Honeywell VISTA-128BPT Installationsanleitung
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 1
Interfacing Lutron RadioRA 2
®
Systems with
Honeywell Vista-128BPT Security Systems
revision A
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 2
Interfacing Lutron RadioRA 2
®
Systems with
Honeywell Vista-128BPT Security Systems
Overview
RadioRA 2
®
is capable of direct integration with the Honeywell Vista-128BPT security panel. Integrating RadioRA 2 with a
security system enables many new features beyond intrusion alert. By incorporating lighting control, shades, temperature,
and small appliance control, RadioRA 2 offers energy savings, convenience, and ambiance that the homeowner can enjoy
every day.
Required components
In order to interface RadioRA 2 with a Vista-128BPT security panel, you will need the following items:
•RadioRA 2 system installed
•RadioRA 2 programming software version 5.0 or higher.
•Honeywell Vista-128BPT security panel installed and programmed (to enable the extra settings to allow
integration—not covered in the Honeywell instructions—see Appendix 2)
•Null Modem Serial cable or straight-through Serial cable with a Null Modem adapter
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 3
Wiring
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 4
Programming Overview
Programming a RadioRA 2 system to interface with a Honeywell Vista-128BPT security panel is done in four phases:
1.) Install and program the Honeywell Vista-128BPT security system according to Honeywell instructions.
2.) Program the Vista-128BPT to enable the extra settings to allow the integration, not covered in the Honeywell instructions
(see Appendix 2).
3.) Install and program the Lutron RadioRA 2 system using RadioRA 2 programming software version 5.0 or higher.
4.) Program appropriate phantom buttons associated with each security action, as described in the following section.
Programming Phantom Buttons for Security
Actions in the Honeywell Vista-128BPT security panel will send RS-232 commands to the RadioRA 2 system. Each command is
associated with a specific phantom button, and each phantom button may be programmed to deliver a desired scene. When a
command is received from the security system, the corresponding phantom button is automatically “pressed”. For certain
buttons, a Time of Day feature has been pre-programmed so that the most appropriate action takes place.
The RadioRA 2 Main Repeater has 100 phantom buttons available for use with integration. Buttons 76-100 are configured to
receive commands from the Honeywell Vista Turbo system. Table 1 shows how each security action is associated with RadioRA
2 phantom buttons and Table 2 offers a recommended scene for each phantom button. The Time of Day, when various actions
will take place, is also specified. Table 3 provides a timeline illustrating how the RadioRA 2 system will automatically respond to
various security commands throughout the day.
Note: If the Honeywell Vista-128BPT system has no partitions, use phantom buttons associated with partition 1. See Table 2 for
the phantom button to partition mapping.
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 5
Table 1: Security Actions and associated Phantom Buttons (Partition 1)
This table illustrates the various possible actions from a security system and the phantom buttons they will activate depending on Time of
Day. The recommended phantom button scene name is also matched to the phantom button number.
Security Action Time of Day Phantom Button(s) Activated Phantom Button Scene Name
Day 95 + 92 Away Scene + Away Timeclock Mode
Arm Away
Night 95 + 92 Away Scene + Away Timeclock Mode
Day - -
Arm Stay
Night 93 Goodnight
Day 92 turned off (Away Timeclock turned off)
Disarm
Night 92 turned off; 94 (Away Timeclock turned off); Welcome
Day 98 + 99 Exterior Flash, Interior Full
Intrusion
Night 98 + 99 Exterior Flash, Interior Full
Day 100 + 98 Emergency, Exterior Flash
Emergency
Night 100 + 98 Emergency, Exterior Flash
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 6
Table 2: Phantom Buttons and Recommended Programming
This table provides the recommended programming for each phantom button associated with security on the Main Repeater.
Button Type Recommended Programming
Phantom
Button
Security
System
Partition Recommended
Scene Lights Shades HVAC Plug-in
Modules Time Clock
100 All Single/Multi-
room scene Emergency* Interior lights at 25% Open - - -
99 All Security mode Interior Full Interior lights at 100% Open - - -
98 All Security mode Exterior Flash Exterior lights flash - - - -
97 All Reserved for
future use - - - - -
96 All Reserved for
future use - - - - -
95 1 Single/Multi-
room scene Away Scene Lights off (delayed off on exit
pathway) Close - Off -
94 1 Single/Multi-
room scene Welcome Entry, foyer, kitchen lights on to
75% - - -
93 1 Single/Multi-
room scene Goodnight Evening light levels Close Set Back Off -
92 1 Timeclock mode Away Timeclock
Mode - - Set Back - Away Mode
91 1 Reserved for
future use - - - - -
90 2 Single/Multi-
room scene Away Scene Lights off (delayed off on exit
pathway) Close - Off -
89 2 Single/Multi-
room scene Welcome Entry, foyer, kitchen lights on to
75% - - -
88 2 Single/Multi-
room scene Goodnight Evening light levels Close Set Back Off -
87 2 Timeclock mode Away Timeclock
Mode - - Set Back - Away Mode
86 2 Reserved for
future use - - - - -
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 7
Button Type Recommended Programming
Phantom
Button
Security
System
Partition Recommended
Scene Lights Shades HVAC Plug-in
Modules Time Clock
85 3 Single/Multi-
room scene Away Scene Lights off (delayed off on exit
pathway) Close - Off -
84 3 Single/Multi-
room scene Welcome Entry, foyer, kitchen lights on to
75% - - -
83 3 Single/Multi-
room scene Goodnight Evening light levels Close Set Back Off -
82 3 Timeclock mode Away Timeclock
Mode - - Set Back - Away Mode
81 3 Reserved for
future use - - - - -
80 4 Single/Multi-
room scene Away Scene Lights off (delayed off on exit
pathway) Close - Off -
79 4 Single/Multi-
room scene Welcome Entry, foyer, kitchen lights on to
75% - - -
78 4 Single/Multi-
room scene Goodnight Evening light levels Close Set Back Off -
77 4 Timeclock mode Away Timeclock
Mode - - Set Back - Away Mode
76 4 Reserved for
future use - - - - -
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 8
Table 3: Security Programming Timelines
When configured according to this tech tip, the RadioRA 2 system will automatically respond to commands from the security keypad
as outlined in the tables below.
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 9
RadioRA 2 Interfacing with Honeywell Vista-128BPT Security Syste s Page 10
Appendix 1: Programming the Phantom Buttons
Coming soon: for more in-depth programming instructions, a corresponding Security Training Module can be found online
at resi.lutron.com/radiora2 by following the RadioRA 2 Software Online Training Modules link.
Once the project has been designed in the RadioRA 2 programming software, select the “Program” tab (1) and then find
the Main Repeater using the “Selected Device Location” drop-down menu (2).
1
2
Andere Handbücher für VISTA-128BPT
5
Inhaltsverzeichnis
Andere Honeywell Sicherheitssystem Handbücher
Honeywell
Honeywell VISTA-21iP Bedienungsanleitung
Honeywell
Honeywell VISTA-128BPEN Montageanleitung
Honeywell
Honeywell LYNX Touch Security System Bedienungsanleitung
Honeywell
Honeywell MK V Bedienungsanleitung
Honeywell
Honeywell Galaxy Dimension Bedienungsanleitung
Honeywell
Honeywell Vista 21IP Bedienungsanleitung
Honeywell
Honeywell SEF800HF Bedienungsanleitung
Honeywell
Honeywell proX1 Bedienungsanleitung
Honeywell
Honeywell SEF8MS Bedienungsanleitung
Honeywell
Honeywell Lynx Plus Series Montageanleitung
Honeywell
Honeywell Domonial Bedienungsanleitung
Honeywell
Honeywell LYNX Touch Security System Bedienungsanleitung
Honeywell
Honeywell ADEMCO 745 3 Series Montageanleitung
Honeywell
Honeywell HS321S Bedienungsanleitung
Honeywell
Honeywell LYNX Touch L5210 Series Bedienungsanleitung
Honeywell
Honeywell Lyric Bedienungsanleitung
Honeywell
Honeywell FA-300 Alarm Bar Bedienungsanleitung
Honeywell
Honeywell Ademco VISTA-32FB Bedienungsanleitung
Honeywell
Honeywell ADEMCO LYNXR-ENSIA Bedienungsanleitung
Honeywell
Honeywell Friedland FGGA04 Series Bedienungsanleitung
Beliebte Sicherheitssystem Handbücher anderer Marken
EDM
EDM Solution 6+6 Wireless-AE Bedienungsanleitung
Highway Safety Group
Highway Safety Group EA401 Bedienungsanleitung
Siren
Siren LED GSM Bedienungsanleitung
Detection Systems
Detection Systems 7090i Montageanleitung
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung
Siemens
Siemens FDM273 Bedienungsanleitung