VARIO-PERGOLA
INSTALLATION INSTRUCTIONS
Helioscreen Australia Pty Ltd
Page 10
Art.-Nr.: 930059 © by WO&WO Literal mistakes and technical changes excepted Valid from February 2010
Page 10
InstallatIon InstructIons
Pergoline
2.9. mounting the DiStanCe tube(S):
2.10. a lignment oF the SyStem
• Alignthesystembymovingthecasinginthebracketsor
sideways movement of the two posts in the diagonal.
Deviations of the diagonal measurements by more than
5 mm may result in malfunctions.
• Verticallyaligntheposts
To stabilise the parallelism of the system, mount at least
one distance tube before aligning the system at the post.
• Insertthewasherandturnthedistancetubeholderinto
the end cap of the distance tube until it is fully in.
• Alignthetighteningsurfacesofbothholders.
• Securetheholdersintheguiderailswithscrewsand
hammerhead threaded plates.
The writing on the hammerhead threaded plates must
point towards the surface of the holder.
• Thepositiondependsontheextendedlengthofthe
system.Uptoanextendedlengthof3500mmnearthe
posts, from 3501mm extended length distributed evenly
over the length of the guide rails.
Thepositionofthedistancetubescanalsobeadjusted
to the cross seams of the fabric.
• Distributeadditionaldistancetubesoverthelength
of the guide rails.
To fasten the distance tube holders, push the screws with
the hammerhead threaded plates up and twist (as described
in 2.8.). Ensure that the hammerhead threaded plates have
twisted correctly in the installation channel.
• Aftertightening,thelongerdiagonalmustbecrosswise
to the clamping channel of the guide rail (see drawing
next to the text).
• Lockthenutsagainsttheendcapsofthedistancetube.
parallelism rear
parallelism front
diagonal
diagonal
2.8.MOUNTINGTHEDISTANCETUBE(S):
i •Tostabilisetheparallelismofthesystem,mountat
least one distance tube before aligning the system at
the post.
•Insertthewasherandturnthedistancetubeholder
into the end cap of the distance tube until it is fully in.
•Alignthetighteningsurfacesofbothholders.
•Securetheholdersintheguiderailswithscrewsand
hammerhead threaded plates.
i •Thewritingonthehammerheadthreadedplates
must point towards the surface of the holder.
•Thepositiondependsontheextendedlengthofthe
system.Uptoanextendedlengthof3500mmnear
theposts,from3501mmextendedlengthdistributed
evenly over the length of the guide rails. The position
ofthedistancetubescanalsobeadjustedtothe
cross seams of the fabric.
•Distributeadditionaldistancetubesoverthelengthof
the guide rails.
i •Tofastenthedistancetubeholders,pushthescrews
with the hammerhead threaded plates up and twist
(asdescribedin2.8.).Ensurethatthehammerhead
threaded plates have twisted correctly in the
installation channel.
•Aftertightening,thelongerdiagonalmustbe
crosswise to the clamping channel of the guide rail
(seedrawingnexttothetext).
•Lockthenutsagainsttheendcapsofthedistance
tube.
