Interacoustics Titan ABRIS Bedienungsanleitung

8104738 Rev. 2 – 2019/03 Page 1of 2

Quick Guide

Titan ABRIS handheld

PREPARE THE EQUIPMENT

1. Turn on Titan by pressing the R or L button.

2. Choose the test protocol from the list using the up & down arrow keys and then press Select.

3. To use a different protocol than the one selected, press Protocol and then repeat step 2 above.

4. Select the transducer (only if more than one connected to the preamplifier).

5. Select the ear for testing.

TEST ENVIRONMENT

The ideal test environment is a quiet room where lights and other electronic equipment are turned off.

PREPARE THE INFANT

Patient state

The infant should be sleeping or in quiet relaxed state.

Sucking, blinking, crying or movement may affect testing.

Skin preparation

Typically, no skin preparation is required.

If the infant’s skin is oily, the electrode placement sites should be cleaned using

alcohol wipes and/or skin preparation gel.

Use a conductive gel with the electrodes to improve impedances.

Place electrodes

Place surface electrodes using the desired montage (mastoid or nape).

Connect cables

Connect the cables from the PreAmplifier to the respective surface electrodes.

CHECK IMPEDANCE

Impedances are indicated by the green/amber dots on the infant as well as in numerical format on screen.

When the dot is amber, this means the impedance

is poor (> 40kΩ). In this instance, it may be

necessary to clean the skin and replace the

surface electrode.

NB. Testing is possible when impedances are

poor. This may, however, affect test time and

measurements.

8104738 Rev. 2 – 2019/03 Page 2of 2

PLACE TRANSDUCER/S

Place the probe or insert earphones in the infant’s ear/s or place the headset over the infant’s ears.

The probe light will turn green when a good seal is obtained.

RUN TEST

Press the START button on the Titan or press the preamplifier button.

PATIENT NOISE (EEG)

After starting the test, the patient noise/EEG bar is displayed at the top of the screen.

If the patient noise goes above the black line, try to calm the

infant to reduce movement, crying, sucking etc.

If the infant appears calm and the patient noise is not ideal,

stop the test and select a protocol with a higher rejection

level (if available).

If the patient noise/EEG signal is still not ideal, refer to the

EEG troubleshooting section below.

RESULTS

PASS result

REFER result

PASS – when the result reaches 100% for the pass criteria, PASS is displayed in green above the

measurement.

REFER – when the result does not reach 100% for the pass criteria within the measurement time, REFER is

displayed in amber above the measurement.

INCOMPLETE – if the test is stopped before a PASS or REFER is generated by the system, INCOMPLETE

is displayed above the measurement indicating that the full test was not completed.

EEG TROUBLESHOOTING

When the patient noise/EEG signal is poor, and the patient is calm, try the following:

•Turn off (if possible) all electronic devices/sources, such as lights, computers, mobile phones etc.

•Ensure that the Titan battery is not being charged (via the cradle) during testing

•If impedances were initially poor, clean the skin/use conductive gel and replace the electrodes

Inhaltsverzeichnis

Andere Interacoustics Medizinische Geräte Handbücher

Interacoustics

Interacoustics Aqua Stim Bedienungsanleitung

Interacoustics

Interacoustics VRA201 Bedienungsanleitung

Interacoustics

Interacoustics OtoRead Bedienungsanleitung

Interacoustics

Interacoustics ASSR Bedienungsanleitung

Interacoustics

Interacoustics Air Fx Bedienungsanleitung

Interacoustics

Interacoustics AS608 Bedienungsanleitung

Interacoustics

Interacoustics Sera Bedienungsanleitung

Interacoustics

Interacoustics EyeSeeCam vHIT Bedienungsanleitung

Interacoustics

Interacoustics Orion Bedienungsanleitung

Interacoustics

Interacoustics affinity 2.0 Installationshandbuch

Interacoustics

Interacoustics Virtual SVV Bedienungsanleitung

Interacoustics

Interacoustics AD528 Bedienungsanleitung

Interacoustics

Interacoustics Affinity2.0 Bedienungsanleitung

Interacoustics

Interacoustics OtoRead Bedienungsanleitung

Interacoustics

Interacoustics Nydiag 200 Bedienungsanleitung

Interacoustics

Interacoustics Eclipse EP15 Bedienungsanleitung

Interacoustics

Interacoustics VisualEyes 515 Installationshandbuch

Interacoustics

Interacoustics VisualEyes 515 Bedienungsanleitung

Interacoustics

Interacoustics VF405 Bedienungsanleitung

Interacoustics

Interacoustics VisualEyes 515 Bedienungsanleitung

Interacoustics

Interacoustics VisualEyes 505 Bedienungsanleitung

Interacoustics

Interacoustics Eclipse Bedienungsanleitung

Interacoustics

Interacoustics Eclipse Installationshandbuch

Interacoustics

Interacoustics Titan Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung