IFM Electronic Efector 200 Bedienungsanleitung

Operating instructions

Diffuse reflection sensor with

background suppression

OGH7xx

704076 / 03 06 / 2011

1 Preliminary note

1.1 Symbols used

►Instruction

> Reaction, result

[…] Designation of pushbuttons, buttons or indications

→Cross-reference

Important note

Non-compliance can result in malfunctions or interference.

2 Safety instructions

According to the cULus approval

Caution - Use of controls or adjustments or procedures other than those specified

herein may result in hazardous radiation exposure.

Visible laser light; CLASS 1 LASER PRODUCT.

IEC 60825-1 : 2007

Complies with 21 CFR 1040.10 except for deviations pursuant to Laser

Notice No. 50, dated June 2007.

Position of the product label Additional label

3 Functions and features

The diffuse reflection sensor detects objects and materials without contact and

indicates their presence by a switching signal.

Range 20 ... 200 mm (on white paper 200 x 200 mm, 90 % remission)

4 Installation



1: LED

2: programming buttons

►Align the diffuse reflection sensor to the object to be detected.

►Secure it to a bracket.

Note:

The objects to be detected are to move transver-

sally to the lens of the sensor.

►In case of other directions of movement

it should be tested before whether safe

switching is guaranteed.

5 Electrical connection

The unit must be connected by a qualified electrician.

►The national and international regulations for the installation of electri-

cal equipment must be adhered to.

►Voltage supply according to EN 50178.

►Disconnect power.

►Connect the unit as follows:

DC PNP











pin 1 = L+ ( 10...36 V DC )

pin 3 = L-

pin 4 = load (200 mA)

(pin 2 = not connected)

DC NPN











pin 1 = L+ ( 10...36 V DC )

pin 3 = L-

pin 4 = load (200 mA)

(pin 2 = not connected)

6 Settings

6.1 The sensor is to switch when the object is detected

►Position the object





►Press [OUT on] for 2 s.

> The sensitivity is set to the object.

> The LED flashes.

►Remove the object





►Press [OUT off].

> The sensitivity is set without object.

> The LED goes out. The programming is finished.

6.2 The sensor is not to switch when the object is detected

►Position the object (see figure 1) and press [OUT off] for 2 s.

►Remove the object (see figure 2) and press [OUT on].

The setting can also be carried out first without object and then with object.

6.3 Setting of the maximum sensitivity

►Align the sensor so that no light is reflected.

The sensor is to switch when the object is detected

►First press [OUT on], then [OUT off].

The sensor is to switch when the object is not detected

►First press [OUT off], then [OUT on].

6.4 Programming unsuccessful

> The LED flashes quickly, 8 Hz.

• Measured value difference too small

• Max. programming time (15 min.) exceeded.

6.5 Electronic lock

Lock or unlock the buttons

►Press [OUT on] and [OUT off] simultaneously for 10 s.

> Acknowledgement is indicated by a change of the LED status.

7 Operation

►Check whether the unit operates correctly.

> The LED lights when the switching output is switched.

8 Maintenance, repair and disposal

►Keep the front pane of the sensor free from soiling.

►For cleaning do not use any solvents or cleaning agents which could damage

the plastic material.

►Do not try to open the module enclosure. There are no user - serviceable

components inside.

Technical data and further information at

www.ifm.com→Selectyourcountry→Datasheetdirect:

Andere Handbücher für Efector 200

Inhaltsverzeichnis

Andere IFM Electronic Zubehör Handbücher

IFM Electronic

IFM Electronic efector 160 LR8300 Bedienungsanleitung

IFM Electronic

IFM Electronic efector 250 Bedienungsanleitung

IFM Electronic

IFM Electronic PY2954 Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

IFM Electronic

IFM Electronic efector 300 SU7000 Bedienungsanleitung

IFM Electronic

IFM Electronic efector 300 SU8200 Bedienungsanleitung

IFM Electronic

IFM Electronic efector 200 OJ Series Bedienungsanleitung

IFM Electronic

IFM Electronic LR2059 Bedienungsanleitung

IFM Electronic

IFM Electronic LR2759 Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 200 Installationsanleitung

IFM Electronic

IFM Electronic O5E5 A Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 200 OI Series Bedienungsanleitung

IFM Electronic

IFM Electronic PI209 Series Bedienungsanleitung

IFM Electronic

IFM Electronic efector200 OL Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 300 Bedienungsanleitung

IFM Electronic

IFM Electronic efector 200 OIH5 Series Bedienungsanleitung

IFM Electronic

IFM Electronic EFECTOR 500 PI26 Bedienungsanleitung

IFM Electronic

IFM Electronic LK1022 Bedienungsanleitung

IFM Electronic

IFM Electronic efector180 IX50 Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 300 SA1000 Bedienungsanleitung

IFM Electronic

IFM Electronic efector200 OJ Bedienungsanleitung

IFM Electronic

IFM Electronic efector100 GG507S Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 500 PN3 Bedienungsanleitung

IFM Electronic

IFM Electronic KQ5 Series Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung

Axminster

Axminster Tooling Stylus Tip Ballpoint Pen Kit Bedienungsanleitung