PRODUCT INSTALLATION MANUAL DO13 SELF SERVE OLIVE
_________________________________________________________________________________________________________________________
Page 4 Hussmann
Operating Environment
All Hussmann Cases have been factory tested to AS1731, 25C at 60% RH. For best performance, store temperature
should be maintained at or below 24C at 50% RH, otherwise an “air ventilation kit” may be required to avoid under or rear
cabinet sweating.
To avoid condensation build-up, cases should be positioned to allow air to freely circulate around the underside and rear
of the case. Ideally, the floor will be levelled.
Cases must not be positioned in areas that may be subject to heat or air currents such as ventilation ducts, open doors or
windows, direct sunlight, electric fans or ovens, etc. Otherwise the cabinet may show poor temperature performance or the
operating life is affected.
NOTE
Refer to product MSDS for all hazardous substances used
during installation in relation to their application, PPE, first aid,
disposal and emergency management. Refer page 25 (Risk
Analysis)
For MSDS sheet contact your Hussmann Representative
Handling and Transporting cases
Case dimensions can be found in the product engineering data sheets.
(This manual is a guide only. Always refer to the latest case information available from Hussmann Customer Service)
Always ensure that the moving device is of a suitable type, and has sufficient lifting capacity for the case weight and
dimension. Always lift cases from the underside.
Refer to and follow the manual handling policies of your Company when moving cases.
CAUTION
Care must be taken to avoid damage to drainage
outlets and electrical equipment mounted under or
at the rear of cases.
Shipping Damage, Shortages and checklist
1. Where possible, it is recommended that packaging be removed from the case before they are moved into the store.
2. Inspect case for any shipping damage.
3. Any damage must be noted on the freight documentation supply by the transport company and contact a Hussmann
representative within 48 hours.
4. Take clear and accurate photos of damage parts with documentation and forward them to a Hussmann
representative.
5. Check and confirm all case part ie:- Trims, shelves, product fence, bumpers etc are supplied.
6. If case parts are short supplied please contact a Hussmann representative within 48 hours.
Note:-
Contact a Hussmann representative immediately
within 48 hours of damage case or missing parts
with photos and documentation.
