Kohler VINTAGE K-7158 Bedienungsanleitung

Installation Guide

Bath Drain

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page“ Français-1”

Español, página“ Español-1”

K–7158, K-7159, K-7178

1018153-2-B

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing and building codes.

Turn off the main water supplies.

Carefully inspect the ﬁttings for damage before installing.

For replacement installations, remove the wall covering from the

drain end of the bath and remove the existing drain.

If installing a new bath, install the drain before installing the

bath.

If the tubes are cut, remove any burrs.

The overﬂow ell and drain ell tubes may need to be cut for

proper ﬁt. Dry ﬁt or measure and cut them to the proper length.

Kohler Co. reserves the right to make revisions in the design of

drains without notice, as speciﬁed in the Price Book.

Hacksaw or

Tubing Cutter

Plus:

• Trap

Pipe

Wrench Adjustable

Wrench Flat Blade

Screwdriver

Plumbers

Putty Thread

Sealant

Tape

Phillips

Screwdriver

Pliers

1018153-2-B 2 Kohler Co.

1. Install the Drain Ell

Apply a ring of plumbers putty or other sealant around the

underside of the strainer according to the manufacturer’s

instructions.

Set the gasket between the drain ell and the underside of the

bath.

Thread the strainer into the drain ell until snug. Do not fully

tighten at this time.

Drain

Ell

Apply

plumbers

putty.

Strainer

Gasket Bath

Kohler Co. 3 1018153-2-B

2. Install the Tubing

NOTE: The same steps apply to both above-the-ﬂoor and

below-the-ﬂoor installations, but the tee is aligned differently. Align

as shown in the illustration.

Slide a coupling nut, then gasket onto the overﬂow tube.

Slide a coupling nut, then gasket onto the drain ell.

Align the overﬂow tube and drain ell with the tee. Align the tee

following the illustration for your style of installation.

Insert the tubes completely into the tee. If necessary cut the

overﬂow tube to the correct length.

Align the tubes and tighten the nuts.

Apply thread sealant to the threads on the tailpiece.

Insert the tailpiece into the trap inlet, with 1” (2.5 cm) to 2” (5.1

cm) inside the trap. The tailpiece may need to be cut for proper

ﬁt.

Attach the tailpiece to the tee and tighten.

Tee

Tailpiece

Overflow Tube

Gasket

Coupling Nuts

Through-the-Floor Installations

Drain Ell

Tee

Tailpiece

Gasket

Overflow Tube

Coupling Nuts

Drain Ell

Above-the-Floor Installations

1018153-2-B 4 Kohler Co.

3. Install the Overﬂow Ell

Lubricate the two O-rings with the provided grease.

Slide the O-rings into the groove on the overﬂow ell.

Apply additional grease to the O-rings and surrounding tube.

Slide the overﬂow tube over the bottom end of the overﬂow ell.

Attach the gasket to the overﬂow ell.

Apply a ring of plumbers putty or other sealant to the front side

of the gasket according the manufacturer’s instructions.

Center the gasket with the opening in the bath wall.

Gasket

Overflow Ell

Overflow Tube

Kohler Co. 5 1018153-2-B

4. Tighten the Drain Ell

CAUTION: Risk of property damage. Do not reposition the

drain ell after the strainer is tightened. Moving the drain ell may

damage the seal created when the strainer was tightened,

increasing the risk of leaking.

Tighten the drain ell securely by inserting pliers handles into the

top of the strainer.

Turn the strainer into the drain ell.

Remove any excess sealant.

1018153-2-B 6 Kohler Co.

5. Install the Lift Rod and Stopper

Insert the lift rod assembly into the overﬂow ell.

Tighten the overﬂow hood to the overﬂow ell with the provided

screws.

If necessary, assemble the lever to the overﬂow hood with the

Phillips screw provided.

With the drain lever in the closed position, insert the stopper

assembly into the drain.

When the drain is opened, the stopper should rise approximately

3/8″(1 cm) above the strainer.

Kohler Co. 7 1018153-2-B

6. Adjustments

If adjustment is required, remove the stopper assembly from the

drain and loosen the jam nut below the stopper.

Turn the nut counterclockwise to raise the stopper or clockwise to

lower the stopper.

Tighten the nut.

If sufficient clearance cannot be obtained by adjusting the stopper,

remove the lift rod assembly and loosen the locknut.

Rotate the turnbuckle counterclockwise to lengthen the lift rod or

clockwise to shorten the lift rod.

Tighten the locknut, reinstall the lift rod assembly and check the

clearance.

7. Complete the Installation

Make sure all connections are tight.

Open the drain.

Turn on the main water supply and check for leaks.

Jam

Nut

Lift Toggle

Stopper

Spring

Locknut

Turnbuckle

Lift Rod

1018153-2-B 8 Kohler Co.

Guide d’installation

Drain de baignoire

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de fonctionnement. Nos numéros de

téléphone et notre adresse du site internet sont au verso. Merci encore

d’avoir choisi la compagnie Kohler.

Avant de commencer

Respecter tous les codes de plomberie et de bâtiment locaux.

Fermer les alimentations d’eau principales.

Examiner soigneusement les raccords pour en déceler tout

dommage avant l’installation.

Pour des installations de remplacement, retirer le revêtement du

mur autour de l’extrémité du drain de la baignoire puis retirer le

drain existant.

Scie à métaux

ou coupe tubes

Plus:

• Siphon

Clé à tuyau Clé à molette Tournevis à

lame plate

Mastic de

plombier Ruban

d'étanchéité

pour filetage

Tournevis

cruciforme

Pinces

Kohler Co. Français-1 1018153-2-B

Avant de commencer (cont.)

Si une nouvelle baignoire est installée, installer le drain avant

d’installer la baignoire.

Si les tubes sont coupés, retirer toute ébarbure.

Le coude de trop plein et les tubes de coude du drain peuvent

nécessiter d’être coupés pour un ajustage correct. Ajuster à sec ou

mesurer et les couper à la bonne longueur.

Kohler Co. se réserve le droit d’apporter toutes modiﬁcations au

design des drains et ceci sans préavis, comme spéciﬁé dans le

catalogue des prix.

1018153-2-B Français-2 Kohler Co.

Andere Handbücher für VINTAGE K-7158

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Purist 14434 Bedienungsanleitung

Kohler

Kohler K-97060-4-CP Bedienungsanleitung

Kohler

Kohler K-13108 Montageanleitung

Kohler

Kohler K-8549 Bedienungsanleitung

Kohler

Kohler K-170 Montageanleitung

Kohler

Kohler K-19797T Bedienungsanleitung

Kohler

Kohler K-1110-G Kurzanleitung

Kohler

Kohler 8030A Bedienungsanleitung

Kohler

Kohler Stillness K-14450 Bedienungsanleitung

Kohler

Kohler K-8855 Bedienungsanleitung

Kohler

Kohler K-193-4-CP Bedienungsanleitung

Kohler

Kohler K-14402 Montageanleitung

Kohler

Kohler Strayt Bedienungsanleitung

Kohler

Kohler Brenham K-1999-8-0 Bedienungsanleitung

Kohler

Kohler Stillness 944-4 Bedienungsanleitung

Kohler

Kohler MARSTON K-2766 Bedienungsanleitung

Kohler

Kohler K-T9493 Bedienungsanleitung

Kohler

Kohler ESCALE Bedienungsanleitung

Kohler

Kohler K-14675 Montageanleitung

Kohler

Kohler 22327T-7 Bedienungsanleitung

Kohler

Kohler K-T8230 Bedienungsanleitung

Kohler

Kohler rada Exact-3 B Bedienungsanleitung

Kohler

Kohler K-18494 Montageanleitung

Kohler

Kohler SKYLINE K-705879T-FM-SHP Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung