ITI 351 Installations- und Betriebsanleitung

351 Installation and

Reference Manual

351 Access Point Manager

Installation and Reference Manual

For reprints, order manual: 466-1000, Revision C

Printed in the U.S.A.

651/777-2690

651/779-4890

Notice

State and local fire/life safety codes prohibit the use of access control devices on emergency

exits without providing an approved alternate method of exiting the controlled area.

Emergency exits must be capable of operation by people who are physically handicapped

and by those who have no knowledge of the system. The approval of an alternative exit

method should always be obtained in writing from the appropriate agency involved. In

most cases, this is the state or local fire marshal. The owner should be instructed to obtain

this approval in writing before installing the equipment.

ITI access control systems were not designed to be primary notification devices in a fire or

life safety system. These fire or life safety systems should be monitored and controlled by

devices designed by the manufacturer of those systems. ITI access control systems may be

used as secondary or auxiliary stations, as long as they do not interfere with the operation of

the primary device.

ITI makes no representations or warrantees with respect to the contents hereof and

specifically disclaims any implied warranties of merchantability or fitness for any particular

purpose. Further, ITI reserves the right to revise this publication and to make changes from

time to time in the contents hereof without obligation of ITI to notify any person of such

revision or changes.

All rights strictly reserved. No part of this document may be reproduced, copied, adapted,

or transmitted in any form or by any means without written permission from ITI. Copyright

protection claim included all forms and matters of copyrightable material and information

now allowed by statutory or judicial law, including but not limited to, material generated

from the software programs, which are displayed on the screen, such as icons, screens

display looks, etc.

Trademarks:

ITI is a trademark of Interactive Technologies, Inc.

Table of Contents

List of Figures.................................................................................................................7

List of Tables................................................................................................................... 8

List of Command References........................................................................................ 9

List of Examples........................................................................................................... 10

1. About This Manual ................................................................................................... 11

1.1. Parts of This Manual..............................................................................................................................11

1.2. Manual Conventions...............................................................................................................................13

2. Product Overview..................................................................................................... 14

2.1. Basic Operations.....................................................................................................................................14

2.2. Schedules.................................................................................................................................................15

2.2.1. Holidays..........................................................................................................................................15

2.2.2. TimeSchedules ...............................................................................................................................16

2.2.3. Daylight Savings ............................................................................................................................16

2.3. Doors........................................................................................................................................................17

2.3.1. Entrance/Exit Devices....................................................................................................................17

2.3.2. Door Strike .....................................................................................................................................17

2.4. Inputs.......................................................................................................................................................17

2.4.1. Normal State...................................................................................................................................18

2.4.2. Supervision.....................................................................................................................................18

2.4.3. Scheduling......................................................................................................................................19

2.4.4. Door Position and Egress ...............................................................................................................19

2.5. Outputs....................................................................................................................................................19

2.5.1. Operation........................................................................................................................................19

2.5.2. Scheduling......................................................................................................................................19

2.6. Options.....................................................................................................................................................19

2.6.1. Denied Access................................................................................................................................19

2.6.2. Interlocking ....................................................................................................................................19

2.6.3. Security System Arm / Disarm.......................................................................................................20

2.6.4. Panic...............................................................................................................................................20

2.6.5. Wireless Point Control ...................................................................................................................20

2.6.6. Occupancy Monitoring...................................................................................................................21

2.7. Cardholder Database .............................................................................................................................21

2.7.1. ID Attributes...................................................................................................................................21

2.7.2. Master Learn / DeleteCards............................................................................................................21

2.8. System Status ..........................................................................................................................................21

2.8.1. Event Reporting..............................................................................................................................21

2.8.2. Reader LED Indications.................................................................................................................22

2.9. Miscellaneous ......................................................................................................................................... 23

2.9.1. Password........................................................................................................................................ 23

2.9.2. Site Code........................................................................................................................................ 23

2.9.3. Customizable Magnetic Stripe Format.......................................................................................... 23

2.10. Power Supply........................................................................................................................................ 23

2.10.1. Power Input.................................................................................................................................. 23

2.10.2. Power Output............................................................................................................................... 23

3. Installation Planning.................................................................................................24

3.1. Schedules................................................................................................................................................. 24

3.1.1. Holidays......................................................................................................................................... 24

3.1.2. Time Schedules.............................................................................................................................. 25

3.1.3. Daylight Savings Time Changes ................................................................................................... 26

3.2. Hardware................................................................................................................................................ 27

3.2.1. Option Kits..................................................................................................................................... 27

3.2.2. Doors.............................................................................................................................................. 27

3.2.3. Inputs ............................................................................................................................................. 28

3.2.4. Outputs........................................................................................................................................... 29

3.2.5. Options........................................................................................................................................... 29

3.2.6. Readers and Keypads..................................................................................................................... 30

3.2.7. Site Codeand Terminal Baud Rate ................................................................................................ 31

3.2.8. Magnetic Stripe Card Data Format................................................................................................ 31

3.2.9. System Power ................................................................................................................................ 34

3.3. Database.................................................................................................................................................. 34

3.3.1. Cardholders.................................................................................................................................... 34

3.3.2. Master Learn / Delete Cards.......................................................................................................... 35

4. Mounting and Wiring ................................................................................................37

4.1. Equipment List....................................................................................................................................... 37

4.1.1. Power Supply................................................................................................................................. 37

4.1.2. Door Peripherals............................................................................................................................ 37

4.1.3. Optional Add-On Kits.................................................................................................................... 37

4.1.4. Communications............................................................................................................................ 37

4.2. Mounting the APM and Peripherals.................................................................................................... 38

4.3. Wiring the APM and Peripherals......................................................................................................... 39

4.3.1. WiringGuidelines........................................................................................................................... 39

4.3.2. Stripping Shielded Cable............................................................................................................... 39

4.3.3. Grounding Shielded Cable............................................................................................................. 39

4.4. Wiring the Power Supply and Grounding........................................................................................... 41

4.4.1. Wiring an AC Power Supply......................................................................................................... 41

4.4.2. Wiring a DC Power Supply........................................................................................................... 42

4.5. Wiring the Outputs................................................................................................................................ 43

4.6. Wiring the Terminal.............................................................................................................................. 45

4.6.1. Configuring the Terminal.............................................................................................................. 45

4.7. Wiring the Readers and/or Keypads.................................................................................................... 46

4.8. Wiring the Inputs................................................................................................................................... 47

4.9. Applying Power...................................................................................................................................... 47

4.9.1. Prepower Checklist........................................................................................................................ 47

4.9.2. Powering Up.................................................................................................................................. 48

4.10. Wiring the Backup Battery..................................................................................................................48

4.10.1. Testing Communications..............................................................................................................48

5. Introduction to Programming.................................................................................. 50

5.1. Programming Conventions....................................................................................................................50

5.1.1. The Ready> Prompt........................................................................................................................50

5.1.2. Aborting Commands ......................................................................................................................50

5.1.3. Command Responses......................................................................................................................50

5.2. List of APM Commands.........................................................................................................................51

5.3. Command Entry Mode ..........................................................................................................................52

5.3.1. Entering Command Entry Mode: LOGON ....................................................................................52

5.3.2. Obtaining a List of Commands: HELP...........................................................................................53

5.3.3. Exiting Command Entry Mode LOGOFF......................................................................................53

5.4. General Procedure for Entering Commands.......................................................................................53

6. Reports......................................................................................................................54

6.1. Full Report..............................................................................................................................................54

6.1.1. Power..............................................................................................................................................56

6.1.2. Inputs..............................................................................................................................................56

6.1.3. Outputs ...........................................................................................................................................56

6.1.4. Lock Status.....................................................................................................................................57

6.1.5. TimeSchedules ...............................................................................................................................57

6.1.6. Holidays..........................................................................................................................................57

6.1.7. Daylight Savings ............................................................................................................................57

6.1.8. Options ...........................................................................................................................................57

6.1.9. Doors ..............................................................................................................................................58

6.1.10. Panic.............................................................................................................................................58

6.1.11. Site Code ......................................................................................................................................58

6.1.12. Reader Type .................................................................................................................................58

6.1.13. Reader Led Type ..........................................................................................................................58

6.1.14. Master Learn Cards ......................................................................................................................58

6.1.15. NUMBER OF IDS IN DBASE ....................................................................................................59

6.1.16. Cardholder Database Percentage Full...........................................................................................59

6.2. Event Reports..........................................................................................................................................59

6.3. Cardholder Reports................................................................................................................................60

6.3.1. Category Reports............................................................................................................................60

6.3.2. Cardholder Attributes.....................................................................................................................61

6.3.3. Badge Reports ................................................................................................................................63

6.3.4. NameReports..................................................................................................................................64

7. Programming Your 351............................................................................................ 65

7.1. Basic Setup Commands..........................................................................................................................65

7.1.1. APM Name: APM..........................................................................................................................65

7.1.2. Current Date: DATE.......................................................................................................................65

7.1.3. Current Time: TIME.......................................................................................................................66

7.2. Schedule SetupCommands.....................................................................................................................67

7.2.1. Holidays: HOL ...............................................................................................................................67

7.2.2. Time Schedules: TS........................................................................................................................68

7.2.3. Daylight Savings Time Changes: DLS...........................................................................................70

7.3. Hardware Setup Commands..................................................................................................................70

7.3.1. Door Setup DOOR..........................................................................................................................71

7.3.2. Inputs and Outputs: IO ...................................................................................................................72

7.3.3. Options: OPT..................................................................................................................................74

7.3.4. Panic Settings: PANIC ...................................................................................................................77

7.3.5. Card Readers: RDR........................................................................................................................78

7.4. Miscellaneous Setup Commands...........................................................................................................78

7.4.1. Password: PSW...............................................................................................................................78

7.4.2. Site Code: SC .................................................................................................................................79

7.4.3. Magnetic StripeCard Format: SETMAG........................................................................................79

7.5. Control Commands ................................................................................................................................81

7.5.1. Unlock Readers: REL.....................................................................................................................81

7.5.2. Lock Readers: LOCK.....................................................................................................................82

8. Setting Up and Maintaining the Cardholder Database..........................................83

8.1. Attributes.................................................................................................................................................83

8.1.1. Card Number ..................................................................................................................................83

8.1.2. PIN Number....................................................................................................................................83

8.1.3. Cardholder Name............................................................................................................................83

8.1.4. Time Schedules ..............................................................................................................................83

8.1.5. Category .........................................................................................................................................83

8.1.6. Option Privileges............................................................................................................................83

8.2. Adding Individual Cards or PINs .........................................................................................................84

8.2.1. Adding Cards at the Card Reader...................................................................................................84

8.2.2. Adding a PIN, Card, or a Group of Cards with DBASE................................................................84

8.3. Adding A Group of Cards......................................................................................................................85

8.4. Modifying a Card or PIN.......................................................................................................................86

8.5. Deleting Individual Cards or PINs........................................................................................................87

8.6. Deleting a Group (Block) of Cards........................................................................................................87

8.7. Master Learn / Delete Cards: LEARN.................................................................................................88

8.7.1. Adding Master Learn / Delete Cards..............................................................................................89

8.7.2. Deleting a Master Learn / Delete Card...........................................................................................90

8.7.3. Adding or Deleting Cards With Master Learn / Delete Cards........................................................90

9. Testing and Troubleshooting...................................................................................91

9.1. Testing Procedures.................................................................................................................................91

9.1.1. Testing Inputs.................................................................................................................................91

9.2. Testing Outputs.......................................................................................................................................92

9.2.1. Testing Readers..............................................................................................................................93

9.2.2. Testing Keypads.............................................................................................................................94

9.2.3. Testing Backup Power....................................................................................................................95

9.3. Reasons Why Outputs Are Active.........................................................................................................95

9.4. Troubleshooting......................................................................................................................................95

10. Appendix A: Specifications..................................................................................103

11. Appendix B: 351 Installation Planning Form......................................................104

12. Appendix C: 351Schedules Planning Form........................................................108