- 1
Please read and comply with
these instructions prior to the
initial operation of your appliance. Retain
these operating instructions for future refer-
ence or for subsequent possessors.
The appliance may only be operated by
persons who have read and understood the
contents of this operating instructions man-
ual. Please ensure that you conform to all
the safety instructions and regulations.
This operating instructions manual
must be stored in such a way that it can
be easily accessed by the operator.
The following symbols are used in this op-
erating manual:
DANGER
Indicates an immediate danger. By not pay-
ing attention to this notice, there is danger
of death or serious injury.
몇WaRNING
Indicates a possible dangerous situation.
By not paying attention to the notice, light
injuries or property damage may possibly
occure.
-NOTICE
Indicates operating idea and important in-
formation.
DANGER
Risk of cold burns. Dry ice has a tempera-
ture of -79 °C. Never touch dry ice or cold
parts of the machine without appropriate
protection.
DANGER
Risk of burns! Beware of hot components.
DANGER
Risk of injury on account of electric shock.
Pull the plug out of the socket before open-
ing the control cabinet.
DANGER
Risk of injury by emerging hydraulic oil stream.
Never operate the machine while the housing
is open. Immediately take the machine out of
service if the hydraulic system is leaking.
DANGER
Risk of injury on account of flying dry ice
pellets or dirt particles. Wear close fitting
safety goggles.
Risk of hearing impairment. Wear ear-pro-
tection aids.
DANGER
Risk of injury on account of flying dry ice
pellets.
Wear protective gloves as per EN 511.
DANGER
Risk of suffocation on account of carbon di-
oxide. The dry ice pellets are made of solid-
ified carbon dioxide. The carbon dioxide
content in the air at the place where the ma-
chine is used will increase when the ma-
chine is running. Ensure adequate ventila-
tion at the place of use; if possible, use an
alarm to warn persons. Symptoms of high
levels of carbon dioxide in the air that is
breathed in:
–3...5%: headache, faster breathing.
–7...10%: headache, nausea and per-
haps even unconsciousness.
If any of these symptoms occur, please
switch off the machine immediately and get
a breath of fresh air and improve the venti-
lation before starting work again with the
machine.
Follow the safety specifications of the man-
ufacturer of carbon dioxide.
DANGER
Risk of injury if the machine is left running
in an unattended state. Disconnect the
mains plug from the socket before perform-
ing any work.
DANGER
Risk of cold burns on account of dry ice or
cold parts of the machine. While working on
the machine, wear appropriate safety gear
for protection against cold or remove dry
ice and let the machine heat up.
Avoid bodily contact with dry ice.
Never put dry ice in your mouth.
Seek immediate medical attention.
Flush eye with plenty of warm water
and seek medical attention immediate-
ly.
Flush affected skin with plenty of warm
water for at least 15 minutes and seek
medical attention immediately.
For the operation of this system the follow-
ing regulations and directives are applica-
ble in the Federal Republic of Germany
(available from Carl Heymanns Verlag KG,
Luxemburger Straße 449, 50939 Cologne):
– BGR 189 Using safety gear
– BGR 195 Using of safety gloves
– BGI 836 Gas warner
Press emergency-stop button.
The machine is immediately shut off.
The machine produces dry ice pellets con-
sisting of liquid carbon dioxide. The size of
the dry ice pellets is selected via different
extruder plates.
The machine is only to be used in dry
rooms.
Do not spray the machine with water to
clean it. Wipe the machine housing using a
damp cloth.
The application may only be installed by
authorised technicians!
Contents
Environmental protection. . . . . EN 1
Safety instructions . . . . . . . . . . EN 1
Proper use. . . . . . . . . . . . . . . . EN 1
Function. . . . . . . . . . . . . . . . . . EN 2
Control elements . . . . . . . . . . . EN 2
Mounting the installation set
"Volume control PCS" (option) EN 2
Operation. . . . . . . . . . . . . . . . . EN 2
Shutting down . . . . . . . . . . . . . EN 3
Replace the extruder plate. . . . EN 3
Maintenance and care. . . . . . . EN 4
Troubleshooting. . . . . . . . . . . . EN 5
Technical specifications. . . . . . EN 6
Accessories . . . . . . . . . . . . . . . EN 6
Spare parts . . . . . . . . . . . . . . . EN 6
Warranty . . . . . . . . . . . . . . . . . EN 6
EU Declaration of Conformity . EN 6
Environmental protection
The packaging material can be re-
cycled. Please do not place the
packaging into the ordinary refuse
for disposal, but arrange for the
proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper re-
cycling of old appliances. Batter-
ies, oil, and similar substances
must not enter the environment.
Please dispose of your old appli-
ances using appropriate collection
systems.
Safety instructions
Symbols used in the operation
instruction
Symbols on the machine
General notes on safety
First aid in case of accidents
involving dry ice or liquid carbon
dioxide
Ingestion
Contact with eye
Contact with skin
Specifications and Guidelines
Switch-off in case of emergency
Proper use
9EN
