Intellinet 524803 Bedienungsanleitung

WIRELESS

150N

PORTABLE

3G ROUTER

QUICK

INSTALL

GUIDE

MODEL 524803

INT-524803-QIG-1009-02

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™

Wireless 150N Portable 3G Router, Model 524803.

This quick install guide presents the basic steps required to set up and

operate this device. For detailed instructions and specications, refer to

the user manual on the enclosed CD or at www.intellinet-network.com.

Easy-to-follow instructions in this guide and the user manual help make

installation of the switch quick and simple, so you’ll soon be enjoying the

benets of these features:

• Supports UMTS/HSDPA and EVDO 3G networks

• Up to 150 Mbps network link speed

• Complies with 2.4 GHz Draft IEEE 802.11n standard and is

backward compatible with IEEE 802.11g/b standards

• Supports WMM to meet the multimedia data bandwidth requirements

• Supports Wi-Fi Protected Setup (WPS)

• Supports WAN connection auto fail-over

• Supports WEP and WPA/WPA2 (TKIP and AES) data encryption

• DHCP server supports static lease management

• Supports virtual server, port forwarding and DMZ (demilitarized zone)

• Supports DDNS (dynamic DNS)

• Supports UPnP (Universal Plug and Play)

• Integrated anti-DOS rewall

• QoS (Quality of Service) bandwidth management

• VPN Passthrough (PPTP/IPSec)

• Integrated USB 2.0 port for UMTS/HSDPA and EVDO 3G modems

• Easy installation through Web-based user interface

• Lifetime Warranty

Package Contents

• Wireless 150N Portable 3G Router

• Quick install guide, plus user manual on CD

• Power adapter

• Built-in rechargable Li-ion battery

• Ethernet Cat5 RJ45 cable: 1.0 m (3 ft.)

• USB extension cable: 1.0 m (3 ft.)

• Carrying case and car charger

REGULATORY STATEMENTS

Federal Communications Commission (FCC)

FCC Part 15

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

4. Consult the dealer or an experienced radio technician for help.

FCC Caution

This equipment must be installed and operated in accordance with provided

instructions, and a minimum 20 cm spacing must be provided between

computer mounted antenna and person’s body (excluding extremities of

hands, wrists and feet) during wireless modes of operation.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: 1) This device may not cause harmful

interference; and 2) This device must accept any interference received,

including interference that may cause undesired operation.

Any changes or modications not expressly approved by the party

responsible for compliance could void the authority to operate equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an

uncontrolled environment. In order to avoid the possibility of exceeding

the FCC radio frequency exposure limits, human proximity to the antenna

shall not be less than 20 cm (8 inches) during normal operation.

The antenna(s) used for this transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

The equipment marketed in the U.S. is restricted to usage of channels 1-11.

R&TTE Compliance Statement

This equipment complies with all the requirements of Directive 1999/5/

EC of the European Parliament and the Council of March 9, 1999, on

radio equipment and telecommunication terminal Equipment and the

mutual recognition of their conformity (R&TTE).

The R&TTE Directive repeals and replaces in the directive 98/13/EEC

(Telecommunications Terminal Equipment and Satellite Earth Station

Equipment) as of April 8, 2000.

Safety

This equipment is designed with the utmost care for the safety of those

who install and use it. However, special attention must be paid to the

dangers of electric shock and static electricity when working with electrical

equipment. All guidelines of this and of the computer manufacture must

therefore be allowed at all times to ensure the safe use of the equipment.

EU Countries Intended for Use

The ETSI version of this device is intended for home and ofce use in

Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland,

Italy, Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the

United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member

states: Iceland, Liechtenstein, Norway, and Switzerland

EU Countries Not Intended for Use

None.

Modem

USB port

Cover Battery

Power adapter

PWR/CHG

LED

HARDWARE SETUP/CONNECTIONS

Charging the Battery

Before using the router, the battery needs to be charged. Charging the

battery takes about four hours.

1. Remove the battery

compartment cover

on the back of the

router, insert the

included battery, then

replace the cover, sliding it until the

latch snaps securely back in place.

2. Plug the included power adapter into

an AC outlet or an automobile’s auxiliary

power outlet, then connect it to the mini USB

port on the router (DC In). While the router battery

is charging, the PWR/CHG LED lights orange, then turns green when

the router battery is fully charged.

3. On the left side panel, set the On/Off switch to

On. CAUTION: Always switch the router off

before removing the battery, and only use the

battery and power adapter included with the

router, as other types could be dangerous and damage the router.

Network Connections

If needed, visit www.intellinet-network.com for a complete list of compatible

3G USB modems.

1. Connect your 3G / 3.5G USB

modem to the USB port on the

top panel of the router.

2. Connect your computer to the Ethernet port

on the right side panel of the router. NOTE:

It’s recommended that you use a cable

connection through the Ethernet port for the

router’s initial conguration. The PWR/CHG LED should be lighted

green and the Ethernet LED should be on if the computer or other

network device connected to the router’s Ethernet port is turned on

and connected properly.

NETWORK SETUP

The following steps are for the preliminary network setup of the router

using a Web browser, which will make the router operational and ready

for advanced conguration based on procedures in the user manual.

NOTE: Screen images of other Windows operating systems are similar.

Some screen images have been modied to t the format of this guide.

1. Set your computer to

obtain an IP address

from a wireless router:

Click “Start” (typically

located in the lower-

left corner of your PC),

then Control Panel;

double-click Network

Connections, then

double-click Local

Area Connection; and

lastly, on the Local

Area Connection

Status screen, click

“Properties.”

2. When the Local Area

Connection Properties

screen appears, select

“Internet Protocol

(TCP/IP),” then click

“Properties.”

3. Select “Obtain an IP

address automatically”

and “Obtain DNS

server address

automatically,” then

click “OK.”

4. Once the IP address

setup is complete,

click “Start” on the

desktop again, then

click “Run.” At the rst

DOS prompt, enter

“cmd” and click “OK.”

5. When the next prompt screen appears, enter “ipcong,” then press

<Enter> on your keyboard. Note the IP address and default gateway.

HERE!

6. Open the Web browser and

enter the IP address of the

router in the address bar.

When the prompt screen at

right appears, enter “admin”

(the default entry) in the

“User name” text eld; and

“1234” (the default entry), in

the “Password” text eld.

Click “OK” to access the

Web management interface

of the router.

7. When the main menu screen of the Web management interface

displays, click “Quick Setup” on the left.

8. When the subsequent Time Zone screen displays, select your local

time zone from the drop-down menu and click “Next.”

9. When the subsequent Broadband Type screen displays, select “3/3.5G”

from among the Internet connection options, then click “Next.”

10. Enter the Internet connection parameters required by your 3G/3.5G

service provider, then click “OK.”

Andere Handbücher für 524803

Inhaltsverzeichnis

Andere Intellinet Netzwerk-Router Handbücher

Intellinet

Intellinet 560405 Bedienungsanleitung

Intellinet

Intellinet 560559 Bedienungsanleitung

Intellinet

Intellinet 516204 Bedienungsanleitung

Intellinet

Intellinet 524049 Bedienungsanleitung

Intellinet

Intellinet 561044 Bedienungsanleitung

Intellinet

Intellinet 560535 Bedienungsanleitung

Intellinet

Intellinet 530347 Bedienungsanleitung

Intellinet

Intellinet 530347 Bedienungsanleitung

Intellinet

Intellinet Network Solutions 523462 Bedienungsanleitung

Intellinet

Intellinet 522205 Bedienungsanleitung

Intellinet

Intellinet 523615 Bedienungsanleitung

Intellinet

Intellinet 523523 Bedienungsanleitung

Intellinet

Intellinet 530347 Bedienungsanleitung

Intellinet

Intellinet 560849 Bedienungsanleitung

Intellinet

Intellinet 524988 Bedienungsanleitung

Intellinet

Intellinet 524636 Bedienungsanleitung

Intellinet

Intellinet 560559 Bedienungsanleitung

Intellinet

Intellinet 521246 Bedienungsanleitung

Intellinet

Intellinet 523776 Bedienungsanleitung

Intellinet

Intellinet 524377 (Annex b) Bedienungsanleitung

Intellinet

Intellinet 560931 Bedienungsanleitung

Intellinet

Intellinet 505093 Bedienungsanleitung

Intellinet

Intellinet 560801 Bedienungsanleitung

Intellinet

Intellinet 561457 Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise

LevelOne

LevelOne FBR-1416 Bedienungsanleitung