3 of 8
Installation and Connection
www.ironman4x4america.com
Each LED light bar is
designed to be located
inside the three (3) roof
frames fixed to the rear
awning mounting plate.
It is important that the
mounting surface for the
adhesive mounting strips
is clean and free from
dirt and debris before
the light bar is attached.
It is recommended that
the each light bar is
positioned 100mm from
the end of the roof frame.
Connect the 3-way splitter to the light bars, connect to the inline control and then to the power lead.
CONNECTION DIAGRAM
NOTE: Ensure that the light bars are disconnected, and the cables are tucked away inside the roof frame
before packing the awning away, failure to do so may result in damage to the light kit or awning.
Multi Use
Cigarette Lighter Fitting
3 Way SplitterPower/Brightness
Control
OPERATION
• Connect to a suitable 12VDC power source
• Press the Power / Mode button (Center of controller)
• Select the light color by pressing the Power / Mode button until the desired color is achieved
• Adjust the brightness by pressing the + or – button
• Turn off pressing Power/Mode button
