Honeywell PRO TH4110B Bedienungsanleitung

Product Application

This thermostat provides electronic control of 24 VAC single-stage heating and cool-

ing systems, or 750 mV heating systems.

System Types Power Type

• Gas, oil, or electric heat with air • AA alkaline batteries (2)

conditioning

• Warm air, hot water, high-efficiency System Settings

fllrnaces, heat pumps, steam, gravity • Heat, Oft, Cool

• Heat only

• Heat only with fan Fan Settings

• Cool only • Auto, On

• 750 mV heating systems

CAUTION: ELECTRICAL HAZARD

Can cause electrical shock or equipment damage. Disconnect power before

beginning installation.

MERCURY NOTICE

If this product is replacing a control that contains mercury in a sealed tube, do not

place the old control in the trash. Contact your local waste management authority for

instructions regarding recycling and proper disposal.

® U.S. Registered Trademark. Patents pending.

PRO TH4110B Programmable Thermostat

Installation

Preqnstallation checklist ............... .2

WMlplate installation ..................... .3

Wiring. ............................................ .4

Wiring diagrams .............................. 5

Installer Setup

Fan operation settings ................ .6

Batte W iustallation ......................... .7

Thermostat mounting ................... .7

Installer setup ................................. .8

Installer system test ....................... .9

Appendices

Quick reference to controls .......... 10

Quick reference m display ............ 10

Compressor protection ................ l0

In case of difficulty ...................... 11

Accessories. ................................... 12

Specifications ................................ 12

InstNI the thermostat about 5 feet (1.5m) above the floor in an area

wRh good air circulation at average temperature.

Do not instaR in locations where the thermostat can be affected by:

* Drafts or dead spots behind doors and in corners

* Hot or cold air from ducts

* Sunlight or radiant heat from appliances

* Concealed pipes or chimneys

* Unheated/uncooled areas such as an outside wall behind the thermostat

Installation Guide

Package contents

Check to make sure your package includes the l()llowing items:

PRO TH4110B

digital thermostat

(wallplate attached to back)

Wall anchors and AA alkaline

mounting screws batteries (2)

(2 each)

Operating manual

Quick reference card

Required tools & supplies

• No. 2 Phillips screwdriver

• Small pocket screwdriver

• Drill

• Drill bit (3/16" for drywall, 7/32" for plaster)

" Hananaer

• Pencil

• Electrical tape

• Level (optional)

PRO TH41 lOB Programmable Thermostat

Grasp top and bottom of wallplate

and pull to remove from thermostat. Remove the wallplate from the ther-

mostat as shown at left, then fk_llow

directions below for mounting.

1 Pull wires through wire hole.

2 Position wallplate on wall, level and

mark hole positions with pencil.

3 Drill holes at marked positions as

shown below, then tap in supplied

wall anchors.

4 Place wallplate over anchors, insert

and tighten mounting screws.

5 Insert quick reference card in slot

in [?ont of wall plate.

Insert quick reference card after

wallplate is mounted (see mounting

instructions, below)

Drill 3/16" holes for drywall.

Drill 7/32" holes for plaster.

Installation Guide

CAUTION: ELECTRICAL HAZARD. Can cause electrical shock or equipment damage.

Disconnect power before wiring.

Jumper

0000000

WYG ORcR B

Terminal

block

NOTES

R & Rc termirtals

In single-transformer system, leave metal

jumper in place between R & Rc. Remove

metal jumper if two-transformer system.

Heat pump systems

If wiring to a heat pump, use a small piece of

wire (not supplied) to connect terminals W

and Y.

Wire specifications

Use 18- to 22-gauge thermostat wire.

Shielded cable is not required.

Wiring

I Loosenscrew terminals, insert

wires into terminal block, then

re-tighten screws.

2 Push excess wire back into the

wall opening. Keep wires in shaded

area as shown at left.

Plug the wall opening with non-

flammable insulation to prevent

drafts from affecting thermostat

opemtion.

Terminal Designations

W Heat relay.

YColYlpressor contactor.

G Fan relay.

O Heat pump changeover valve

energized in cooling.

Rc Cooling powe> Connect to

secondary side of cooling

system transformer.

R Heating power. Connect to

secondary side of heating

system transformer.

B Heat pump changeover valve

energized in heating.

PRO TH41 lOB Programmable Thermostat

_. Power supply. Provide disconnect means and overload protection as required.

,_ Factory-installed jumper. Remove for 2-transformer systems only.

A Use either O or B terminals for changeover valve.

,_ Use asmall piece of wire (not supplied) to connect W and Y terminals.

,_ Set fan operation switch to Heat Pump (see page 6) and configure for heat pump (see pg. 8).

Typiea_ 1H/1C system." 1 transformer

_ HEATRELAY _]

COMPRESSOR

CONTACTOR

FAN RELAY

1(HOT)

I°°°_ "°.°1

W Y G O Rc R

Typical 1H/1C system: 2 transformers

HEATRELAVI _.L,

.....* kl (HOT)

°_A2LI {HOT)

Y G ORc R

Remove jumper

Typical 1H/1C heat pump system

IwYoososolA

Typical heat=only system

C_L2

......* 1 (HOT)

I'w°°° ° °°1

Y G 0 Rc R B

Typical heat=only system with fan

FAN RELAY CL2

I(HOT)

I°_°_ °°tlW Y G O Rc R

Typical cool=only system

CONTACTOR

FAN RELAY C L2

1(HOT)

Iw_°°_°".°1g G O Rc R

Installation Guide

Gas or Oil: For gas or oil heating

systems, leave the fan operation

switch in this factory-set position

(This setting is liar systems that

control the fan in a call liar heat.)

Electric or Heat Pump: Change the

switch to this setting lk)r heat

pump or electric heat systems.

(This setting is lk_rsystems that

allow the thermostat to control the

fan in a call for heat, if a fan wire is

connected to the G terminal.)

Set fan operation switch

PRO TH41 lOB Programmable Thermostat

Install two AA alkaline batteries in the

back of the thermostat, as shown at

left.

Install batteries in back of thermostat

Fresh batteries should lye installed

immediately when the REPLACEBATT

warnh_g begins flashhlg (see page 10.)

The warning flashes about two months

befbre batteries are depleted.

Even if the wamh_g does not appear,

Batteries should lyereplaced once a year,

or befbre the home is left vacant tbr

more than a month.

Align the 4 tabs on the wallplate with

corresponding slots on the back of the

thermostat, then push gently until the

thermostat snaps in place.

Installation Guide

Follow the procedure below to configure the thermostat to match the installed

heating/cooling system, and customize feature operation as desired.

Press and hold both buttons

To begin, press and hold the A and V

buttons until the display changes

Function number Setting

Press Y to change settings

Press A to advance to next function

Press and hold Yak to exit and save settings

Setup Function

1Systemtype

5 Heating cycle rate

(CPH: cycles/hour)

9 Compressor

cycle rate (CPH)

Settings & Options

0Gas_ oil or electric heat with air conditioning

1 Heat pump (5 minute compressor off time in heating and cooling)

5 For gas or oil furnaces of less than 90% efficiency

1 For steam or gravity systems

3 For hot water systems & furnaces of over 90% efficiency

9 For electric furnaces

[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]

Recommended for most compressors

[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]

14 Temperature 0 Fahrenheit

display 1 Celsius

t5 Compressor

protection 5 Five-minute cempressor off time **See page 10

[Other options: 0, 1, 2, 3 or 4-minute off time]

J"3.. = "3 "||l ""3

After completing the installer setup above, press the _k button again to begin a

system test (see next page).

Andere Handbücher für PRO TH4110B

Inhaltsverzeichnis

Andere Honeywell Thermostat Handbücher

Honeywell

Honeywell CT3650 Bedienungsanleitung

Honeywell

Honeywell PRO 3000 Bedienungsanleitung

Honeywell

Honeywell FocusPRO TH6220D Bedienungsanleitung

Honeywell

Honeywell RTH2310 Bedienungsanleitung

Honeywell

Honeywell Y87RF Bedienungsanleitung

Honeywell

Honeywell T7351 Bedienungsanleitung

Honeywell

Honeywell TP979A-E Bedienungsanleitung

Honeywell

Honeywell T8602C Bedienungsanleitung

Honeywell

Honeywell PRO TH3110D Bedienungsanleitung

Honeywell

Honeywell PRO 1000 Bedienungsanleitung

Honeywell

Honeywell CHRONOTHERM T4700 Bedienungsanleitung

Honeywell

Honeywell Lyric T6 Pro Wi-Fi Bedienungsanleitung

Honeywell

Honeywell RTH9580 Wi-Fi Bedienungsanleitung

Honeywell

Honeywell VisionPRO TH8321 Bedienungsanleitung

Honeywell

Honeywell Single Stage Heat Pump ProgrammableCommercial... Bedienungsanleitung

Honeywell

Honeywell Evohome Bedienungsanleitung

Honeywell

Honeywell Digital Round T8775A Bedienungsanleitung

Honeywell

Honeywell RTH7400 series Bedienungsanleitung

Honeywell

Honeywell RTH2300 series Bedienungsanleitung

Honeywell

Honeywell XE70 Series Bedienungsanleitung

Honeywell

Honeywell CT3200 series Benutzerhandbuch

Honeywell

Honeywell RTHL2410 series Bedienungsanleitung

Honeywell

Honeywell T834H Bedienungsanleitung

Honeywell

Honeywell ST9400A Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Aube Technologies

Aube Technologies TH305 Bedienungsanleitung

Powtier Controls

Powtier Controls 505MST Bedienungsanleitung

Kanmor

Kanmor Zone Control 369e Bedienungsanleitung

MICROclimate International

MICROclimate International B2 Magic Eye Bedienungsanleitung