bedienungsanleitung

Multiplex

Multiplex EasyStar II Bedienungsanleitung

iKarus

iKarus ECO 8 Bedienungsanleitung

Walkera

Walkera 38 Bedienungsanleitung

MD MXION SWD Bedienungsanleitung

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Bedienungsanleitung

marklin

marklin 39671 Bedienungsanleitung

LEGO

LEGO TECHNIC 8735 Bedienungsanleitung

Mattel

Mattel HOTWHEELS DWL04 Bedienungsanleitung

REVELL

REVELL Bristol Beaufighter TF.X Bedienungsanleitung

Ravensburger

Ravensburger 3D Puzzle La Tour Eiffel Bedienungsanleitung