Honeywell RAE Systems NeutronRAE II Bedienungsanleitung

NeutronRAE II

User’s Guide

www.raesystems.com

Personal Radiation Monitor

P/N 047-4204-100

Revision B, January 2013

Read Before Operating

This manual must be carefully read by all individuals who

have or will have the responsibility of using, maintaining,

or servicing this product. The product will perform as

designed only if it is used, maintained, and serviced in

accordance with the manufacturer’s instructions.

CAUTION!

To reduce the risk of electric shock, turn off power and remove

batteries before removing the monitor cover. Never operate this

monitor while the cover is removed. Remove monitor cover and

sensor modules only in an area known to be non-hazardous.

WARNING

To prevent ignition of flammable or combustible atmospheres,

disconnect power before servicing.

WARNING

Do not mix old batteries with used batteries or mix batteries

from different manufacturers.

WARNING

Substitution of components may impair performance.

This product complies with Part 15 of the FCC rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) This device must accept

any interference received, including intereference that may cause

undesired operation.

www.raesystems.com

Warnings

For safety reasons, this equipment must be operated

and serviced by qualified personnel only. Read

and understand the user manual completely before

operating or servicing.

Computer Interface

Do not transfer data by means of the Bluetooth®interface in

hazardous atmospheres.

Static Hazard

Clean only with a damp cloth.

Long-Term Storage

Reliable performance of this radiation detector is based upon

regular usage. For long-term storage, the battery should be

disconnected. Preparation for use after long storage requires

installation of the batteries and a warm-up period of at least

10 minutes for the sensors to equilibrate. The user should

recognize that sensor life is based upon the purchase date.

2NeutronRAE II

Avertissements

Pour des raisons de sécurité, cet équipement doit

être utilisé, entretenu et réparé uniquement par un

personnel qualifié. Étudier le manuel d’instructions

en entier avant d’utiliser, d’entretenir ou de réparer

l’équipement.

Câble de Computer

Ne transférez pas les données au moyen de l’interface de

bluetooth en atmosphères dangereuses.

Danger Risque D’origine Electrostatique

Nettoyer uniquement avec un chiffon humide.

Stockage à Long Term

Le fonctionnement durable de ce détecteur de rayonnement

est conditionné par une utilisation régulière de celui ci. Lors

d’un stockage à long terme, la batterie doit être déconnectée.

Le rédémarrage aprés une longue période d’arrêt, nécessite la

réinstallation de la batterie, et une période de chauffage de 10 mn

afin que les capteurs se mettent à l’équilibre. L’utilisateur doit être

conscient que la durée de vie indiquée pour le capteur démarre à

sa date d’achat.

www.raesystems.com

Contents

NeutronRAE II Features .......................................4

General Information ...........................................5

Inserting & Replacing Batteries..................................6

User Interface ...............................................7

User Interface Icons ...........................................8

Turning the NeutronRAE II On and Off ...........................8

Flipping the Screen ..........................................12

Operation ..................................................13

Normal Operating Mode ...................................13

NORM ................................................14

CAL ..................................................14

PEAK .................................................15

MIN ..................................................15

DOSE .................................................16

STAT .................................................16

COMM ................................................17

TEST .................................................18

Programming Mode .......................................20

Alarm Set ..............................................21

Datalog Set .............................................22

Monitor Set ............................................23

Back Lite .............................................24

Buzz & Lite ...........................................25

Vibrate mode ..........................................25

Temp Unit ............................................25

Gamma Unit ..........................................26

Change Date ..........................................26

Change Time ..........................................26

Quit .................................................27

Default Settings and Parameter Ranges ..........................27

Specications ...............................................29

Limited Warranty ............................................34

4NeutronRAE II

LED alarm

LCD showing operation

parameters and

radiation measurements

MODE key for

selecting mode

and function

Buzzer alarm

SET key for

selecting

or setting

parameters

Battery

compartment

cover screw Belt clip

Battery

compartment

LED alarm

Front View

Rear/Side View

Sensor location

www.raesystems.com

General Information

The NeutronRAE II is a rapid detector

of γ-ray (gamma) and neutron radia-

tion sources.

Because of its high

sensitivity, it can alert rst responders

to the presence of a radiation threat

well before they might be exposed

to health-threatening levels.

This

personal radiation detector features a

loud audible alarm, big, bright ashing

LEDs, and a vibration alarm. For stealth

operations, law enforcement personnel can disable each

alarm separately.

NeutronRAE II’s water-resistant design makes for reliable

operation in wet environments. Its sensitive Cesium Iodide

(CsI) and Lithium Iodide (LiI) scintillators provide fast

response to radiological threats.

The NeutronRAE II accumulates dosage. Stored dosage data

can be cumulative or cleared and reset for each use period.

6NeutronRAE II

NeutronRAE II Features

Inserting & Replacing Batteries

NeutronRAE II uses two AA alkaline batteries as

its power source (use only Duracell MN1500 or

Energizer E91). To change the batteries:

1. Use a coin or

screwdriver to open

the cover on the

side of the unit.

Turn the screw

counterclockwise to

loosen the screw, and

then tilt the cover off.

2. Insert batteries into the compartment

according to the legend on the rear of

the NeutronRAE II, making sure the

batteries’ polarity is correct.

3. Replace the cover and turn the screw

clockwise to secure the cover.

www.raesystems.com

User Interface

NeutronRAE II’s user interface consists of the display, LEDs,

alarm transducer and two buttons, labeled MODE and SET.

The LCD display provides visual feedback that includes

time, functional mode, battery condition, and gamma and

neutron radiation measurements.

LCD display

Current time

Gamma alarm

information

Battery status

Functional

mode

Gamma radiation

measurement

Unit of

measure

(gamma)

MODE and SET switches

Datalog indication

Neutron radiation

measurement

Neutron reading

sign

Unit of

measure

(neutron)

Neutron alarm

information

8NeutronRAE II

User Interface Icons

Icon Indication

Battery Voltage low

Battery Low alarm triggered

Battery fully charged

Low Gamma alarm triggered

High Gamma alarm triggered

Gamma Over-Range (reading over 20 mR/h)

Gamma Overload

Low Neutron alarm triggered

Neutron Over-Range (reading over 100 cps)

Neutron Overload

Bluetooth®communication active

Datalogging active (ashing)

Inhaltsverzeichnis

Andere Honeywell Messgerät Handbücher

Honeywell

Honeywell H Series Bedienungsanleitung

Honeywell

Honeywell GasLab Q2 Bedienungsanleitung

Honeywell

Honeywell TE923W - Deluxe Weather Station Bedienungsanleitung

Honeywell

Honeywell Minitrend Bedienungsanleitung

Honeywell

Honeywell SmartLine RMA800 Bedienungsanleitung

Honeywell

Honeywell Green Class meter Bedienungsanleitung

Honeywell

Honeywell AC-250NXS Bedienungsanleitung

Honeywell

Honeywell HERMetic PRESS Bedienungsanleitung

Honeywell

Honeywell BK V2 Bedienungsanleitung

Honeywell

Honeywell DR4300 Series Leitfaden

Honeywell

Honeywell TC809EA1035 Bedienungsanleitung

Honeywell

Honeywell RM640 Bedienungsanleitung

Honeywell

Honeywell HPB Bedienungsanleitung

Honeywell

Honeywell CM4 Bedienungsanleitung

Honeywell

Honeywell QA 10 DN 25 G I Bedienungsanleitung

Honeywell

Honeywell FS24X Plus Bedienungsanleitung

Honeywell

Honeywell Enraf FlexLine RMA805 Bedienungsanleitung

Honeywell

Honeywell BK-G1.6A Bedienungsanleitung

Honeywell

Honeywell RMA300-ME Bedienungsanleitung

Honeywell

Honeywell enCore Series Bedienungsanleitung

Honeywell

Honeywell AutoSet 1500 Bedienungsanleitung

Honeywell

Honeywell themis plus EI3 Bedienungsanleitung

Honeywell

Honeywell AS302P Bedienungsanleitung

Honeywell

Honeywell NOTIFIER AM-8200 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

Keysight

Keysight M8290A Bedienungsanleitung

Acterna

Acterna MS1400 Bedienungsanleitung

R&S

R&S ZPH Bedienungsanleitung

Datacolor

Datacolor ColorReader DC10-2 Bedienungsanleitung