Hubbell Dual-Lite PGN Handbuch

WARNING – This product contains chemicals known to the State of California to cause cancer, birth

defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,

or otherwise touching this product.

SERVICE

Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com

93020531 A 2/09

High Performance LED Sconce For Indoor

Or Outdoor Application

Installation, Operation and Service Instructions

PGN LED Sconce

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following.

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not let power supply cords touch hot surfaces.

2. Do not mount near gas or electric heaters.

3. Equipment should be mounted in locations and at heights where it will not readily be subject

to tampering by unauthorized personnel.

4. The use of accessory equipment not authorized by the manufacturer may cause an

unsafe condition.

5. Do not use this equipment for other than its intended purpose.

6. Servicing of this equipment should be performed by qualied service personnel.

INSTALLER:

•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS

•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT

93021413

93021935

93021936

93021937

93021938

93021939

LED Replacement

Contact factory

PATENTS

PENDING

RECYCLING INFORMATION

All steel, aluminum and thermoplastic parts

are recyclable.

All cartons contain recycled materials.

Please recycle responsibly.

Screw

O-Ring

Backplate

Cover

INSTALLATION OPERATION

120VAC Connect black (hot) and neutral

(white) to supply. Cap off

unused (red) conductor.

277VAC Connect red (hot) and neutral

(white) to supply. Cap off

unused (black) conductor.

Ground Connect ground (green)

conductor.

6VDC

through

12VDC

Connect blue (+) conductor to

building (+) DC supply. Connect

yellow (-) conductor to building

(-) DC supply

IMPORTANT:

Once unit is connected and cover is snapped onto backplate, gently

seat screws onto O-ring seals to less than 1/2FT-LB (.7N-m).

DO NOT OVERTIGHTEN!

O-RING MAY BE DAMAGED AND THE UNIT WILL LEAK IF ABOVE

IS NOT FOLLOWED.

1.Open the unit by loosening both screws on top of unit until screws spin

freely. Pry cover from backplate, and remove cover squarely from

backplate. (Remove screws prior to re-installing cover.)

2.Remove 7/8” diameter K.O. from backplate if mounting

to electrical box or remove 1/2”-1/4NPT pipe plug if

using conduit.

CONDUIT MOUNTING:

If unit is not secured to mounting surface using

unit backplate K.O. pattern and supplied gasket,

use sealant to create waterproof seal between the

mounting surface and the unit backplate.

IMPORTANT!

To weatherproof your outdoor installation, be sure to

seal all xture openings - mounting, conduit, etc.

4.Peel backing from J-Box Gasket and

adhere to backplate around center K.O.

5.Feed building wires through center

K.O. as shown and secure back-

plate using screws supplied with

electrical box.

3.Remove appropriate backplate

K.O.’s for electrical box screws.

6.Connect building AC

wires to transformer

harness wires. Connect

DC supply wires to DC

harness wires

7.Connect transformer AC wire harness

to AC wire harness on unit backplate.

8.Connect DC wire harness from unit

backplate to J1 on power supply PCB.

AC Wire Harness DC Wire Harness

To Building Ground Wire

NOTE:

Feed wires and nuts back into electrical box

through backplate as shown.

9.Attach unit cover to backplate

by reversing Step 1. Ensure

all wires are within enclosure to

avoid pinching with cover.

Full Cut-off Shield Installation

1.Slide tabs “A” between housing and lens gasket.

2.Pinch sides of shield inward and seat shield against lens.

3.Release pinched sides of shield to secure to unit.

TABS “A”

Pinch sides inward

Unit will operate from 120 or 277VAC, 6 through 12VDC.

NOTE: In order for unit to function properly as emergency lighting (NEC 700.12), DC emergency

supply must be powered from same normal AC supply as that to unit.

NOTE: This unit does not provide transfer logic. DC voltage supplied to unit will take priority over the

AC supply, and unit will operate from the DC supply whenever both AC and DC voltages are present.

93021938

93021935

93021936

93021937

93021939

Inhaltsverzeichnis

Andere Hubbell Außenleuchte Handbücher

Hubbell

Hubbell RATIO AREA Bedienungsanleitung

Hubbell

Hubbell KIM LIGHTING VSBC Bedienungsanleitung

Hubbell

Hubbell LNC4 Bedienungsanleitung

Hubbell

Hubbell PERIMALITER III Service-Handbuch

Hubbell

Hubbell KIM LIGHTINING C24 Bedienungsanleitung

Hubbell

Hubbell VBGL-2 Bedienungsanleitung

Hubbell

Hubbell Kim Lighting Neo Sphere NS Bedienungsanleitung

Hubbell

Hubbell FXL LED FLOOD Bedienungsanleitung

Hubbell

Hubbell KIM Path Pilot KLV101 Bedienungsanleitung

Hubbell

Hubbell Kim Lighting Wall Forms WF30H Series Bedienungsanleitung

Hubbell

Hubbell KIM LIGHTING ARCHETYPE-LED-AR-LED Bedienungsanleitung

Hubbell

Hubbell Kim Lighting KLV Series Bedienungsanleitung

Hubbell

Hubbell Killark KFLX Series Bedienungsanleitung

Hubbell

Hubbell Kim Pavilion PA7R Bedienungsanleitung

Hubbell

Hubbell MATRIX AREA Bedienungsanleitung

Hubbell

Hubbell WGH81L Bedienungsanleitung

Hubbell

Hubbell AIRO Bedienungsanleitung

Hubbell

Hubbell LUMASQUARE Bedienungsanleitung

Hubbell

Hubbell RFL2 Bedienungsanleitung

Hubbell

Hubbell SLING Service-Handbuch

Hubbell

Hubbell DDL-9L1 Bedienungsanleitung

Hubbell

Hubbell KIM Lighting SCARAB Accent Series Bedienungsanleitung

Hubbell

Hubbell DDL Series Bedienungsanleitung

Hubbell

Hubbell Kim Lighting EL161 Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung

LIGMAN

LIGMAN DE-20023 Bedienungsanleitung