IRobot ROOMBA 900 SERIES Betriebsanleitung

IMPORTANT INFORMATION

Maintenance Guide

To keep Roomba running at peak performance, it is recommended that you

perform the following maintenance tasks after every use:

Wi-Fi Connected 600 series

600 series

1Remove and empty Roomba’s bin

a. Press the bin release tab and pull to

remove the bin.

b. Open the bin door to empty the bin.

600 Series

e & i Series

900 Series

2Clean Roomba’s lter compartment

a. Pull the lter to remove.

b. Shake off debris by tapping the lter

against your trash container.

c. Clean or replace lter.

600 Series

e & i Series

900 Series

Maintenance Guide

3Clean Roomba’s side brush

a. Use a coin or small screwdriver to

remove the screw.

b. Remove brush, clean the brush and

brush post, and reinstall the brush.

4Clean Roomba’s brushes

a. Remove the brush guard by lifting both

yellow tabs. i series: Push on the green

tab on the right-hand side of the brushes.

b. Remove and clean the brushes and

extractor caps.

c. Ensure the vacuum path is clear, reinstall

the extractors and close the brush guard

(if applicable).

5Clean Roomba’s front wheel

Front caster wheels that are clogged with

hair and debris could result in oor damage.

a. Pull rmly on the front wheel to remove it.

b. Remove any debris from inside

wheel cavity.

c. Spin the wheel by hand.

If rotation is restricted,

remove wheel from its

housing and push rmly

to remove the axle and

clear any debris or hair

wrapped around it.

d. Reinstall all parts when

nished. Make sure the

wheel clicks back into place.

6Clean Roomba’s sensors

a. Wipe the cliff sensors with a clean,

dry cloth.

b. Floor tracking sensor (only applicable

to 900 & i series) – turn Roomba over and

use a clean, Scotch bright sponge or

pencil eraser to wipe any debris that has

accumulated in the round sensor

opening in the right side of the Robot’s

bottom surface. Do NOT spray cleaning

solution directly into sensor opening.

Maintenance Guide

i series

600 series e series

900 series i series

7Clean Roomba’s charging contacts

a. Clean the charging contacts by wiping

the charging contacts on the home

base and Robot with a clean, dry cloth.

You can alternatively use lightly dampened

melamine foam such as a magic eraser or

a clean, Scotch bright sponge to clean the

charging contacts on the home base and

Robot.

b. Clean localisation camera

(only applicable to 900 and i series) –

Wipe the window on the robot’s top

surface using a microbre or soft cotton

cloth that has been lightly dampened

with water or a screen cleaning solution.

8Clean base reporting a bag full

after just a couple runs i series

a. Lift up the lid of the canister lid to open.

b. Pull up on the plastic card leading to

the vacuum port and lift up to pull the

bag out of the canister.

c. Lightly shake the bag.

d. Place the bag into the canister, sliding

the plastic card into the guide rails.

e. Press down on the lid making sure it is

rmly closed.

f. Make sure the vacuum path isn’t clogged.

Maintenance Guide

Charging contacts on the home base

Charging contacts on the Robot

Charging contacts &

docking sensor on

i series Clean Base

900 series i series

Maintenance Guide

TIP: If you notice Roomba picking up less debris

from your oor, empty the bin and clean the

brushes.

9Clear clogged Clean Base™

Charging Station + Automatic Dirt

Disposali series

a. Push down the canister lid to ensure it

is rmly sealed.

b. Remove any debris from the debris

evacuation port on the bottom of the

Clean Base.

c. Unplug the Clean Base® Charging

Station + Automatic Dirt Disposal from

the wall.

d. Place the Clean Base® Charging

Station + Automatic Dirt Disposal

on its side. Loosen the 5 screws

retaining the debris evacuation

tubing on the bottom and then remove

any debris.

e. If issue persists, remove the bag

and use a can of compressed air

to clean any dust particles that may

remain inside the Clean Base®.

Excessive build-up of hair in

Roomba’s brushes and bearings

can permanently damage

Roomba. Inspect brush

bearings regularly.

Do not attempt to run Roomba without the

bearings. If you misplace Roomba’s brush

bearings, contact IXL Home Customer

Service for replacement bearings.

Maintenance Guide

Battery Information

Please take care when removing the pull tab,

if it breaks you will need to open the bottom

cover and make sure that nothing is blocking

the battery connection points.

See “Removing Roomba’s Battery” section

for help on how to open the bottom cover.

Charging Roomba can be done in 2

different ways:

Through the home base OR Directly to the

power supply (bypassing the home base).

Home Base:

Power Supply (in older models):

16-Hour Refresh Charge

If Roomba has been left off of the Home

Base for an extended period, it will automat-

ically initiate a special 16-hour charge cycle.

This extensive charge refreshes the battery

and extends battery life. While charging, the

battery indicator pulses quickly.

For some models, all indicators on the robot

will turn off after 1 minute of charging.

This is normal behaviour, designed to

conserve energy. For best results, do not

interrupt the refresh charge. Charging time

under normal conditions is at least 2 hours.

This is not applicable to the Li-ion battery.

Resetting Roomba’s Battery

Roomba’s battery may need resetting if

its run-time starts shortening over a period

of time.

1. In the Max mode, run the Roomba for

one complete cycle without a home

base present, repeat steps 3 and 4 a

few times. If your Roomba does not

have max mode, run several clean

cycles until Roomba stops and plays

the ‘dead battery’ song.

2. Reset the Roomba charging system.

Do this by removing the battery and

holding down the “clean” button for at

least 20 seconds. Then reinstall the

battery.

3. Plug the charger into Roomba

(avoid using the home base if you have

one so as to ensure the Roomba’s

charging cycle is not interrupted).

4. Charge the battery until the Roomba

power light is solid green and keep the

Roomba on the charger for an additional

72 hours (3 days). Note: Do not

interrupt this charging cycle.

Before you use Roomba for

the rst time, or when returned

from service you may need to

activate Roomba by removing

the battery pull tab, if applicable.

TIP: Never store the battery inside unit until

it is on the home base and charging.

For storage and transporting Roomba, fully

charge the battery and remove the battery.

TIP: For best performance, always store

Roomba on its charging base.

Maintenance Guide

Removing Roomba’s Battery

a. Undo screw and remove side

spinning brush.

b. Remove screws on base plate and

set aside.

c. Remove battery by lifting the pull tabs.

600 Series

900 Series

e & i Series

Australia

Free Call: 1300 727 421

E: [email protected]

New Zealand

Free Call: 0800 727 421

E: [email protected]

Andere Handbücher für ROOMBA 900 SERIES

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere iRobot Staubsauger Handbücher

iRobot

iRobot Roomba Discovery Series 400 Series Bedienungsanleitung

iRobot

iRobot Roomba Bedienungsanleitung

iRobot

iRobot Roomba Bedienungsanleitung

iRobot

iRobot Roomba 500 Series Bedienungsanleitung

iRobot

iRobot Roomba 4110 Bedienungsanleitung

iRobot

iRobot Roomba 900 Bedienungsanleitung

iRobot

iRobot Roomba i6 Bedienungsanleitung

iRobot

iRobot Roomba 700 series Bedienungsanleitung

iRobot

iRobot Roomba Combo j5 Bedienungsanleitung

iRobot

iRobot Cleaning System Bedienungsanleitung

iRobot

iRobot Roomba Combo j5 Bedienungsanleitung

iRobot

iRobot RVE-Y1 Bedienungsanleitung

iRobot

iRobot Roomba Bedienungsanleitung

iRobot

iRobot Discovery/400 series Bedienungsanleitung

iRobot

iRobot R11384 Bedienungsanleitung

iRobot

iRobot Braava 300 Series Bedienungsanleitung

iRobot

iRobot Roomba 570 Bedienungsanleitung

iRobot

iRobot Roomba i5+ Bedienungsanleitung

iRobot

iRobot Roomba Professional Series Bedienungsanleitung

iRobot

iRobot Scooba 5900 Bedienungsanleitung

iRobot

iRobot Roomba e6 Bedienungsanleitung

iRobot

iRobot Roomba 900 Bedienungsanleitung

iRobot

iRobot Roomba 4105 Bedienungsanleitung

iRobot

iRobot Roomba Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch

iRobot ROOMBA 900 SERIES Betriebsanleitung

Beliebte Staubsauger Handbücher anderer Marken