STEP 2: POST INSTALLATION
Starng with the first post, remove the stake from the ground and dig a hole measuring approximately 8” in
diameter and around 22“ deep in the stakes place. Once the hole is dug, posion the post in the hole and
check to make sure the pre-cut holes are facing the direcon the panels will be installed. Using a hammer
and a block of wood (to protect the post) hammer the post into the ground approximately 2-1/2” so the post
is 24-1/2“ below ground level. This will provide stability when pouring concrete and aaching the panel to
the post.
TIP: Measure 49.5” from the boom of the post and mark with chalk or a temporary marker to ensure
proper height placement. The 49.5” mark on the post should align with ground level.
Once the first post is in the ground, pour concrete to fill the hole, filling just enough to provide a slight slant
for water runoff.
Connue with remaining posts.
If installing on a hard surface such as a deck or pao, a flange post must be used and can be installed by
simply mounng the hardware to the surface (screws/bolts not included with flange post). Posts should be
installed at the same width as menoned above.
STEP 3: PANEL INSTALLATION
Each Euro fence post has pre-drilled dimples to mark the drilling locaon for a standard install. Using the
clamps, nuts and bolts included, mount the panel to the post, aligning the edge of the panel in the center of the
two pre-drilled dimples.
