Kohler K-11842 Series Montageanleitung
Installation and Care Guide
Wall-Mount Valve
Mproduct numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
Mcorresponden a México (Ej.
K-12345M)
Français, page “Français-1”
Español, página “Español-1”
K-11842, K-11843
1207552-2-B
Declaration of Conformity
September 22, 2009
EC DECLARATION OF CONFORMITY
08
Kohler Company
444 Highland Drive, Kohler, WI 53044
Phone 920-457-4441
We declare under our sole responsibility that the product AC models:
K-11842
K-11842W
K-11842IN
K-11842M
K-11842D
K-11842T
K-E 11842
K-11843
K-11843W
K-11843IN
K-11843M
K-11843D
K-11843T
K-E 11843
Electronic Wall-Mount Lavatory
Faucet (Tap) – AC Power
AC Power Supply
K-13480 K-13481
On behalf of Kohler Co.,
to which this declaration relates, are in conformity with the relevant European Community
Directive(s):
Timothy J. Stessman
Codes & Standards Dept.
Kohler Company
Signature
September 22, 2009
Electromagnetic Compatibility (EMC) Directive 2004/108/EC
Conformity to this directive is based on compliance with the following harmonized standards:
• EN 61000-6-2: 2005
Electromagnetic Compatibility (EMC) – Radiated Immunity, 80MHz to 1GHz
(Test method: IEC 61000-4-3: 2008)
• EN 61000-6-3: 2007
Radiated Emission(Test Method: CISPR 16-2-3): CLASS B
Date
1207552-2-B 2 Kohler Co.
Tools
Important Information
NOTE: Follow the installation dimensions precisely as there is no
deep rough-in kit available for this product.
Observe all local plumbing and building codes.
Shut off the main water supply.
Inspect the supply tubing for damage. Replace as necessary.
Site preparation and wall finishing may require additional tools
and materials.
Adjustable
Wrench
Sealant Tape
Hex WrenchAssorted
Screwdrivers
Plus:
• Wire Fasteners
• Woodworking Tools
• Pipe Fitting Tools
• Wood Screws
• 2x4s
Kohler Co. 3 1207552-2-B
1. Determine the Sensor Location
* Consult the specification sheet for the spout that will be paired with
this valve for specific installation dimensions.
Countertop
*
Finished Wall
11" (279 mm)
20˚
1/2"
(13 mm)
X
Y
Motion
Zone
Countertop
*
Finished Wall
11" (279 mm)
1/2"
(13 mm)
X
Y
Motion
Zone
Drop-In
Sinks
Under-Mount
Sinks
Important:
Measure "Y"
from the sink rim,
not the countertop.
Countertop
*
Finished Wall
Above-Counter
Sinks 11" (279 mm)
20˚
1/2"
(13 mm)
X
Y
Motion
Zone
20˚
1207552-2-B 4 Kohler Co.
Determine the Sensor Location (cont.)
IMPORTANT! It is critical for proper operation that the sensor be
installed with the motion zone clear of any obstructions, including
the edge of the countertop or the bathroom sink.
NOTE: Before installation, consult the specification sheet for the
spout to determine the correct wall rough-in for your installation.
Measure the distance (X) from the finished wall to the inside edge
of the countertop or bathroom sink.
Determine the sensor height (Y) using the chart below. If you
cannot determine Y from the chart, use the formula .5″+X(0.364)
to determine (Y).
If dimension X is: Then the sensor height (Y) is:
1″(25 mm) 7/8″(48 mm)
2″(51 mm) 1-1/4″(32 mm)
3″(76 mm) 1-9/16″(40 mm)
4″(102 mm) 2″(51 mm)
5″(127 mm) 2-3/8″(60 mm)
6″(151 mm) 2-9/16″(65 mm)
7″(179 mm) 3″(76 mm)
8″(203 mm) 3-7/16″(87 mm)
9″(229 mm) 3-3/4″(95 mm)
Kohler Co. 5 1207552-2-B
2. Prepare the Site
IMPORTANT! The valve requires special framing and support
considerations. Consult the specification sheet for the spout that will
be installed with your valve at www.kohler.com for specific
dimensions.
NOTE: Mount the valve with the sensor at the height determined in
the previous step.
NOTE: A suggested framing example is shown. Each installation
may have different framing requirements than those shown.
Construct the framing for your installation.
If a thermostatic mixing valve will be included with your
installation, install the valve now following the directions
provided with the valve.
3. Secure the Valve
IMPORTANT! Make sure the location of the valve is correct before
securing it in place. The centerline of the drain and faucet should be
in line with each other.
2x4 Stud Framing
Wall Plate
Screws
Sink Height
Six Round Holes (Typical)
*
*
16"
(406 mm)
7" (178 mm)
*Consult the spout
specification sheet
for specific installation
dimentions.
Finished
Wall
1207552-2-B 6 Kohler Co.
Secure the Valve (cont.)
Secure the wall plate to the studs using six wood screws (not
provided).
Kohler Co. 7 1207552-2-B
4. Install the Pipe and Finished Wall
Install 1/2″supply pipe to the valve assembly.
At the point where the supply will exit the wall, install a drop ear
ell flush or slightly behind the finished wall.
Feed the sensor wire through the sensor mount and plaster
guard, leaving 1-1/2″(38 mm) minimum of exposed wire
protruding.
Connect the sensor wire harness to the wall.
Temporarily connect the water supply to the supply ell.
Turn on the water.
Check the system for leaks.
Turn off the water.
Install the finished wall.
NOTE: The diameter of the faucet hole cutout is 1-3/4″(44 mm).
The diameter of the sensor hole cutout is 1-3/8″(35 mm).
Secure wire
harness to the wall.
Plaster Guard
Ell
1-1/2"
(38 mm)
1207552-2-B 8 Kohler Co.
Install the Pipe and Finished Wall (cont.)
NOTE: The diameter of the supply inlet opening is determined by
the ell diameter.
Kohler Co. 9 1207552-2-B
5. Install the Sensor
Install the Bezel
Loosen the screws in the plaster guard.
Remove the plaster guard and discard.
Feed the sensor wire through the back of the bezel.
Position the bezel over the screw heads and turn 1/8 turn
counterclockwise.
Tighten the screws.
Connect the Sensor
Connect the sensor to the wire harness and feed the wire into the
wall.
Position the sensor in front of the bezel with the wire on the back
of the sensor to the right.
Push the sensor into place.
Discard the
plaster guard.
Bezel
Sensor Wire
Sensor
1207552-2-B 10 Kohler Co.
Andere Handbücher für K-11842 Series
1
Dieses Handbuch passt für folgende Modelle
16
Inhaltsverzeichnis
Sprachen:
Andere Kohler Steuereinheit Handbücher
Kohler
Kohler K-5557 Montageanleitung
Kohler
Kohler K-306 Bedienungsanleitung
Kohler
Kohler K-10673 Betriebsanleitung
Kohler
Kohler K-402 Bedienungsanleitung
Kohler
Kohler K-10959 Bedienungsanleitung
Kohler
Kohler K-10970 Montageanleitung
Kohler
Kohler rada VZ1 10 Bedienungsanleitung
Kohler
Kohler K-10666 Betriebsanleitung
Kohler
Kohler K-308 Bedienungsanleitung
Kohler
Kohler Mira Select B14C Bedienungsanleitung
Kohler
Kohler K-76746GL-NA Bedienungsanleitung
Kohler
Kohler K-307 Bedienungsanleitung
Kohler
Kohler 28209W-NA Bedienungsanleitung
Kohler
Kohler TAUT 73193T-4CD Bedienungsanleitung
Kohler
Kohler K-305 Montageanleitung
Kohler
Kohler K-682 Bedienungsanleitung
Kohler
Kohler K-10675 Betriebsanleitung
Kohler
Kohler K-528 Bedienungsanleitung
Kohler
Kohler K-400 Bedienungsanleitung
Kohler
Kohler 1190330-NA Bedienungsanleitung
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
