CARE AND CLEANING
Face Plate
ฝาครอบ
Button
ปุ่มกด
Screw
สกรู
Wrench
Mounting Plate
ฐานยึด
F.Installationcheckout.
Test run and check the valve after installation.
Leakage at inlet connector: Check whether the seal is properly
installed, nut is tightened and whether the inlet pipe is at
proper vertical and horizontal level.
Leakage at outlet connector: Check whether the seal is twisted
and the nut is tightened.
Watercontinuesrunningatushvalve:Checkwhetherthe
rod is still too long, cut the rod if necessary. Continue press
the rod with the button to make the valve continue working.
No water or too little water running from the valve: Check
whether the rod is too short.
Contact the manufacturer for any other problems.
For best results, keep the following in mind when caring for your
product
Always test your cleaning solution on an inconspicuous area
before applying to the entiresurface.
Wipe surfaces clean and rinse completely with water immediately
after applying cleaner. Rinse and dry any overspray that
lands on nearby surfaces.
Do not allow cleaners to soak on surfaces.
Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.
The ideal cleaning technique is to rinse thoroughly and blot
dry any water from the surface after each use.
E. Fix the faceplate.
Place the face plate onto the mounting plate. Then slide the
faceplate downwards.
Tightenthescrewwithwrenchtonishtheinstallation.
NOTE: When removing the faceplate, unscrew the screw 3 mm
out and slide the faceplate upwards to remove it.
1299535-X2-B Kohler Co.
CallCenter:+(66)22046222
