HP 205H-MNT2 Bedienungsanleitung

205H-MNT2 Wall Mount Kit

Installation Guide

0511763-03 | March 2015 1

Package Contents

Dual Gang Wall Mount

(x4) #6-32 Machine Screws

Plastic Front Cover

(x2) T8H Torx Security Screw

205H-MNT2 Wall Mount Kit Installation Guide

Introduction

The 205H-MNT2 Wall Mount Kit provides a secure and practical solution for mounting the 205H access

point to single and dual gang wall boxes.

Installing the 205H-MNT2 Wall Mount Kit

Use the following instructions to install the 205H-MNT2 Wall Mount Kit.

1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in Figure 1.

Figure 1 Removing Existing Wall Plate

2. Detach any RJ-45 cables by unclipping the connectors from the wall plate, or cutting/removing the UTP

cable(s).

3. Use a short Ethernet cable (sold separately, part number AP-CBL-ETH10) to connect the E0 port to an

RJ-45 connector, or crimp an RJ-45 plug (not supplied) to the cable, and insert into the E0 port. Do the

same for the PT port if used.

2205H-MNT2 Wall Mount Kit | Installation Guide

Installation for Single Gang Wall Box

If mounting the 205H-MNT2 Wall Mount Kit to a single gang wall box, refer to steps 4-5.

4. Align the screw holes on the mounting bracket with the corresponding holes on the single gang wall box,

as indicated in Figure 2.

Figure 2 Attaching Wall Mount to Single Gang Wall Box

5. Remove the #6-32 x 1 machine screws from their bag and screw the wall mount onto the wall box.

Installation for Dual Gang Wall

If mounting the 205H-MNT2 Wall Mount Kit to a dual gang wall box, refer to steps 6-7.

6. Align the screw holes on the mounting bracket with the corresponding holes on the dual gang wall box,

as indicated in Figure 3.

Figure 3 Attaching Wall Mount to Dual Gang Wall Box

205H-MNT2 Wall Mount Kit | Installation Guide 3

7. Remove the #6-32 screws from their bag and screw the wall mount onto the wall box, as shown in Figure

8. Connect any required cables to the rear of the access point.

9. Align the mounting slots on the back of your 205H access point with the corresponding posts on the wall

mount as shown in Figure 4.

Figure 4 Securing 205H access point to Wall Mount

10. Push the access point against the holes and then downward until the posts engage the slots at the top of

the mounting holes.

11. (Optional) Using the second T8H Torx security screw provided, insert into the hole on the upper-right

side of the mount and tighten to lock the 205H access point into the mount.

12. Position the prongs on the back of the front cover inside the slots on the front mount housing, as shown

in Figure 5.

Figure 5 Fitting Front Cover onto Wall Mount

0511763-03 205H-MNT2 Wall Mount Kit | Installation Guide

13. Slide the cover into the tracks toward the access point until the left side of the cover is level with the

side of the mount. Refer to Figure 6, demonstrating the cover sliding from open position (left) to locked

position (right).

Figure 6 Plastic Side Cover Sliding into Wall Mount (Rear View)

14. (Optional) Once the front cover is securely attached to the mount, insert one of the T8H Torx Security

Screw into the hole located at the left side of the cover and tighten until secure.

15. (Optional) If not using PoE, connect the AC-DC power adapter (sold separately, part number AP-CBL-

SER) to the DC power socket located on the right of the 205H access point.

Inhaltsverzeichnis

Andere HP Netzwerk-Hardware Handbücher

HP AHA-8940 Bedienungsanleitung

HP StorageWorks x9300 Service-Handbuch

HP StorageWorks X1000 G2 Anleitung zur Verwendung

HP zl2 Bedienungsanleitung

HP 10:10 LAN Bridge MB Installations- und Betriebsanleitung

HP AJ878A - StorageWorks 320 GB Hard Drive Bedienungsanleitung

HP ProLiant DL980 G7 Kurzanleitung

HP Bc1500 - BladeSystem - Blade PC Bedienungsanleitung

HP X1800sb G2 Gebrauchsanweisung

HP 16-port SCS Bedienungsanleitung

HP IBRIX X9720 Service-Handbuch

HP Ethernet Network Interface Card hn230e Bedienungsanleitung

HP StoreEasy 3000 Bedienungsanleitung

HP 634041-006 Kurzanleitung

HP Deskjet 870 Bedienungsanleitung

HP HSR6602-G Montageanleitung

HP ProCurve 1600M Bedienungsanleitung

HP Bc1500 - BladeSystem - Blade PC Handbuch

HP E1459A Bedienungsanleitung

HP c-Class Installationsanleitung

HP StorageWorks T5521A Handbuch

HP X1600 - StorageWorks Network Storage System 5.4TB SAS Model NAS... Anleitung zur Verwendung

HP StorageWorks 2324fc Bedienungsanleitung

HP MSR954 Series Montageanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Lanner

Lanner NCA-1525 Bedienungsanleitung