thermal imager. When an infrared image is displayed in the eyepiece, the thermal imager enters
the operating status, and the indicator is on.
WARNING! The lens of the device must not be pointed at any sources of intense
radiation energy, such as laser-emitting devices or the sun. This may damage the electronic
components in the device. Damage caused by failure to comply with the operating guidelines
is not covered under warranty.
VII. Powering Off
Press and hold the Power button. The shutdown countdown screen will appear. When the
countdown counts from 3 to 0, the device shuts down. Then, you can release the Power button.
The current status will be automatically saved after shutdown. When the device is powering off
and saving data, do not disconnect it from the power source. Otherwise, the data cannot be
saved.
VIII. Standby
When the device is powered on, press the Power button to enter the standby status. Press the
Power button again to wake up the device. Then the thermal imager enters the operating status.
IX. Turning On/Off the LED Indicator
The AFFO series is equipped with the LED indicator. You can quickly turn on the LED
indicator. When the device is powered off, press the ↑button to turn on the LED indicator, and
release the ↑button to turn off the LED indicator (the LED indicator cannot be turned on when the
device is turned on).
X. Switching the Image Mode
Setting the image mode: Press the ↑button to open the image palette mode, which is
white-hot, black-hot, palette, red-hot, and sky bird in sequence. The icon on the top status bar is
updated in real-time.
XI. DiopterAdjustment
The diopter adjustment knob is used to adjust the eyepiece diopter for users with different
degrees of myopia.
XII. Laser Locating
