JL Audio Stealthbox SB-T-CAM/12W3v3 Bedienungsanleitung

INSTALLATION GUIDE

for the

SB-T-CAM/12W3v3

SKU#94437

2000

Thank you for choosing a JL Audio Stealthbox®for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox®installed by your authorized JL Audio

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation,

please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox®be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

S T E P 1

Remove any contents from the trunk so that you have a

clean area to work in.

Continued on Next Page

S T E P 2

Remove both of the hardboard floor inserts

S T E P 3

The Jack and it’s mounting foam will be removed from the

compartment on the passengers side of the trunk floor.

SB-T-CAM/12W3V3 INSTR_SKU# 011284

INSTALLATION

D I F F I C U LT Y :

OUT

ESTIMATED TIME:

23 HOURS

Continued on Next Page

SB-T-CAM/12W3V3 INSTR_SKU# 011284

S T E P 7

Align the jack so that the bolt that secures the spare can be

re-inserted thru the wheel and, jack thereby securing both in

the spare tire well.

S T E P 6

Use the strap that was removed in STEP 4 to secure the jack

to the spare wheel.

S T E P 5

Remove the spare tire and turn it over. Put the jack inside

the wheel and, expand it so that the pressure from the jack

holds it in place.

S T E P 4

Remove the strap that secured the Jack to the locating foam,

this will be re-used to secure the jack to the spare tire.

Page 2 • JL Audio, Inc 2008

S T E P 9

Remove the trunk liner fastening plug, this will be replaced

by one of 1/4-20 Rivet Nuts (see detailed picture of the Rivet

Nut below). Enlarge the hole using a 3/8” drill bit and, drill.

*CAUTION*

Before drilling, always make sure that you are not

going to be drilling into any gas lines, brake lines,

transmission lines, electrical wiring, exhaust systems

or anything else that might cause a reduction in

your weekly pay. Always wear eye protection when

drilling.

STEP 11

The anchor point for the cargo net needs to be removed for

the installation of the Stealthbox®.

STEP 10

Insert the 1/4-20 Rivet Nut into the appropriate hole and,

expand it by tightening a 1/4-20 x 5/8” Pan Head Phillips

Screw, once the 1/4-20 Rivet Nut has been expanded in

place, remove the 1/4-20 x 5/8” Pan Head Phillips Screw. The

procedure for installing the Rivet Nuts will be repeated three

times in total (STEPS 9 & 15) as will be detailed.

S T E P 8

Re-install both floor panels that were removed in STEP 2.

Install both of the brackets on the bottom of the enclo-

sure as shown

Continued on Next Page

SB-T-CAM/12W3V3 INSTR_SKU# 011284

S T E P 1 5

Using a drill with a 3/8” bit, drill through the locations marked

in STEP 14 . Repeat STEP 10 in both holes.

*CAUTION*

Before drilling, always make sure that you are not

going to be drilling into any gas lines, brake lines,

transmission lines, electrical wiring, exhaust systems

or anything else that might cause a reduction in

your weekly pay. Always wear eye protection when

drilling.

S T E P 1 4

Press in at the bottom of the enclosure so that it sits as tight

in the side as possible, and mark the locations for the bottom

anchors to be drilled through the floor. Remove the enclo-

sure from the side.

S T E P 1 3

The two lower brackets from the Stealthbox® should be con-

figured as shown, the one that goes up will be the same, just

arranged vertically.

S T E P 1 2

Attach the upper mounting bracket into the just installed

1/4-20 Rivet Nut using One of the supplied 1/4-20 Phillips

Head Screws. The correct order of the hardware is indicated

in the illustration below.

Page 3 • JL Audio, Inc 2008

STEP 17

CONGRATULATIONS!

You have completed the installation for this model!

Enjoy your new Stealthbox®!

Please refer to the Power Recommendation section for an

amplifier recommendation and basic set-up help.

STEP 16

Test the Stealthbox® to ensure proper operation then,

remount using the supplied three Phillips Head Screws, Split

Lock Washers and, Flat Washers.

THREADED INSERT

FLAT WASHER

HEX BOLT

LOCK WASHER

MOUNTING BRACKET

LOCK WASHER

STEALTHBOX®

VEHICLE BODY

RIVET NUT

PHILLIPS HEAD SCREW

SB-T-CAM/12W3V3 INSTR_SKU# 011284

Page 5• JL Audio, Inc 2008

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc.“Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.

#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign

patents pending. For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

www.jlaudio.com

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

I N C L U D E D H A R D W A R E

3) 1/4-20 Rivet Nut 3) 1/4-20 x 1” Hex Head Bolt

3) 1/4” Split Lock Washer 6) 1/4” Flat Washer

3) 1/4-20 x 5/8” Pan Head Phillips Screw

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 12W3v3-4

Nominal Impedance: 4 Ohms

Continuous Power Handling: 500 Watts

P O W E R R E C O M M E N D A T I O N

JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2.

The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1v2

when being used to power your Stealthbox®.

The JL Audio 250/1v2 is a very versatile audio component. Please consult the owner’s manual for even more

detailed information about installing and tuning this amplifier.

M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6” x 9”- Front Doors

Fits JL Audio Models: TR690-TXi, C2-690tx, VR690-CXi

Rear Speaker Size / Location: 6” x 9”- Rear Door

Fits JL Audio Models: TR690-TXi, C2-690tx, VR690-CXi

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio 12TW1-2 Bedienungsanleitung

JL Audio

JL Audio 12W1v2-4 Bedienungsanleitung

JL Audio

JL Audio ZR570-CSi Bedienungsanleitung

JL Audio

JL Audio 15W1-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-KW-TRX4/10TW3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CFMINI/10W3v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-POL-RNGR/SYS Bedienungsanleitung

JL Audio

JL Audio M3-10IB Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-CRV2/10TW3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-HUMR2/12W6v2 Bedienungsanleitung

JL Audio

JL Audio 12W3v3-2 Bedienungsanleitung

JL Audio

JL Audio 10TW3-D8 Bedienungsanleitung

JL Audio

JL Audio 10TW3-D4 Bedienungsanleitung

JL Audio

JL Audio JL AUDIO Evolution ZR800-CW Bedienungsanleitung

JL Audio

JL Audio 12W6v3-D4 Bedienungsanleitung

JL Audio

JL Audio 12WXv2-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-J-JK2DR/10W1v3 Bedienungsanleitung

JL Audio

JL Audio 8W1v2-4 Bedienungsanleitung

JL Audio

JL Audio 13TW5v2-2 Bedienungsanleitung

JL Audio

JL Audio 18W6 Montageanleitung

JL Audio

JL Audio 10IB4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-370/10W3v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-P-987C/13TW5v2 Bedienungs- und Wartungsanleitung

JL Audio

JL Audio 12W4-4 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung