John Lewis Showwood Bed Bedienungsanleitung

Showwood Bed

MTO

Thank you for purchasing this Showwood Bed. Please read the instructions carefully before use to ensure

safe and satisfactory operation of this product.

Double

PRE-ASSEMBLY PREPARATION

Please check the pack contents before attempting to assemble this product. A full checklist of components is

given in this leaflet. If any components are missing, please contact customer services on 01244 689949 or email

[email protected].

This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE WHEN

LIFTING to avoid personal injury and (or) damage to the product.

This product takes approximately 40 MINUTES to assemble with 2 PEOPLE.

The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG CHILDREN.

Read this leaflet in full before commencing assembly.

Please ensure instructions are read in full before attempting to assemble this product.

Necessary Tools

1/7

Fitting and parts checklist

M5 Allen Key x 1

M4 Allen Key x 1

Side Caps x 14

Centre Caps x 7

Headboard x 1

Footboard x 1

Side Rails x 2

Slats x 14

Wide Slats x 16

Centre Rail x 1

Legs x 4

Wooden Base (Headboard) x 2

Parts

Fittings

HEAD

M6 Washer x 10

M8 Washer x 2

M6 X 40mm Bolt x 8

2/7

M6 x 55mm Bolt x 4

M8 x 50mm Bolt x 4

Wide Centre Caps x 8

Wide Side Caps x 16

M8 Spring Washer x 4

Note: Make sure the Side Rail (3) which has sticker (HEAD) is attach on Headboard

3/7

Step One

Step Two

Attach the Wooden Base (8) into the side on the Headboard (1) using the M6 x 55mm Bolt (G), and M8 Washer (J).

Do not tighthen the bolt until all part attached.

J.G.8.

M8 Washer x 2

Wooden Base

x 2 M6 x 55mm x 2

M4 Allen Key

x 1

M4 (B)

M6 x 55mm(G)

M10 x Washer(J)

Before attach the Side Rails (3) with the side of Headboard (1), rest the headboard down to the carpeted or soft

flooring as shown in Fig 1. Only then you can attach both using M6 x 55mm Bolt(G) and M6 Washer (F) as

shown in Fig.2.

Continue attach the Side Rails (3) to the Front Headboard (1) using M6 x 40mm Bolt (E) and M6 Washer (F).

Adjust the Side Rails (3) with the Headboard (1) and make sure the edges align perfectly.Tighten M6 x 55mm Bolt(G)

first using M4 Allen Key (B), and then continue to tighthen the M6 x 40mm Bolt (E) to

secure in place

HEAD

Carpeted or

soft flooring

Flip over

Fig.1

x2x2

Fig.2 Fig.3

HEAD

M6 x 55mm (G)

M6 Washer (F)

SIDE

M6 x 40mm Bolt

x 4

M6 x 55mm Bolt

x 2

G. F.

M6 Washer x 6

HEAD

M6 x 40mm

(E)

(F)

(G)

M4(B)

Tighten

first

Tighten

last

Step Four

Step Three

Lower the Centre Rail (6) into the pre-drilled holes of the Headboard (1) and Footboard (2) and attach with

M6 x 40mm Bolt (E) and M6 Washer(F) and fully tighten bolts with M4 Allen Key (A) as shown in Fig.4.

You can now tighten the bolts at the Footboard using M5 Allen Key (A) for the Footboard(2) so all

fastenings are now tightened.

LOOSELY SECURE PARTS

TOGETHER IN ORDER FOR

CENTRE RAIL TO FIT IN

NEXT STEP

4/7

Bracket

Side Rail

Fig.4

K. L.

HEAD

M8 Spring

Washer x 4

M8 x 50mm Bolt

x 4

M8 x 50mm (L)

M8 Spring Washer (K)

Now attach the Footboard (2) to the Side Rails (3) using M8 x 50mm (L) with M8 Spring Washer (K) and hand-

tighten to loosely secure parts together as shown in Fig.4. Do not tighthen bolts with M5 Allen Key (A) until you

have inserted the Centre Rail in the next step.

Bracket

Side Rail

Fig.4

M5(A)

AFTER INSERTING CENTRE RAIL,

TIGHTEN ALL FIXINGS FULLY

M4 Allen Key

x 1

M5 Allen Key

x 1

A. B.

M6 x 40mm Bolt

x 4

E. F.

M6 Washer

x 4

And

M6 x 40mm (E) (F)

M4 (B)

HEAD

2 Lines

Normal slats

1 Line

Normal slat

2 Lines

Wide slats

2 Lines

Wide slats

2 Lines

Normal slats

2 Lines

Normal slats

4 Lines

Wide slats

ZONE 2

ZONE 1

ZONE 5

ZONE 7

ZONE 6

ZONE 4

ZONE 3

Diagram 1

(x8)

(x7)

Side Caps x 14

Wide Centre Caps

x 8

Wide Side Caps

x 16

Wide Slats x 16

Slats x 14

Step Six

With the curved side facing upwards, insert 2 slats into a centre cap then into 2 side caps on either

end(x15). (Please note the Wide Slats must be inserted with the Wide Centre Caps (H) and Wide

Side Caps (I)). Repeat this process for all slats.

Note: Please see the Diagram 1 below to arrange the slat with the correct system).

Centre Caps x 7

Starting with the Headboard (1), insert the Legs (7) into the pre-drilled holes on the underside of the Headboard (1)

and twist to secure, as shown in the diagram below.

Legs x 4

5/7

Step Five

FOOTBOARD

HEADBOARD

Note: Before proceed to the next step, ensure the wooden base on each part are parallel towards each other

by adjusting the bolt on the bottom.

6/7

Step Seven

This bed is now ready to use.

Care and Maintenance

Safety Instructions

If you require any additional information or have any issues with this product please call the customer

services helpline on 01244 689949 or email [email protected].

Never drag furniture when moving it. Always lift it.

Periodically check all fixings to ensure none have come loose and re-tighten where necessary.

Please take care when handling or moving the furniture as careless handling may cause damage or injury.

Furniture can be dangerous if incorrectly installed. Any assembly should be carried out by a competent

adult.

No liability will be accepted for damage or injury caused by incorrectly installed or assembled furniture.

During assembly, children should be kept away from the product due to possible risk of injury.

Do not use this item if any components are missing or damaged.

It is recommended that care is taken when moving heavy objects to a new location to avoid

personal injury or damage to the furniture. Please be careful to retain all fittings when doing this.

This bed should be cleaned using a soft, damp cloth and dried immediately.

Do not use a very wet cloth or allow any liquid contact for a long period of time as this can permanently

damage the surface.

Do not use detergents and do not rub as this can cause permanent damage.

Always protect your bed from direct sunlight as this may accelerate the natural ongoing discolouration

process.

Bolts holding together the bed frame should be tightened regularly.

Please retain this information leaflet for future reference.

This product complies with BS EN 1725:1998.

7/7

Inhaltsverzeichnis

Andere John Lewis Inneneinrichtung Handbücher

John Lewis

John Lewis Etienne 80316820 Bedienungsanleitung

John Lewis

John Lewis GARBO DEMI LUNE CONSOLE 87734911 Bedienungsanleitung

John Lewis

John Lewis Seam Side Table 86228901 Bedienungsanleitung

John Lewis

John Lewis Daisy 803/41404 Bedienungsanleitung

John Lewis

John Lewis Riley Guest Bed 800/65201 Bedienungsanleitung

John Lewis

John Lewis Dara 803 51101 Bedienungsanleitung

John Lewis

John Lewis 049 Bedienungsanleitung

John Lewis

John Lewis Dara 803 18203 Bedienungsanleitung

John Lewis

John Lewis Asuka 803/13904 Bedienungsanleitung

John Lewis

John Lewis JL SCND 1200/17 Bedienungsanleitung

John Lewis

John Lewis Bonn 803 51702 Bedienungsanleitung

John Lewis

John Lewis Morgan 803/16409 Bedienungsanleitung

John Lewis

John Lewis 803/15701 Bedienungsanleitung

John Lewis

John Lewis OXFORD 83501 Bedienungsanleitung

John Lewis

John Lewis Grace Bed Bedienungsanleitung

John Lewis

John Lewis JL Almera Bedienungsanleitung

John Lewis

John Lewis Mary Series Bedienungsanleitung

John Lewis

John Lewis Martha Sleigh cotbed Bedienungsanleitung

John Lewis

John Lewis MIRA 836 23502 Bedienungsanleitung

John Lewis

John Lewis COLOSSEUM 24401 Bedienungsanleitung

John Lewis

John Lewis 80161302 Bedienungsanleitung

John Lewis

John Lewis Salsa 82089613 Bedienungsanleitung

John Lewis

John Lewis 816/82301 Bedienungsanleitung

John Lewis

John Lewis 570/30835 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung