Kohler Englefield Valencia Elite Bedienungsanleitung

1223207-A02-G September 2023 engleﬁeld.co.nz

Page1

VALENCIA / VALENCIA ELITE

DOUBLE DRAWER VANITY

FURNITURE |

Floor Standing Models

Wall Hung Models

® ®

BEFORE YOU BEGIN:

ROUGH-IN:

Please read these instructions carefully to familiarise yourself with the required tools, materials, and

installation sequences. Follow the sections that pertain to your particular installation. This will help you

avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.

Prior to installation, inspect the cabinet and vanity top (either Durastone top, ceramic top or stone

quartz top) to ensure that no damage has occurred in transit. If damage has occurred, or a visible defect

exists, do not proceed with installation, and advise your supplier immediately.

Instructions, drawings, and diagrams contained in this manual present information available at the time

of printing.

Although every attempt has been made to keep them up-to-date, Engleﬁeld reserves the right to implement

product changes without further notice.

Floor Standing Models

Wall Hanging Models

850

800 467

605 755

650

600

905 1205 1205

engleﬁeld.co.nz

Page2

NOTE: For rough-in dimensions and installation instructions of the Valencia Elite Stone

vanity tops, please refer to the supplementrary guide supplied with the stone quartz tops.

1223207-A02-G September 2023

Please leave these instructions for the consumer. They contain important information.

INSTALLATION INSTRUCTIONS

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

1. Drawer removal

Floor standing models must be ﬁxed to a nog in the wall. Wall hung models must be ﬁxed to two nogs

in the wall. The nog size should be 50 x 75mm.

(a) Open the drawer and carefully lift up on the

end of the drawer to release it from the runner

locator pins. It may be necessary to gently pry

the runner away from the drawer.

(b) The drawer is now only held by the runner

hooks at the back and can be pulled out in

the direction shown.

CONSTRUCTION REQUIREMENTS:

INSTALLATION:

TOOLS AND MATERIALS REQUIRED - (Not Supplied)

Floor standing models

To suit pipework To suit screws

TOOLS MATERIALS - Not supplied & must be purchased separately

Fixing washers

20mm

Screws (Refer step 3)

10g x 75mm

Locator pin

A height of 800 to 850mm

from the floor to the top of the

vanity top is recommended for

the wall hung vanity.

50mm from top of

cabinet to centre

of nog.

50mm from top of

cabinet to centre

of nog.

Wall Hung models

Positioning of the nog near

vertical centre is recommended

however exact position will

depend on plumbing etc.

800-850

Runner hook

www.engleﬁeld.co.nz

Page3

1223207-A02-G September 2023

INSTALLATION INSTRUCTIONS

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Alternate drain

position for ﬂoor

standing models

2. Water supply and waste pipe holes

(a) Measure and mark the centres for water

supply and waste pipes on the back of the

cabinet.

into position over the pipework.

NOTE: Before fastening the cabinet make sure that

the it is sitting level and square and if installing a

ﬂoor mounted model ensure that the selected

location is free of bumps and protrusions.

NOTE: Screws should be positioned in an evenly

spaced pattern as shown below.

Mounting brackets screw positioning

Floor standing models

Wall Hung models

Screw positions

for 600mm ﬂoor

mount vanity shown

Screw positions

for 600mm wall

mount vanity shown

200

100100

Floor standing models

Wall Hung models

Mounting bracket

Mounting

bracket

(b) With a suitably sized hole saw drill the holes

for the water supply and waste.

engleﬁeld.co.nz

Page4

1223207-A02-G September 2023

INSTALLATION INSTRUCTIONS

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Size Floor Mount

Number of screws required

600 3

750 4

Wall Mount

900 4

1200 5

3. Fixing the vanity to the wall

(a) Fix the cabinet to the wall using screws (min

10g x 75mm) and *20mm washers. Screw

through the back rail or wall so that they screw

into the nog/s in the wall behind.

*Washers must be used to spread the load.

(a) Unpack the top and check for any damage that

might have occurred in transit. Check and

conﬁrm the ﬁt of your selected tapware.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely ﬁtted to the cabinet and no water

spillage will ﬁnd its way into the cabinet.

No silicone on

front edge

(a) To re-install the drawers, extend the runners.

Place a drawer onto the runners and slide back

so that the runner hooks insert into the rear of

the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press the

drawer down so that the pins slot into place.

6. Drawer re-installation

Runner hook

Locator pin

5. Waste and tapware

that the back is ﬂush against the wall and

there is an even overhang on either side of the

cabinet.

(d) Wipe off any excess sealant.

(a) Fit the waste and tapware. Connect the water

supply to the taps and waste pipe to the waste

outlet.

(b) Run hot and cold water and check for leaks.

When satisﬁed with the results move on to the

next section.

= =

engleﬁeld.co.nz

4. Vanity top

Page5

INSTALLATION INSTRUCTIONS

1223207-A02-G September 2023

*Mount Screws will

need to unscrewed

before removing the

drawer for latest

runners setup.

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

7. Drawer Height Adjustment

Runner hook

engleﬁeld.co.nz

5 Vanity top

(a) Unpack the top and check for any damage that

might have occured in transit. Check and

confirm the fit of your selected tapware.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely fitted to the cabinet and no water

spillage will find its way into the cabinet.

No silicone on

front edge

(a) To re-install the drawers, extend the runners.

Place a drawer onto the runners and slide back

so that the runner hooks insert into the rear of

the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press the

drawer down so that the pins slot into place.

= =

7 Drawer re-installation

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and floor

- Bewteen cabinet and wall

- Between upstand and wall

8 Sealing

VALENCIA

Vanity

6 Waste and tapware

that the back is flush against the wall and

there is an even overhang on either side of the

cabinet.

(d) Wipe off any excess sealant.

(a) Fit the waste and tapware. Connect the water

supply to the taps and waste pipe to the waste

outlet.

(b) Run hot and cold water and check for leaks.

When satisfied with the results move on to the

next section.

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and ﬂoor

- Bewteen cabinet and wall

- Between upstand and wall

8. Sealing

INSTALLATION COMPLETE

(a) Remove the drawer. To tilt the drawer front

forward before adjusting the height of drawer.

(b) Turn anticlockwise on the locator pin spacer to

raise the height of the drawer and turn clockwise

to raise down. Repeat on the other runner.

Hook the hinges onto the base plates and press

down as shown.

Note: All drawers are aligned during assembly.

However further adjustment is often required after

installation.

Please ensure the cabinet has not been twisted

and installed correctly before adjusting.

Page6

INSTALLATION INSTRUCTIONS

Height Adjustment Front Sectional

View

DOWN

1223207-A02-G September 2023

Hook

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Page7

1223207-A02-G September 2023

INSTALLATION INSTRUCTIONS

CLEANING AND MAINTENANCE INSTRUCTIONS

For cleaning instructions, please refer to the Owner’s Information Leaﬂet.

engleﬁeld.co.nz

(a) To re-install the drawers, extend the runners.

Place a drawer onto the runners and slide back

so that the runner hooks insert into the rear of

the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press the

drawer down so that the pins slot into place.

7 Drawer re-installation

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and floor

- Bewteen cabinet and wall

- Between upstand and wall

8 Sealing

INSTALLATION COMPLETE

Runner hook

Locator pin

INSTALLATION INSTRUCTIONS

ENGLEFIELD

CONTACT AND WARRANTY INFORMATION

NEW ZEALAND

Kohler New Zealand Limited

0800 100 382

AUSTRALIA

engleﬁeld.com

info@engleﬁeld.co.nz

engleﬁeld.co.nz

VALENCIA Double Drawer Vanity

VALENCIA ELITE

®®

Compression moulded vanity top:

To clean use non abrasive soap and water. It is recommended that the product surface is

wiped dry after each use to prevent the build up of soap and scum.

Vanity cabinet:

The materials used in the vanity cabinet are water resistant only, not water proof.

Care must be taken to clean up all water spillage onto the vanity cabinet surfaces.

To maintain the ﬁnish on your vanity cabinet clean with mild soapy water and dry with a soft

cloth.

WARNING

FOR YOUR PERSONAL SAFETY AND PRODUCT DURABILITY,

ENSURE THAT HOT WATER SUPPLY IS REGULATED TO 55°C MAXIMUM

CAUTION

Material used in cabinet is water resistant only, not waterproof.

Care must be taken to clean up all water spillage.

Andere Handbücher für Englefield Valencia Elite

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler M MODULAR Bedienungsanleitung

Kohler

Kohler K-11578 Montageanleitung

Kohler

Kohler K-99003-TLC Montageanleitung

Kohler

Kohler K-2684 Montageanleitung

Kohler

Kohler K-77123T Bedienungsanleitung

Kohler

Kohler Escale 23264IN-NF Bedienungsanleitung

Kohler

Kohler TOOBI K-15468T Bedienungsanleitung

Kohler

Kohler Vanity K-2435 Montageanleitung

Kohler

Kohler BANCROFT Service-Handbuch

Kohler

Kohler Kathryn K-3020 Bedienungsanleitung

Kohler

Kohler K-11750 Montageanleitung

Kohler

Kohler K-CB-CLW2030DAW Bedienungsanleitung

Kohler

Kohler K-76663T Bedienungsanleitung

Kohler

Kohler K-2967 Montageanleitung

Kohler

Kohler Archer K-2449 Bedienungsanleitung

Kohler

Kohler Verdera K-99003-TL Bedienungsanleitung

Kohler

Kohler ALEUTIAN K-24203T Bedienungsanleitung

Kohler

Kohler NEW ELOSIS Bedienungsanleitung

Kohler

Kohler Fountainhead K-2441 Bedienungsanleitung

Kohler

Kohler K-97631 Montageanleitung

Kohler

Kohler TRESHAM K-72530T-R Bedienungsanleitung

Kohler

Kohler K-2526 Montageanleitung

Kohler

Kohler K-2659 Montageanleitung

Kohler

Kohler K-2431 Montageanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung