Hobby King Katana EPP-30E Bedienungsanleitung

Instructions Manual

Many thanks to choosing our 3D

stunt plane. We hope you have

many hours of enjoyment flying

it..

While opening the package, please check whether all the components are complete. If

anything is missing, please contact the dealer immediately.

Specifications:

Wingspan

Fuselage length

Wing area

Takeoffweight

Center of gravity:108mm back from the leading edge next to the fuselage

Recommended power configuration:

Motor: Shuangtian 3542/950kv exodeviation brushless motor

Electronic tuning: Haoying40A

Battery

Propeller

Servos

Flight precautions

Do not fly in following circumstances:

1. In bad weather conditions such as strong winds, poor visibility and rain.

2. Where there is strongelectromagnetic interference such as near high-tension lines

3. Near high buildings, trees or street lamps.

4. Without guidanceof an experienced person if you have never flown before.

5. Attention: Model airplanesare not toys,you are fully responsible for the safety of the flight.

Storage precautions:

1. The battery must be removed from the airplane before storing in case of fire.

2. When storing the model it is best to hang it on a rack from its propeller.

Attention: Due to continuous updating of products there may be some tiny differences between the

instruction book and the actual product.

Recommended control throws:

Ailerons: 3D flying 40 degrees/Normal flying 25 degrees.

Elevator: 3D flying 40 degrees/Normal flying 25 degrees.

Rudder: 3D flying 50 degrees/Normal flying 25 degrees.

Installation of the motor mount.

Slot the motor mount into the slots

of the fuselage, Glue in place with

medium CA adhesive.

Install the elevator servo in the

direction shown above. Screw into

place with 2 x PK screws.

As shown above place the steel wire

undercarriage into the slot.

Screw into place the undercarriage

securing plate. Note: There is 1 extra

securing plate supplied as a spare in

the kit..

Make slots in the ailerons and wing

trailing for the hinges, glue in place with

a medium CA. Ensure you leave a small

gap to allow the aileron to move freely

without binding.

Install the aileron horn as

shown using medium CA

adhesive.

Install the aileron servo mount

and servo as shown in the picture

above.

Fit and glue in place the elevator hinges

(Note: It is recommended to keep a 1mm gap

between the elevator and tailplane so that the

elevator can move freely without binding.)

Insert the wings either side of

the fuselage and feed the ailerons

servo leads through into the

receiver compartment.

As shown in the picture, tension

the wing hookswith a rubber band

and wrap around about 3 times.

Please ensure the wing peg is

located properly for safety.

As shown above slide the

elevator and then the tailplane

through the fuselage.

Also ensure that the tailplane

is parallel with the wing and

vertically inline with the fuselage.

Install the rudder control horn as

shown with a medium CA adhesive

As shown in the picture install

the elevator control horn,glue into

position with medium CA glue.

As shown above ensure the

tailplane is perfectly centered and

square to the wing and fuselage. When

measured as above both measurements

should be the same.

Glue the tailplane into place

using medium CA or appropriate

foam glue.

As shown in the picture, install the

rudder and glue the hinges in position

with CA adhesive.(Note: Please leave a

gap of about 1mm to allow the rudder to

move without binding. )

Trim out the EPP foam from

the motor cowling.

As shown in the picture install

the wheelsand wheel covers,the

epp foam sheet for the

undercarriage legs can be glued on

using medium CA or foam glue.

Fit the propeller and spinner

as shown, ( a propeller must be

purchased separately).

Fit the cowling as shown, slot

the ply locaters into the fuselage and

ensure

it is firmly pushed home.

Install the motor speed

controller in the position shown.

Install the elevator pushrod as

shown in the picture.

Connect the ESC and the servo's to the

receiver and check that everything is

working properly and that the controls

work it the correct direction.

Next install the aileron push

rods as shown.

Components for the carbon

landing gear.

As shown in the picture install

the wheel covers over the wheels,

screw the undercarriage tothe

fuselage.

Andere Hobby King Spielzeug Handbücher

Hobby King

Hobby King J3 CUB Bedienungsanleitung

Hobby King

Hobby King Maestro-46 Bedienungsanleitung

Hobby King

Hobby King 12A BEC Bedienungsanleitung

Hobby King

Hobby King YAK54 20CC EP Bedienungsanleitung

Hobby King

Hobby King Airoso F3A Bedienungsanleitung

Hobby King

Hobby King WARGO YAK55 Bedienungsanleitung

Hobby King

Hobby King Yak54EP-49in Bedienungsanleitung

Hobby King

Hobby King Libero Kurzanleitung

Hobby King

Hobby King Breeze Bedienungsanleitung

Hobby King

Hobby King Gulfstream G500 ARF Bedienungsanleitung

Hobby King

Hobby King B-17 F Bedienungsanleitung

Hobby King

Hobby King wing wing z-84 Bedienungsanleitung

Hobby King

Hobby King Raven 990 MINI DLG 2017 Bedienungsanleitung

Hobby King

Hobby King Typhoon -EP Bedienungsanleitung

Hobby King

Hobby King Mig-15 EDF Bedienungsanleitung

Hobby King

Hobby King YAK 54 EP ARF Bedienungsanleitung

Hobby King

Hobby King Mariposa Trainer Bedienungsanleitung

Hobby King

Hobby King Li13der-EP Bedienungsanleitung

Hobby King

Hobby King Assault 100 Bedienungsanleitung

Hobby King

Hobby King DragonFly EDF Bedienungsanleitung

Hobby King

Hobby King EXTRA260P Bedienungsanleitung

Hobby King

Hobby King MiG-15 Bedienungsanleitung

Hobby King

Hobby King Micro SU-27 Bedienungsanleitung

Hobby King

Hobby King TRAINSTAR Bedienungsanleitung

Beliebte Spielzeug Handbücher anderer Marken

marklin

marklin 37321 Bedienungsanleitung

Canon

Canon PAPER CRAFT Bedienungsanleitung

GREAT PLANES

GREAT PLANES Pitts M-12S Bedienungsanleitung

NOCH

NOCH 14261 Bedienungsanleitung

Hausler

Hausler 450 SE V2 Bedienungsanleitung

Dynaflite

Dynaflite Daydream Bedienungsanleitung

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Handbuch

Kenner

Kenner Batman 63651 Bedienungsanleitung

LEGO

LEGO 8527 Bedienungsanleitung

iKarus

iKarus ECO 8 Bedienungsanleitung

Multiplex

Multiplex EasyStar II Bedienungsanleitung

Walkera

Walkera 38 Bedienungsanleitung

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Bedienungsanleitung

MD MXION SWD Bedienungsanleitung

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Bedienungsanleitung

marklin

marklin 39671 Bedienungsanleitung

Meccano

Meccano 15103 Bedienungsanleitung

LEGO

LEGO TECHNIC 8735 Bedienungsanleitung