Kichler Lighting THELMA 37533 Bedienungsanleitung

Français p. 15

Español p. 29

ITEM # 5024098, 5141830

MODEL # 37533, 37544

THELMA PLUG-IN WALL SCONCE

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 800-554-6504, 8 a.m. - 4:30 p.m, EST, Monday - Friday.

kichler.com/customer-care/contact-us

ATTACH YOUR RECEIPT HERE

Serial Number Purchase Date

PACKAGE CONTENTS

Canopy

Mounting Bracket

Socket

Glass

Cord

Coupling

On/O Switch

Candle Sleeve

Decorative Nut Cover

Decorative Tube

Socket Base Cup

Spring Bracket

PART DESCRIPTION QTY.PART DESCRIPTION QTY.

2 43

HARDWARE CONTENTS

Wire

Connector

AA BB CC DD

Qty: 3 Qty: 2

Short

Mounting

Screw

Lock

Washer

Qty: 2

Threaded

Knob

Qty: 2

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install

the product.

WARNING

• CAUTION – RISK OF SHOCK –

Disconnect Power at the main circuit breaker panel or main fusebox before starting and during

the installation.

• WARNING:

This fixture is intended for installation in accordance with the National Electrical Code (NEC)

and all local code specifications. If you are not familiar with code requirements, installation by a

certified electrician is recommended.

• Do not use bulbs with wattage greater than specified on this fixture.

• California Proposition 65

WARNING: This product can expose you to chemicals including lead, which is known to

the State of California to cause cancer, birth defects, or other reproductive harm.

For more information, go to http://www.P65Warnings.ca.gov

CAUTION

• If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate

completely, please contact a licensed electrical contractor.

• All parts must be used as indicated in these instructions. Do not substitute any parts, leave

parts out, or use any parts that are worn out or broken. Failure to obey this instruction could

invalidate ETL listing and/or C.S.A. certification of this fixture.

Qty: 2

Wall

Anchor

Qty: 2

Long

Knob

Screw

Qty: 1

Hole

Cover

Wall Anchor

Mounting

Screw

Stud

Mounting

Screw

For Plug-In Mounting Assembly,

Go to Step 1a on Pg. 5

For Direct Wire Mounting Assembly,

Go to Step 1b on Pg. 8

NOTE: This model can be installed as a fixture that

plugs into a wall outlet, or a fixture that is directly wired

to a wall-mounted outlet box.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package

contents list and hardware contents list. If any part is missing or damaged, do not attempt to

assemble the product.

Estimated assembly time: 30 minutes to 1 hour

Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire strippers,

electrical tape, ladder, safety glasses, drill, crescent wrench.

For Plug-In Mounting Assembly,

Go to Step 1a on Pg. 5

For Direct Wire Mounting Assembly,

Go to Step 1b on Pg. 8

NOTE: This model can be installed as a fixture that

plugs into a wall outlet, or a fixture that is directly wired

to a wall-mounted outlet box.

4 5 6

ASSEMBLY INSTRUCTIONS (PLUG-IN MOUNTING)

1a.

Remove ground screw from mounting bracket

(B), and discard.

Find a suitable location on the wall to mount

your fixture (location should be within 6 feet of

an electrical outlet).

Using the mounting bracket (B) as a template,

place flat side of mounting bracket (B) flush

against wall with the mounting hardware slots

aligned vertically in the 12 and 6 o’clock position

as shown. Mark locations for the two (2)

mounting hardware holes, one in each

mounting hardware slot. Set mounting bracket

(B) aside.

If NOT mounting fixture on a stud,

Go to Step 2a on Pg. 6

If mounting fixture on a stud,

Go to Step 4a on Pg. 7

REMOVE AND

DISCARD

MOUNTING

HARDWARE

SLOT

For Plug-In Mounting Assembly,

Go to Step 1a on Pg. 5

For Direct Wire Mounting Assembly,

Go to Step 1b on Pg. 8

NOTE: This model can be installed as a fixture that

plugs into a wall outlet, or a fixture that is directly wired

to a wall-mounted outlet box.

5 6

ASSEMBLY INSTRUCTIONS (PLUG-IN MOUNTING)

3a.

Push wall anchors (FF) through 11/16”

holes drilled in wall (wall anchor (FF) is

completely through wall when a "click" is

heard).

While holding mounting bracket (B) flat

against wall in its final mounting position,

gently pull wall anchor mounting screws

(EE) out and away from mounting bracket

(B) such that wall anchors (FF) are flush

against inside of wall surface, and tighten

wall anchor mounting screws (EE) to

secure mounting bracket (B) to wall

anchors (FF).

Go to Step 5a on Pg. 7

2a.

If NOT mounting fixture on a stud, drill

holes for mounting hardware where

marked in Step 1a. Using a 11/16" drill bit

(not included), drill a 11/16" hole at each

marked location for the wall anchors (FF)

and wall anchor mounting screws (EE).

Remove wall anchor mounting screws (EE)

from wall anchors (FF) and retain. Pass

threads of wall anchor mounting screws

(EE) through mounting hardware slots in

the mounting bracket (B), then thread

them back into wall anchors (FF) as

shown.

NOTE: Wall anchor mounting screws (EE)

should be threaded into wall anchors (FF)

such that 2-3 threads protrude through

wall anchor (FF).

Hardware Used

x 2Wall Anchor

x 2

Wall Anchor

Mounting Screw

EE FF

4a.

If mounting fixture on a stud, drill holes for

mounting hardware where marked in Step

1a. Using a 1/16" drill bit (not included), drill

a 1/16" pilot hole at each marked location

for the stud mounting screws (GG).

Hold mounting bracket (B) flat against wall

(with mounting hardware slots positioned

over 1/16” pilot holes) and screw stud

mounting screws (GG) into pilot holes.

Tighten stud mounting screws (GG) to

secure mounting bracket (B) to wall.

ASSEMBLY INSTRUCTIONS (PLUG-IN MOUNTING)

5a.

Pass canopy (A) over the screws

protruding from the mounting bracket (B)

and secure in place with lock washers (DD)

and threaded knobs (CC).

NOTE: Make sure all wires are inside of

canopy (A) and do not get pinched

between canopy (A) and mounting bracket

(B), or canopy (A) and wall.

NOTE: Fixture should be mounted with

socket (C) in the up position as shown.

Go to Step 1c on Pg. 12

Hardware Used

x 2Stud Mounting Screw

Hardware Used

x 2Lock Washer

x 2Threaded Knobs

2b.

Orient the mounting bracket (B) such that

the mounting hardware slots align with

threaded holes in the outlet box (not

included) as shown.

Insert long knob screws (HH) through the

horizontally aligned threaded holes in the

mounting bracket (B) as shown, starting

from the outlet box side, with the threads

of the long knob screws (HH) protruding

outward.

7 8

ASSEMBLY INSTRUCTIONS (DIRECT WIRE MOUNTING)

1b.

Remove preassembled machine screws and

lock washers from mounting bracket (B) by

unscrewing hex nuts, and discard machine

screws, lock washers, and hex nuts.

1b B

MOUNTING

HARDWARE

SLOT

REMOVE

AND DISCARD

Hardware Used

x 2Long Knob Screw

3b.

With the long knob screws (HH)

protruding outward, connect the

mounting bracket (B) to the outlet box

using short mounting screws (BB).

ASSEMBLY INSTRUCTIONS (DIRECT WIRE MOUNTING)

4b.

Pull up an additional length of cord (E) into

canopy (A). Cut cord (E) approximately (8)

inches from center of canopy (A). Discard

the remaining length of cord (E) attached

to the plug.

CAUTION: Ensure cord is NOT plugged

into electrical outlet when cutting the

cord.

Hardware Used

x 2Short Mounting Screws

0.5"

[13mm]

9 10

ASSEMBLY INSTRUCTIONS (DIRECT WIRE MOUNTING)

5b.

Remove coupling (F) from the bottom of

canopy (A) by unscrewing the hex nut

from the short threaded pipe protruding

into the canopy (A). Discard the coupling

(F), short threaded pipe, hex nut, and lock

washer.

Insert hole cover (II) into hole from the

outside of canopy (A) such that bottom

of hole cover (II) is flush with bottom of

canopy (A) when installed.

6b.

Split the end of the cord and strip ends of

each wire 1/2" (13mm).

REMOVE AND

DISCARD

Hardware Used

x 1Hole Cover

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kichler Lighting Außenleuchte Handbücher

Kichler Lighting

Kichler Lighting 59009WZC Bedienungsanleitung

Kichler Lighting

Kichler Lighting 11320 Bedienungsanleitung

Kichler Lighting

Kichler Lighting SALEMA 37540 Bedienungsanleitung

Kichler Lighting

Kichler Lighting AMMA 37534 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 49898BKLED Bedienungsanleitung

Kichler Lighting

Kichler Lighting Chance Harbor Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15309BKT Bedienungsanleitung

Kichler Lighting

Kichler Lighting Camillo Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15092BKT Bedienungsanleitung

Kichler Lighting

Kichler Lighting 16099BK Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15390AZT Bedienungsanleitung

Kichler Lighting

Kichler Lighting 16097BK Montageanleitung

Kichler Lighting

Kichler Lighting Hone 59138B Bedienungsanleitung

Kichler Lighting

Kichler Lighting LEMMY 37535 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15066AZT Bedienungsanleitung

Kichler Lighting

Kichler Lighting Nocar 59143BKT Bedienungsanleitung

Kichler Lighting

Kichler Lighting 10797 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 300318 Bedienungsanleitung

Kichler Lighting

Kichler Lighting Linford 39535 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 16236 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15382BK Bedienungsanleitung

Kichler Lighting

Kichler Lighting Hampshire 13.25 Bedienungsanleitung

Kichler Lighting

Kichler Lighting 15088BK Bedienungsanleitung

Kichler Lighting

Kichler Lighting Ashland Bay 49569WZC Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung

LIGMAN

LIGMAN DE-20023 Bedienungsanleitung