Intersil ISL28470EVAL1Z Bedienungsanleitung
1
®
AN1289.0
ISL28470EVAL1Z Evaluation
Board User’s Guide
Introduction
The ISL28470EVAL1Z evaluation board is a design platform
containing all the circuitry needed to characterize critical
performance parameters of the ISL28470 Quad
Instrumentation Amplifier using a variety of user defined test
circuits.
The ISL28470 is a quad channel instrumentation amplifier
optimized for 2.4V to 5V single supplies. The device features
an Input Range Enhancement Circuit (IREC) which
maintains CMRR performance for input voltages equal to the
positive supply and down to 50mV above the negative
supply rail. The input signal is capable of swinging above the
positive supply rail and to the negative supply with only a
slight degradation of the CMRR performance. The output
operation is rail to rail. The ISL28270 is compensated for a
minimum gain of 100.
Reference Documents
• ISL28470 Data Sheet, FN6260
Evaluation Board Key Features
The ISL28470EVAL1Z is designed to be operated from a
single supply (+2.4VDC to +5VDC), or from split supplies
(±1.2VDC to ±2/5V). The board is configured for 4
independent instrumentation amplifiers connected for a
closed loop gain of 101 with inverting and non-inverting high
impedance terminated with 100k resistors to ground. Each
amplifier contains it’s own VREF input to establish an input
common mode reference. An ENABLE select switch is
provided for each amplifier to be used to save power by
powering the device down.
Power Supplies (Refer to Figure 1)
External power connections are made through the +V, -V
and Ground connections on the evaluation board. For single
supply operation, the -V and Ground pins are tied together to
the power supply negative terminal. For split supplies, +V
and -V terminals connect to their respective power supply
terminals. De-coupling capacitors, C1and C2, connect to
ground through R1 and R2, 0Ωresistors. Resistors R3and
R4are 0Ωbut can be changed by the user to provide power
supply filtering, or to reduce the voltage rate-of-rise to less
than ±1V/µs. Anti-reverse diodes D1and D2protect the
circuit in the case of accidental polarity reversal.
FIGURE 1. POWER SUPPLY CIRCUIT
R3
R4
C10
C9
D2
R1C1
C2
J3J2J1
D1
R2
GND V-V+
V-
V+
VP
0.1µF 0.1µF
VM
11
11
22
22
0
0
004.7µF 4.7µF
++
-
+
-
+
IN+
IN-
FB+
FB-
RF
RG
VREF(x)
IN+(x)
IN-(x)
GND 100kΩ
1kΩ
100kΩ
100kΩVOUT(x)
1/4 ISL28470
VP
-V
ENABLE
10kΩ
0Ω
VM
VCM
IN+
IN-
VREF
FIGURE 2. BASIC AMPLIFIER CONFIGURATION
Application Note February 12, 2007
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2007. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
2AN1289.0
February 12, 2007
Amplifier Configuration (Figure 2)
The schematic of each of the 4 Op Amps with the
components supplied is shown in Figure 2. The circuit
implements a differential input instrumentation amp with a
closed loop gain of 101. The circuit can operate from a
single 2.4VDC to +5VDC supply, or from dual supplies from
±1.2VDC to ±2.5VDC.The output common mode reference
is applied to the VREF pin, and has a range from ground
(VM) to VP.
User-selectable Options (Figure 3)
Component pads are included to enable a variety of user-
selectable circuits to be added to the amplifier differential
inputs, the VREF input, and the amplifier feedback loop. A
voltage divider and filter option can be added to establish a
power supply tracking common mode reference at the VREF
input, or a coaxial connection to the ISL28470 FB+ pin can
be made at the FB+ BNC connector. The differential inputs
have additional resistor placements for adding input
attenuation, or to establish input DC offsets through the
VREF pin. FIGURE 3. COMPONENT-SELECTABLE OPTIONS
J9
R6R5
C3OPEN
DNPDNP VREFA
V+V-
J4
VREFA
1
R13 R15
R17
R18
R21
R22 R23
R20
R19
R16
R14
J8
J10
FB+A
-INA
+INA 0
0
0
DNP DNP DNP
DNP
DNP
1k
100k
100k
VREFA
ISL28470EVAL1Z Components Parts List
DEVICE # DESCRIPTION COMMENTS
C1, C2CAP-TANTALUM, SMD, D,4.7µF, 50V, 10%, LOW ESR, ROHS Power Supply Decoupling
C7, C8CAP, SMD, 0603, 0.01µF, 25V, 10%, X7R, ROHS Power Supply Decoupling
C9, C10 CAP, SMD, 0805, 0.1µF, 25V,10%, X7R, ROHS Power Supply Decoupling
C3-C6CAP, SMD, 0805, DNP-PLACE HOLDER, ROHS Optional VREF Filter
Not Populated
C11-C18 CAP, SMD, 0805, DNP-PLACE HOLDER, ROHS Optional Amplifier Feedback Caps
Not Populated
D1, D2DIODE-RECTIFIER, SMD, MELF, 2 Ld, 50V, 1A, GPP, ROHS Reverse Power Protection
U1 ISL28470FAZIC INSTRUMENTATION AMP, 28P, QSOP,
ROHS
R13, R14-R16, R19, R22, R24-R27, R30, R33,
R35-R38,R41, R44, R46-R49, R52, R55, R69,
R71, R73, R75
RESISTOR, SMD, 0603, 0.1%, MF, DNP-PLACE HOLDER User Selectable Resistors
Not Populated
R18, R21, R29, R32, R40, R43, R51, R54, R58,
R60, R63, R66 RES, SMD, 0603, 0Ω, 1/16W, TF, ROHS 0ΩUser Selectable Resistors
R17, R28, R39, R50 RES, SMD, 0603, 1k, 1/10W, 1%, TF, ROHS RGGain Resistors
R59, R61, R65, R67, R70, R72, R74, R76 RES, SMD, 0603, 10k, 1/10W, 1%, TF, ROHS
R20, R23, R31, R34, R42, R45, R53, R56, R57,
R62, R64, R68 RES, SMD, 0603, 100k, 1/10W, 1%, TF, ROHS RFGain Resistors
R1-R4RES, SMD, 0805, 0Ω, 1/8W, TF, ROHS 0ΩUser Selectable Resistors
R5-R12 RES, SMD, 0805, DNP-PLACE HOLDER, ROHS User Selectable Resistors
Not Populated
S1-S4SWITCH-SEALED MINI TOGGLE, TH, 3P, SP, ON/NONE/ON,
GOLD Enable/Disable Select Switches
Application Note 1289
3AN1289.0
February 12, 2007
Application Note 1289
ISL28470EVAL1Z Top View
4
Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without notice. Accordingly, the reader is cautioned to
verify that the Application Note or Technical Brief is current before proceeding.
For information regarding Intersil Corporation and its products, see www.intersil.com
AN1289.0
February 12, 2007
ISL28470EVAL1Z Schematic Diagram
VREFAVREFD VREFC VREFB
V+
GND
V-
VOUT A
VOUT B
VOUT C
VOUT D
+IND
-IND
FB+D
+INC
-INC
FB+C
+INB
-INB
FB+B
+INA
-INA
FB+A
DISABLE
END
ENC
ENA
ENB
ENABLE
ENABLE
DISABLE
DISABLE
ENABLE
DISABLE
ENABLE
0
0
VREFD
0
1
1
VP
2
1
2
VP
R21
VP
VP
1
2
1
1
2
1
2
1
2
1
2
0
1
0
1
3
2
2
ROBERT POSPISIL
ISL28470EVAL1Z
R58
10K
R59
OPEN
C12
R57
100K
C11
OPEN
J20
J21
R60
0
R61
10K
OPEN
C14
R63
0
R65
10K
J22
OPEN
C16
R66
0
OPEN
C18
R67
10K
J23
R68
100K
C17
OPEN
OPEN
C15
100K
R64
OPEN
C13
100K
R62
0.01UF
VM
0.01UF
VP
R15
R16
DNP
DNP
R17
1K
0
R14
DNP
R13
J8
J9
J10
J11
J12 R29
R25
0
DNP
R24
R22
DNP
R23
100K 100K
R20
DNP
R19
0
R18
VREFA
VREFB
DNP
R27
R26
DNP
R28
1K
100K
R31
DNP
R30
0
J13 R32
0
R33
DNP
R34
100K
DNP
DNP
R37
R38
R39
1K
0
R36
DNP
R35
J14
J15
J16 R43
R40
0
R41
DNP
R42
100K
VREFC
100K
R45
DNP
R44
J17
J18
J19
R46
DNP
R47
R51
0
R52
DNP
R53
100K
R48
DNP
R50
1K
R49
DNP
100K
DNP
R55
0
R54
R56
C8
C7
U1
SSOP28
R69
DNP
R70
10K
S1
R72
10K
S2
R71
DNP
R74
10K
S3
DNP
R73
R75
DNP
S4
R76
10K
R2
R1 C1
C2
D1
D2
C9
C10
R3
0
0
R4
0.1UF 0.1UF
4.7UF4.7UF
00
J1
J2J3
R5
DNPDNP
R6
C3
OPEN
OPEN
C4
R8
DNP
R7
DNP
OPEN
C5
DNP
R10
R11
DNP
OPEN
C6
DNP
R12
J7
J6
J5
J4
DNP
R9
VREFA
VREFBVREFCVREFD
V-
V+ V- V+ V- V+ V-
V+
V-V+
VP VM
TITLE:
ENGINEER:
DRAWN BY:
SHEE
DATE
REV:
DAT
E
DESCRIPTION
LTR
ZONE
11
12
7
5
4
3
2
28
27
26
25
24
23
22
21
20
14
13
10
8
6
1
9
15
16
17
18
19
Generic
Pack.
M28.15
Application Note 1289
Inhaltsverzeichnis
Andere Intersil Hauptplatine Handbücher
Intersil
Intersil SL71010BM50EV1Z Bedienungsanleitung
Intersil
Intersil ISL9214AEVAL1Z Gebrauchsanweisung
Intersil
Intersil ISL75051SRHEVAL1Z Bedienungsanleitung
Intersil
Intersil ISL8014AEVAL2Z Montage- und Bedienungsanleitung
Intersil
Intersil ISL97683 Bedienungsanleitung
Intersil
Intersil ISL54211EVAL1Z Bedienungsanleitung
Intersil
Intersil ISL70003ASEHEV2Z Bedienungsanleitung
Intersil
Intersil ISL8216MEVAL1Z Bedienungsanleitung
Intersil
Intersil ISL6252AEVAL2Z Handbuch
Intersil
Intersil ISL62881CGPUEVAL2Z Bedienungsanleitung
Intersil
Intersil ISL5761EVAL1 Bedienungsanleitung
Intersil
Intersil ISL85003EVAL2Z Bedienungsanleitung
Intersil
Intersil ISL800 DEMO1Z Series Bedienungsanleitung
Intersil
Intersil ISL70040SEHEV2Z Bedienungsanleitung
Intersil
Intersil ISL45042EVAL1Z Bedienungsanleitung
Intersil
Intersil ISL3331EVAL1Z Bedienungsanleitung
Intersil
Intersil HIP4086 Bedienungsanleitung
Intersil
Intersil ISL71040MEV1Z Bedienungsanleitung
Intersil
Intersil ISL78268EVAL1Z Bedienungsanleitung
Intersil
Intersil ISL8018EVAL3Z Bedienungsanleitung
Beliebte Hauptplatine Handbücher anderer Marken
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Bedienungsanleitung
Gigabyte
Gigabyte GA-9IVDT Bedienungsanleitung
Texas Instruments
Texas Instruments ADS8372EVM Bedienungsanleitung
Commell
Commell MS-C73 Bedienungsanleitung
IBT Technologies
IBT Technologies MB860 Bedienungsanleitung
Nvidia
Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung
