Kohler K-2461 Bedienungsanleitung

Installation Guide

Vanity

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-2461

1061218-2-A

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Tools and Materials

Before You Begin

CAUTION: Risk of product damage. Siliconized acrylic caulk must

be used to secure the lavatory to the vanity. Do not use 100%

silicone sealant, which will damage the ﬁnish of the vanity.

Observe all local building codes.

Prior to installation, unpack the new product and inspect it for

damage. Return the product to its protective carton until you are

ready to install it.

Make sure the ﬁnished wall is straight and plumb, and the ﬂoor

is ﬂat and perpendicular to the ﬁnished wall.

This vanity is designed to allow most base moldings to pass

behind the vanity. Remove any moldings that may inhibit the

vanity from being ﬂush against the ﬁnished wall.

It is recommended that the drawer be removed from the vanity

before beginning the vanity installation. Doing so will ease the

installation process. Refer to the section contained in this guide

for proper removal.

Pencil Tape Measure Siliconized

Acrylic Caulk

Safety Glasses Drill Level

Assorted

Screwdrivers

• Wood Screws

• Framing Nails

• 3/4" Plywood

Plus:

1061218-2-A 2 Kohler Co.

Before You Begin (cont.)

Install the water supply and drain lines according to the

roughing-in information. The water supply nipples must extend

3” (7.6 cm) beyond the ﬁnished wall material.

Kohler Co. reserves the right to make revisions in the design of

products without notice, as speciﬁed in the Price Book.

Kohler Co. 3 1061218-2-A

1. Prepare the Wall

Measure and mark 33″(83.8 cm) up from the ﬂoor. This will be

the height from the top of the 3/4″plywood backing material to

the ﬂoor.

NOTE: The front face of the studs and 3/4″plywood backing

material should be ﬂush.

Secure the 3/4″plywood backing material to the studs with

framing nails.

Install the water supply and drain lines according to the

roughing-in information provided with your lavatory. The water

supply nipples must extend at least 3″(7.6 cm) beyond the

ﬁnished wall material.

NOTE: Plumbing will be exposed and visible once the vanity

installation is complete. Chrome plumbing ﬁttings are

recommended.

Complete the ﬁnished wall. Ensure the ﬁnished wall is straight

and plumb, and the ﬂoor is ﬂat and perpendicular to the ﬁnished

wall.

IMPORTANT! Before installing molding to the ﬁnished wall, check

to ensure that it will not interfere with the vanity.

3/4" Plywood

33"

(83.8 cm)

24" (61 cm)

1061218-2-A 4 Kohler Co.

2. Assemble the Vanity

NOTE: To protect the ﬁnished surface of the vanity, perform

assembly tasks on a ﬂat, padded work surface.

Remove the drawer from the vanity base. Refer to the

″Remove/Reinstall the Drawer″.

Place the vanity base upside down on the work surface.

Thread the feet into the four threaded mounting holes on the

vanity base, as shown.

Turn the vanity base so the feet are resting on the ﬂoor.

Insert the posts into the four threaded mounting holes of the

vanity base, then hand tighten the posts. Do not overtighten.

Place the frame onto the posts. Carefully position the posts so all

four bolts pass through the holes in the frame.

Place a washer and nut onto each bolt.

Securely tighten the nut onto each bolt with the wrench provided.

Secure the knob to the drawer with the screw. Refer to the

instructions packed with the knob.

Vanity Base

Knob

Screw

Feet

Leveler

Frame

Bolt

Washer

Nut

Post

Leveler

Kohler Co. 5 1061218-2-A

3. Install the Vanity

Position the vanity against the ﬁnished wall.

Verify the vanity is level. If necessary, turn the levelers on the

bottom of the vanity counterclockwise to raise the vanity, or

clockwise to lower it.

Mark two pilot holes an equal distance from the centerpoint of

the mounting rail.

Drill two pilot holes through mounting rail at the marked

locations.

Tighten a wood screw through each of the two drilled holes until

the vanity is ﬂush and secure against the ﬁnished wall.

Leveler

Vanity

Finished Wall

Mounting Rail

Wood Screw

1061218-2-A 6 Kohler Co.

4. Install the Lavatory

Install the faucet to the lavatory following the faucet

manufacturer’s instructions.

Properly seat the lavatory on top of the vanity. The back of the

lavatory must be ﬂush against the ﬁnished wall.

Push down on each corner of the lavatory to make sure it does

not rock from side to side on the vanity.

NOTE: If adjustment is needed, remove the lavatory and set it aside.

Use a screwdriver to turn the levelers on the vanity. Seat the

lavatory on the vanity. Repeat this procedure, if necessary.

Remove the lavatory from the vanity and set it aside.

CAUTION: Risk of product damage. Siliconized acrylic caulk must

be used to secure the lavatory to the vanity. Do not use 100%

silicone sealant, which will damage the ﬁnish of the vanity.

Apply a 1/8″(3 mm) thick bead of water-based caulk around the

top edge of the vanity.

Carefully position the lavatory on top of the vanity.

Apply a small bead of water-based caulk to the top edge where

the lavatory contacts the wall. Allow the caulk to dry before

proceeding. Refer to the manufacturer’s instructions for

recommended drying time.

Connect the drain and supplies.

Leveler

Apply sealant.

Kohler Co. 7 1061218-2-A

5. Remove/Reinstall the Drawer

To remove the drawer:

Slide the drawer out on the rails until fully extended.

Pull the right side release latch down, and push the left side

release latch toward you. Pull the drawer toward you until the

rails separate.

To reinstall the drawer:

Fully extend the rails.

Slide the drawer rail into the vanity rail.

Slide the drawer to the closed position.

Open and close the drawer several times to verify smooth

operation.

Release Latch

Rail

1061218-2-A 8 Kohler Co.

Guide d’installation

Meuble

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de performance. Nos numéros de téléphone

et notre adresse du site internet sont au verso. Merci encore d’avoir

choisi la compagnie Kohler.

Avant de commencer

ATTENTION : Risque d’endommagement du produit. Mastic à

l’acrylique à silicone doit être utilisé pour sécuriser le lavabo au

meuble. Ne pas utiliser du mastic à la silicone à 100%, celà

endommagera la ﬁnition du meuble.

Respecter tous les codes de construction locaux.

Avant l’installation, déballer le nouveau produit et l’examiner

pour en déceler tout dommage. Remettre le produit dans son

emballage de protection jusqu’à être prêt à l’installer.

S’assurer que le mur ﬁni soit droit et d’aplomb, que le sol soit

plat et perpendiculaire au mur ﬁni.

Crayon à papier Mètre ruban Mastic acrylique

siliconé

Lunettes

de protection

Perceuse Niveau à bulle

Tournevis

assortis

• Vis à bois

• Clous de cadrage

• Contreplaqué de 3/4"

Plus:

Kohler Co. Français-1 1061218-2-A

Avant de commencer (cont.)

Ce meuble est conçu pour permettre à la plupart des moulures de

base de passer derrière le meuble. Retirer tout moulage risquant

de prévenir le meuble d’être nivelé contre le mur ﬁni.

Il est recommandé que le tiroir soit retiré du meuble avant d’en

commencer l’installation. Ceci facilitera le processus d’installation.

Se référer à la section contenue dans ce guide pour une extraction

correcte.

Installer les lignes d’alimentation d’eau et de drain selon

l’information du plan de raccordement. Les mamelons des

alimentations d’eau doivent se prolonger de 3″(7,6 cm) au-delà

du matériau du mur ﬁni.

Kohler Co. se réserve le droit d’apporter toutes modiﬁcations sur

le design des produits et ceci sans préavis, tel que spéciﬁé dans le

catalogue des prix.

1061218-2-A Français-2 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler Stillness 14388T Bedienungsanleitung

Kohler

Kohler URBANITY K-99916T-LK Bedienungsanleitung

Kohler

Kohler Englefield 1141301 Bedienungsanleitung

Kohler

Kohler TRESHAM VANITY K-45980 Series Montageanleitung

Kohler

Kohler M MODULAR Bedienungsanleitung

Kohler

Kohler ALEUTIAN K-24203X Montageanleitung

Kohler

Kohler VERDERA K-26376T Bedienungsanleitung

Kohler

Kohler K-2529 Montageanleitung

Kohler

Kohler FLEXISPACE 2.0 K-23790T Bedienungsanleitung

Kohler

Kohler MAXISPACE K-96103 Bedienungsanleitung

Kohler

Kohler BANCROFT Service-Handbuch

Kohler

Kohler K-2527 Montageanleitung

Kohler

Kohler Verdera Bedienungsanleitung

Kohler

Kohler K-45775T Bedienungsanleitung

Kohler

Kohler TRESHAM K-72530T-R Bedienungsanleitung

Kohler

Kohler NEW ELOSIS Bedienungsanleitung

Kohler

Kohler K-76663T Bedienungsanleitung

Kohler

Kohler Fountainhead K-2441 Bedienungsanleitung

Kohler

Kohler Bristol K-72480T Bedienungsanleitung

Kohler

Kohler CL Series Bedienungsanleitung

Kohler

Kohler M MODULAR Bedienungsanleitung

Kohler

Kohler K-99003T-R Bedienungsanleitung

Kohler

Kohler Vanity K-2435 Montageanleitung

Kohler

Kohler K-20195 Montageanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung