Kohler STERLING 402024 Bedienungsanleitung

Installation Guide

Dual-Flush

Close-Coupled Toilet

Français, page “Français-1”

Español, página“ Español-1”

402024 402025

402027 402028

1035429-2-C

Thank You For Choosing Sterling

We appreciate your commitment to Sterling value. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers are listed on the back cover.

Thanks again for choosing Sterling.

Tools and Materials

Before You Begin

CAUTION: Risk of personal injury or product damage. Handle

with care. Vitreous china can break or chip if the product is

handled carelessly.

Observe all local plumbing and building codes.

Carefully inspect the new toilet for damage.

Illustrations shown may not represent your speciﬁc product.

10" Adjustable

Wrench Supply

Shut-Off

Valve

Tape

Measure Pipe Wrench

Tubing Cutter Safety

Glasses

Sponge

Level

Plus:

Wax Seal

• 5/16" T-Bolts w/ Nuts and Washers

• Putty Knife

• Metal File

• 1/2" Nut Driver/Socket

• Hacksaw

• Screwdriver

1035429-2-C 2 Sterling

1. Remove the Existing Toilet

Turn off the water supply.

Flush the toilet, then sponge out all remaining water from the

tank.

Disconnect the supply shut-off valve (if present), and remove the

old tank and bowl.

Remove the old wax seal from the ﬂoor with a putty knife.

Replace the old T-bolts with the new 5/16″diameter T-bolts.

CAUTION: Risk of hazardous gases. If the new toilet is not

installed immediately, temporarily stuff a rag in the closet ﬂange.

T-Bolts

Closet Flange

Scrape off the

old wax seal

Sterling 3 1035429-2-C

2. Install the Bowl

Install a supply shut-off valve.

Record the model number in the Homeowners Guide.

Lay the toilet down onto a padded surface.

From the bottom of the toilet, ﬁrmly press a new wax seal around

the toilet outlet.

Remove the temporary rag (if used) from the toilet ﬂange hole.

Align and lower the toilet over the ﬂange and T-bolts.

CAUTION: Risk of external leakage. Do not lift or rock the

bowl after placement. If you break the watertight seal, you must

install a new wax seal.

Apply your full body weight around the toilet to set the seal.

Place the plastic bolt cap bases over the T-bolts in the ″up″

position as marked.

Place the metal washers and nuts on the plastic bolt cap bases

and T-bolts.

CAUTION: Risk of product damage. Overtightening may cause

breakage or chipping of the vitreous china.

Carefully tighten the nuts.

CAUTION: Risk of product damage. Protect the vitreous china

from exposure to the saw blade when cutting off excess T-bolt

length.

If the T-bolts extend more than 1/4″(6 mm) over the top of the

nuts, cut off the excess.

Nut

Washer

Bolt Cap Base

Bolt Cap

T-Bolt

Wax Seal

Closet Flange

T-Bolt

1035429-2-C 4 Sterling

Install the Bowl (cont.)

Attach the bolt caps.

Sterling 5 1035429-2-C

3. Install the Tank

Carefully turn the tank upside down onto a protected surface. Fit

the rubber gasket over the ﬂush valve nut so the tapered side of

the gasket faces out.

Carefully position the tank on the bowl by centering the gasket

on the bowl inlet. Line up the tank and bowl bolt holes.

CAUTION: Risk of product damage. Overtightening may cause

breakage or chipping of the vitreous china.

Install the bolt gaskets onto the tank bolts, and slide the tank

bolts down through the holes in the tank and bowl.

Assemble the washers and nuts to the tank bolts. Securely tighten

the nuts so the tank is level.

Be sure the nuts are tight enough to achieve a watertight seal.

Tank

Gasket

Washer

Brass Nut

Tank Tank

Tank Bolt Gasket

Viewing The

Assembly From

Under The Tank

Bowl

1035429-2-C 6 Sterling

4. Final Connections

Connect the supply shut-off valve to the toilet supply shank.

Open the supply shut-off valve slowly to check for leaks. If the

connections have been properly assembled, a slight tightening of

the nuts should stop leakage.

Install the toilet seat according to the packed instructions.

Carefully set the cover on the tank.

Flush the toilet several times using ﬁrst one push button and then

the other, and check all connections for leaks. Verify proper

operation.

Periodically check for leaks for several days following the

installation.

Adjustments

Adjust the water level in the tank by squeezing and sliding the

C-clip on the ﬂoat rod.

•To raise the water level, slide the C-clip up.

•To lower the water level, slide the C-clip down.

Ferrule

Supply Shank Tubing

Compression

Washer

Compression

Nut

Supply

Shut-Off

Valve

Supply Shut-OffValve

Connection

Coupling

Nut

Fill Valve

Nut

Seal

Washer

C-Clip

Waterline

Adjusting The Water Level

Sterling 7 1035429-2-C

5. Install the Push Buttons

Remove the tape covering the push button on the tank cover, and

remove the protective pad. Discard the pad.

Carefully set the cover in position on the tank.

Press the large push button in the center of the cover, and use

your ﬁngers to carefully pull out and remove the small push

button. Then pull out and remove the large push button.

Press the large push button onto the larger diameter rod, and the

small push button onto the smaller rod.

Insert the rods into the side holes in the push button housing in

the center of the cover. Press down on the push buttons until they

click into place in the housing.

Flush the toilet several times and check all connections for leaks.

Periodically check for leaks for several days following installation.

1035429-2-C 8 Sterling

Guide d’installation

W.C. double chasse à couplage direct

Outils et Matériaux

Merci d’avoir choisi Sterling

Nous apprécions votre engagement envers la qualité Sterling. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter pas à nous contacter en cas de

problème d’installation ou de fonctionnement. Nos numéros de

téléphone sont indiqués au verso. Merci encore d’avoir choisi Sterling.

Avant de commencer

ATTENTION : Risque de blessure corporelle ou

d’endommagement du produit. Manipuler avec précaution. La

porcelaine vitriﬁée peut se briser ou se fendre si le produit est

manipulé avec négligence.

Respecter tous les codes de plomberie et de bâtiment locaux.

Examiner soigneusement le nouveau W.C. pour en déceler tout

dommage.

Les illustrations peuvent être différentes de votre produit actuel.

10" Clé à

molette Valve d'arrêt

d'alimentation Mètre

ruban

Coupe tuyau

Lunettes de

protection

Éponge

Niveau à bulle

Et:

Joint en cire • Couteau à mastic

• Lime en fer

• Clé à écrou/douille 1/2"

• Scie à métaux

• Tournevis

Clé à

griffes

• Boulons en T de 5/16" avec

écrous et rondelles

Sterling Français-1 1035429-2-C

1. Retirer le W.C. éxistant

Fermer l’alimentation d’eau.

Activer la chasse d’eau du W.C. et éponger le restant d’eau du

réservoir.

Déconnecter la valve d’arrêt (si présent) et retirer le vieux

réservoir et sa cuvette.

Retirer du sol l’anneau en cire existant avec un couteau à mastic.

Remplacer les vieux écrous en T avec de nouveaux de Ø 5/16″.

ATTENTION : Risque d’émanation de gaz nocifs. Si

l’installation du nouveau W.C. n’est pas immédiate, recouvrir

temporairement la bride du sol avec un chiffon.

Boulons en T

Bride de sol

Retirer le vieux joint en cire

1035429-2-C Français-2 Sterling

Andere Handbücher für STERLING 402024

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Toilette Handbücher

Kohler

Kohler STRUKTURA K-5888T Bedienungsanleitung

Kohler

Kohler C3-150 Montageanleitung

Kohler

Kohler BARDON VITREOUS CHINA TOUCHLESS K-4915T-Y Bedienungsanleitung

Kohler

Kohler PANACHE K-9154T Bedienungsanleitung

Kohler

Kohler VEIL K-1666K-SL-0 Bedienungsanleitung

Kohler

Kohler WELLWORTH K-5778T Bedienungsanleitung

Kohler

Kohler K-20168T-SL-CG1 Bedienungsanleitung

Kohler

Kohler K-31636-0 Bedienungsanleitung

Kohler

Kohler WELLWORTH LITE K-4229 Bedienungsanleitung

Kohler

Kohler K-3423 Bedienungsanleitung

Kohler

Kohler Karess S-TRAP K-5331T-S Datenblatt

Kohler

Kohler K-22106T-S2 Bedienungsanleitung

Kohler

Kohler K-12698X Montageanleitung

Kohler

Kohler Persuade Circ K-3753 Benutzerhandbuch

Kohler

Kohler OVE K-24719T-S2 Bedienungsanleitung

Kohler

Kohler Veil Comfort Height Montageanleitung

Kohler

Kohler K-4744 Montageanleitung

Kohler

Kohler K-3379 Bedienungsanleitung

Kohler

Kohler K-11452 Montageanleitung

Kohler

Kohler EIR K-77798T-0 Bedienungsanleitung

Kohler

Kohler K-3322 Bedienungsanleitung

Kohler

Kohler User Manual K-23188T-NS Bedienungsanleitung

Kohler

Kohler SAN MARTINE K-5503T-C Bedienungsanleitung

Kohler

Kohler K-3466 Montageanleitung

Beliebte Toilette Handbücher anderer Marken

Toto

Toto Washlet TCF4911 Series Bedienungsanleitung

Grohe

Grohe Sensia ARENA Bedienungsanleitung

Geberit

Geberit AQUACLEAN MERA CLASSIC Bedienungsanleitung

Better Bathrooms

Better Bathrooms BUN/BeBa 27555/78725 Bedienungsanleitung

American Standard

American Standard CONCEPT Cube TF-2704 Bedienungsanleitung

BIOLAN

BIOLAN ECO Stücklistenhandbuch

Thetford

Thetford C260 Series Bedienungsanleitung

KELISS

KELISS T162A Series Bedienungsanleitung

BIOLAN

BIOLAN GARDEN TOILET Stücklistenhandbuch

washloo

washloo Prestige Bedienungsanleitung

JABSCO

JABSCO 37010 Series Bedienungsanleitung

Olympia

Olympia EPOQUE 69209 Bedienungsanleitung

DENCK

DENCK PURE-D Bedienungsanleitung

Silent Venus

Silent Venus SVP600 Wartungs- und Serviceanleitung

InBe

InBe IB/04.06050 Bedienungsanleitung

Swiss Madison

Swiss Madison Carré SM-1T264 Bedienungsanleitung

agape

agape PEAR 2 Bedienungsanleitung

Roca

Roca DAMA SENSO COMPACT Bedienungsanleitung