Hobot 268 Bedienungsanleitung

HOBOT-268/288 Window Cleaning Robot

User’s Manual

- 1 - HOBOT Technology Inc.

publication may be reproduced, transmitted, transcribed, stored in a retrieval

system or translated into any language or computer language, in any form or by

any means, electronic, mechanical, magnetic, optical, chemical, manual or

otherwise, without the prior written permission of this company.

Trademarks

All other logos, products, or company names mentioned in this manual may be

the registered trademarks or copyrights of their respective companies, and are

used for informational purposes only.

Technical support

If any problems occur and this manual cannot provide the solution you need,

please contact a local retailer or local authorized dealer.

Disclaimer

HOBOT Technology Inc. makes no claims or warranties, either expressed or

implied, with respect to the contents hereof and specifically disclaims any

warranties, tradability or suitability for any particular purpose. Furthermore,

HOBOT Technology Inc. reserves the right to revise this publication and to make

changes from time to time in the contents hereof without obligation of this

company to provide notification of such revisions or changes.

The user should follow the instructions provided in this user manual, but is

ultimately responsible for assessing placement and safety when using this glass

cleaning tool.

- 2 - HOBOT Technology Inc.

Important Safety Precautions

Read all instructions before operating this device.

WARNING

1. Fasten the safety rope and tie to an indoor fixture before operating the device.

2. Check if the safety rope is broken or the knot is loose before operating the

device.

3. A power cord must be used for the HOBOT to function properly.

4. For windows with no balcony, a warning area must be established on the

ground below to prevent people from coming near it.

5. The battery must be fully charged (green light ON) before using.

6. Do NOT use on rainy or humid days.

7. Turn power on before putting device onto glass.

8. When placing the appliance onto glass, make sure it sticks to the surface

before removing the supporting hand.

9. Remove the device before turning the power off.

10.Make sure to put the cleaning cloth onto the device correctly to avoid air

leakage.

11.Do NOT use on frames with non-rectangular (rounded) edges.

12.Do not spray or pour water onto the appliance.

13.Prohibit children from using this device.

14.Remove any obstructions on the glass. Do not use on cracked glass. Reflective

or coated glass may be scratched during operation by dirt on the glass.

15.Keep hair, loose clothing, fingers, and all body parts away from the openings

and moving parts.

16.Do not use in areas containing flammable or combustible liquids or gases.

- 3 - HOBOT Technology Inc.

Product Description

HOBOT-268/288 is a square-shaped window-cleaning robot with a vacuum

motor inside that uses suction to stick to glass surfaces. The device also has two

caterpillar wheels that can freely traverse window surfaces, and even walls. The

easily-replaceable lint-free cloth is used on the pad. Micro-fiber cloth is used to attain

superior glass cleaning.

An embedded UPS (Uninterrupted Power System) can prevent the robot from

falling off the window even when the power is off.

There are two advanced sensors added for enhancing HOBOT’s cleaning

performance and tightening its security while it works on framed and even frameless

windows. The pressure sensor monitors air leakage and the laser sensor detects the

edge of windows.

HOBOT has AI Technology that can calculate paths, auto-detect window edges,

and auto-clean entire windows. It also features a mode for manual operation.

Specifications

Product size

240mm x 240mm x 100mm (LWH)

(9.5 in x 9.5 in x 3.9 in)

Product weight

1.2Kg (2.65 lbs)

Gift box size

340mm x 255mm x 125mm (LWH)

(13.4 in x 10.0 in x 4.9 in)

Gift box total weight

2.35Kg (5.18 lbs)

Input Voltage

100~240VAC, 50Hz~60Hz

Adapter output

Minimum 24V/3.0A

Power consumption

72W

AC power cord length

1.0m (3.3 feet)

DC power cord length

4.0m (13.1 feet)

Safety rope length

4.5m (14.8 feet), Stength:150Kgf

Battery

Li-Po, 4x3.7 V

Battery working time

20 minutes

Battery life

2 years

Cleaning speed

2.4 min/ m2(14.5 sec/ feet2)

(Cleaning the entire area twice)

Noise

64dB

Maximum cleaning area

Height: 6m (19 feet), Width: 5m (16 feet)

- 4 - HOBOT Technology Inc.

Product and accessories

Device x 1

Remote controller x 1

Adapter (100~240VAC, 50~60Hz) x 1

AC power cord x 1

DC power extension cord (4 meters or 13 feet) x 1

Microfiber dry-cleaning cloth x 3

Microfiber polishing cloth x 3

Safety rope x 1

User manual x 1

Product features

Designed for any thickness glass

AI Technology HB268 V1.0

Cleaning speed: 2.4 min/m2(14.5 sec/ feet2).

3 kinds of automatic operation modes for cleaning the entire window

Stops automatically upon completion of cleaning.

Embedded UPS (Uninterrupted Power System)

Applicable to frameless windows (Laser sensor detects edges of windows)

Anti-falling control algorithm

Auto-detects edges of window

Microfiber cloth

High-strength safety rope (tensile strength 150Kgf) and buckle

Remote control

Power consumption: 72W

Input voltage: 100~240VAC, 50~60Hz

- 5 - HOBOT Technology Inc.

Getting to know the device

Step 1. Preparing

(1) Do not use device on rainy or humid days.

(2) For windows with no balcony, a warning area must be established on the

ground below to prevent people from coming near it.

(3) Check to see if the safety rope is broken or if the knot is loose.

(4) Fasten the safety rope and tie to an indoor fixture before operating if

clean outside of higher floor window.

Safety rope & buckle

DC power jack

Vent

Green light: full-charged

Hanging hole

Power-switch

Caution sticker

Blue light: Indicates

normal status

Red light: Indicates

abnormal status

Orange light: charging

Vent

Handle

Buzzer

Remote receiving window

2-Laser Sensor

Cleaning cloth

Blue LED, Red LED

Remote receiving window

2-Caterpillar wheel

Suction area

- 6 - HOBOT Technology Inc.

Step 2. Connect power cord to HOBOT correctly.

Step 3. Make sure the battery is fully charged (green light ON) before use:

(1)First, turn off the power switch on the device. Plug it into a power source.

Orange light ON means charging.

(2)Green light ON means the battery is fully charged.

Step 4. Make sure to put the cleaning cloth onto the device correctly to avoid air

leakage.

Step 5. Put the device onto glass.

(1) Turn power switch on make sure fan is running.

(2) Put device onto glass and keep 10cm (4 in) away from the window frame.

(3) Check if device is sticking to the glass before releasing it.

Step 6. Auto mode or manual mode operation.

(1) Operate HOBOT by remote controller. There are 3 kinds auto mode (,

, ) that could automatically clean whole window.

(2) Press

to stop device running.

(3) Press , , , to manually control device moving.

Step 7. Finish and remove the device from glass.

(1) While device is running, hold the safety rope with one hand and take

device down from glass with the other hand.

(2) Remove the device to a safe area, then turn it off.

Put cleaning cloth onto device correctly

(1) HOBOT has 2-laser sensors for detecting glass edge. These laser sensors

can not be covered by cleaning cloth like as shown.

(2) Put cleaning cloth onto device flatly and do not let cloth cover the caterpillar

wheel and laser sensors.

2-laser sensor

Caterpillar wheel

- 7 - HOBOT Technology Inc.

How to clean caterpillar belt

When the device easily slips on the surface of the window, it is because belts are

stained with accumulation of dust and water after each use. It is highly

recommend cleaning caterpillar belts before putting the device away.

Please follow 3 steps below.

Step 1: Turn the device upside down.

Step 2: Turn power switch on, the device’s caterpillar belts continually rotate for 3

minutes.

Step 3: Customers use cloth clean caterpillar belts and keep cloth in the middle

of belts to avoid cloth being jammed in the belts. If cloth is jammed, users

can turn power switch off and draw it out.

UPS (Uninterrupted Power System) function

(1)The UPS function will be enabled automatically when no electric power is

supplied. The backup time of this UPS is 20 minutes.

(2)If no electric power is supplied, the device will stop automatically, sound an

alert, and flash a red light. The user should take the device down from the glass

as soon as possible.

(3)The safety rope can be used to pull the device back. Gently pull the safety rope

at an angle close to the glass to prevent it from falling off.

How to clean the glass

Microfiber dry-cleaning cloth : it is specifically used for dry clean to wipe partial

dust, dirt off the outside of windows because of its lower friction and poorer water

absorbency.

Microfiber polishing cloth : it can be used for wet or dry clean and suitable for

dust-free exterior windows and interior windows due to its higher friction factor

and better water absorbency.

- 8 - HOBOT Technology Inc.

Spraying detergent on the glass makes HOBOT effectively polish window and

leave window shining. If the device slips and cannot move, please change cloth

to micro-fiber dry-cleaning cloth.

If there is water or detergent on the cloth or glass, the water or detergent will mix

together with the dust or dirt to become mud. Thus, dusty windows must be

cleaned with dry- cleaning cloth as the first step of cleaning glasses, no water or

detergent is needed, exterior windows especially.

Using HOBOT on sunny days or days with low humidity for best results.

The surface of window with water molecules becomes slippery and has

white streaks left on the glass so it is not suggested using the device to

clean exterior windows on rainy or high humidity days.

Remote controller

The device can be remote controlled from the front and back sides. To replace the

battery, just pull down the battery cover.

Setup

Direction

Horizontal

Setup

Vertical

Setup

Zigzag, then N-way

auto-clean whole window

N-way auto-clean whole

window

move LEFT then Zigzag

auto-clean the rest window

move UP then N-way

auto-clean the rest window

move RIGHT then Zigzag

auto-clean the rest window

move DOWN then in N-way

auto-clean the rest window

, , ,

Manually move UP, DOWN, RIGHT, LEFT

Stop

Start/Stop

Auto up then down Auto left then down Auto right then down

- 9 - HOBOT Technology Inc.

Setting up the device with the HOBOT App.

( HOBOT-288 only )

Step 1: Scan QR code or search “HOBOT”on the App Store or

Google Play to download HOBOT app on your smart

phone or tablet.

Step2. Turn on Bluetooth and click

HOBOTApp.

Step3. Turn on the device and wait for

“Connected”shown on HOBOT

App.

Make sure both HOBOTApp and the device are on, so you can

use your iOS or Android smart device to operate the

device.

LED indication

Situation

LED indication/Sound

1. Battery charging

Orange LED is ON

2. Battery charged full

Green LED is ON

3. No electrical power

Blue LED is ON

Red LED flashing

Sound: repeat beep

4. Hardware error

Red-LED flashing

Blue-LED flashing with “error number”

Sound: beep once 60 seconds

5. Vacuum pressure too low

Blue LED is ON

Red-LED flashes once

Sound: single beep

6. Air leakage while operating

Blue LED is ON

Red-LED flashes once

Sound: single beep

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hobot Staubsauger Handbücher

Hobot

Hobot WINBOT 68 Bedienungsanleitung

Hobot

Hobot HOBOT-R3 Bedienungsanleitung

Hobot

Hobot 388 Bedienungsanleitung

Hobot

Hobot LEGEE-668 Bedienungsanleitung

Hobot

Hobot Legee-669 Bedienungsanleitung

Hobot

Hobot LEGEE-688 Bedienungsanleitung

Hobot

Hobot LEGEE 7 Bedienungsanleitung

Hobot

Hobot HOBOT-298 Bedienungsanleitung

Hobot

Hobot HOBOT-188 Bedienungsanleitung

Hobot

Hobot LEGEE-D7 Bedienungsanleitung

Hobot

Hobot LEGEE-688 Bedienungsanleitung

Hobot

Hobot LEGEE-668 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung