HP 6100 Leitfaden

HP StorageWorks

Operator ControlPanel

replacement instructions

These instructions apply to the EVA4x00/6x00/8x00

products. The part may also be used in other HP

products. See the documentation for your product for

detailed replacement instructions.

L.P.

Third edition June 2007

The information in this document is subject to change without

notice.

Printed in Puerto Rico

www.hp.com

*5697-6792*

About this document

This document describes the procedure for replacing the Operator

Control Panel (OCP).

CAUTION:

This procedure assumes the storage system is running XCS 6.000

orlater.IfyouarerunninganearlierversionofXCS,contactyour

HP-authorized service representative for assistance in replacing

the OCP.

Warranty information

Iftheproductinwhichthispartisbeingreplacedisstillunder

HP warranty, then the replacement part(s) referred to in these

Replacement Instructions is provided under the terms and conditions

of the Hewlett-Packard Company Limited Warranty for that

product. A copy of this Limited Warranty may be viewed at:

http://h18006.www1.hp.com/products/storageworks/warranty.html

If this is a trade sale part (product out of warranty), then the replacement

part(s) referred to in these Replacement Instructions is provided under

HP's express limited warranty statement, which may be viewed at:

http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/

policies/2330100.doc

The replacement part takes on either the Limited Warranty Period of the

part being replaced or a ninety-day period that begins upon installation

of the replacement part, whichever is greater.

The only warranty for this replacement product is as noted above.

Nothing in these replacement instructions should be construed as

constituting an additional warranty. The information provided in these

replacement instructions is provided "AS IS" and HP is not liable for

technical or editorial errors or omissions contained herein.

Before you begin

Observe the following precautions when replacing the OCP:

•Removing the OCP signiﬁcantly changes the air ﬂow within the

enclosure. The OCP must be installed for the enclosure to cool

properly. If the OCP fails, leave it in place in the enclosure until a

new OCP is available to install.

•Parts can be damaged by electrostatic discharge. Use proper

anti-static protection.

•UsecarewhenreplacingtheOCPtoavoiddamagingtheenclosure.

Removing the OCP

1. Remove the front panel (1, Figure 1) by grasping the panel at each

end pulling it off the enclosure.

2. Press the OCP latch (2) and swing the panel out until it is fully open.

CAUTION:

Handle the OCP by its metal frame only. This will ensure that the

electronic components are not damaged by static discharge.

3. Grasp the OCP by its metal frame and pull it out of the enclosure

(3).

Page 1

0142b

Figure 1 Removing the OCP

Installing the OCP

1. Slide the new OCP into the enclosure (1, Figure 2).

2. Close the OCP until the latch engages.

3. Install the front panel, pressing it ﬁrmly into place.

NOTE:

After installing the OCP, the controller may have to upgrade the

OCP ﬁrmware. Do not remove the OCP while this operation is in

progress. When the OCP is displaying the alternating Storage

System Name and WWID, the correct ﬁrmware has been loaded

on the OCP.

0143b

Figure 2 Installing the OCP

Verifying proper operation

After replacing the OCP, verify that it is operating properly:

1. Check the display. It will typically display the default information

which alternates between the Storage System Name and the World

Wide Name.

2. Press any push button. The Storage System Menu Tree should be

displayed.

Returning the failed component

Follow the return instructions provided with the new component.

Page 2

Andere Handbücher für 6100

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Lagerung Handbücher

HP StorageWorks 8B - FC Entry Switch Bedienungsanleitung

HP StorageWorks TL895 Bedienungsanleitung

HP C2488A Produkthandbuch

HP SureStore 4115w Bedienungsanleitung

HP StorageWorks ESL E Series Gebrauchs- und Pflegehandbuch

HP StorageWorks XP10000 - Disk Array Bedienungsanleitung

HP StorageWorks P4000 Series Bedienungsanleitung

HP HP 7936 Montageanleitung

HP StorageWorks 9100 - Extreme Data Storage... Handbuch

HP StorageWorks 1500cs - Modular Smart Array Bedienungsanleitung

HP SimpleSave Bedienungsanleitung

HP Surestore DLT 80 Bedienungsanleitung

HP StoreAll 8000 Gebrauchsanweisung

HP StorageWorks P4000 Series Bedienungsanleitung

HP Surestore Disk Array 12h - And FC60 Montageanleitung

HP StorageWorks vs80 Bedienungsanleitung

HP Xw8200 - Workstation - 1 GB RAM Referenzhandbuch

HP EVA P6000 Bedienungsanleitung

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Bedienungsanleitung

HP S700 Pro 2.5 Bedienungsanleitung

HP Storevirtual 4000 Bedienungsanleitung

HP VS160 - StorageWorks DLT Tape Drive Betriebsanleitung

HP AJ750A - StorageWorks Modular Smart Array 2000 Dual I/O Storage... Bedienungsanleitung

HP SmartMemory Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung

Dell

Dell PowerVault MD3600f Series Bedienungsanleitung

CFI

CFI TERA STOR SATA RAID IV Bedienungsanleitung